Tài liệu Installing the Fiber Spool Box ppt

OptiX OSN 3500 Installation Manual Contents Contents 8 Installing the Fiber Spool Box 1 8.1 Installation Position of the Fiber Spool Box 1 8.2 Installing the Plate and the Box 3 Issue 05 (2006-11-20) Huawei Technologies Proprietary i Figures Appearance of the ber spool box 2 Top view of the plate 2 Securing the box 3 T2-0416xx- 20050330-C- 1.20 Huawei Technologies Proprietary iii OptiX OSN 3500 IM 8 Installing the Fiber Spool Box About This Chapter This section describes how to install the fiber spool box. The following table lists the contents of this chapter. Section Description 8.1Installation Position of the Fiber Spool Box Describes the appearance of the fiber spool box. 8.2Installing the Plate and the Box Describes the procedure of installing the plate and the box. 8.1 Installation Position of the Fiber Spool Box The fiber spool box is used to spool fiber jumpers and hold the optical attenuators. It can accommodate 4 x 10 m fiber jumpers and hold eight fixed or tunable attenuators. If the cabinet holds two OSN 3500 subracks, install the fiber spool box at the third hole from the bottom of the cabinet, more than 50 mm away from the subrack. 1 8 Installing the Fiber Spool Box OptiX OSN 3500 Installation Manual If the cabinet holds only one OSN 3500 subrack, install the fiber spool box above the orderwire fixing frame. Figure 1.1 and Figure 1.2 show the fiber spool box. Mounting ear Fiber hole Plate Box Figure 1.1 Appearance of the fiber spool box Captive screw fibre holder fibre spool attenuator holder Figure 1.2 Top view of the plate 2 Huawei Technologies Proprietary Issue 05 (2006-11-20) OptiX OSN 3500 Installation Manual 8 Installing the Fiber Spool Box 8.2 Installing the Plate and the Box Purpose This procedure guides you to install the fiber spool box into the cabinet. Tools /Materials Cross screwdriver Optical attenuator Prerequisites The cabinet and the subrack are installed. Required/As needed Required Step 1 Secure the box in cabinet with two panel screws. See Figure 1.1. Figure 1.1 Securing the box Step 2 Fix the optical attenuators in the plate. Step 3 Spool the fibers in the plate. See Chapter 10 "Installing and Routing the Fiber Jumpers". Step 4 Fix the plate. End Issue 05 (2006-11-20) Huawei Technologies Proprietary 3 . of the Fiber Spool Box Describes the appearance of the fiber spool box. 8. 2Installing the Plate and the Box Describes the procedure of installing the. Manual 8 Installing the Fiber Spool Box 8.2 Installing the Plate and the Box Purpose This procedure guides you to install the fiber spool box into the cabinet. Tools