DECNET IV
Key Commands Shows and Debugs
Decnet routing 1.2 <- network, node.
Declare node type:
Decnet node-type routing-iv (level 1,intra area rtr)
Decnet node-type area (level two, equivalent to ABR)
!
interface ethernet 0
decnet cost 5 <- 5 for LAN, 15 for WAN
On ethernet, must elect a DR:
Interface ethernet 0
Decnet router-priority 75
Higher is better, default is 64
Show decnet
Show decnet interface
Show decnet route
Show decnet traffic
Show decnet neighbors
Additional Commands
Permit all in decnet access-lists is 63.1023
Static decnet routing
Decnet route 1.4 1.10
Decnet route default 1.100
To forward static routes:
Decnet propagate static
Dialer-list 1 protocol decnet permit
Spot The Issue Notes
• Decnet addressing addresses the entire
router. No different interface addresses
• Decnet changes the MAC address of ethernet
interfaces. Beware of this when mixing with
IPX. Make sure you specify an IPX node number
with "ipx routing A.B.C" so not to fall in
this trap. DecNet can screw up ipx frame-map
• Decnet sends hellos every 15 seconds. On DDR
links, this will keep the line up. Use a
default static route.
• Split-horizon can only be disabled on
physical interfaces! Cannot be disabled on
sub-interfaces
. ethernet 0
Decnet router-priority 75
Higher is better, default is 64
Show decnet
Show decnet interface
Show decnet route
Show decnet traffic
Show decnet. DECNET IV
Key Commands Shows and Debugs
Decnet routing 1.2 <- network, node.
Declare node type:
Decnet node-type routing -iv (level