TECHNOLOGYCOMPARISON-HIGHBAND VS 110 TYPE
FEATURE KRONE110 EXPLANATION
HIGHBAND TYPE
Bandwidth NEXT Loss @ NEXT Loss @ Higher headroom capacity allows you to
(patched) 100 MHz = >63dB 100 MHz = <49dB install a network that is capable of
handling emerging technologies.
Contact Silver Tin Silver has an electrical conductance that
plating is 6.9 times greater than tin.
IDC contact 45º 90º By placing contacts at 45º angles across the
positioning axis of the wire, far less stress is placed
on the wire at point of termination.
Centre port Yes No HIGHBAND allows you test/monitor access
access to a hardwired circuit.
Jumper & Yes No The HIGHBAND module allows you to
patch jumper and patch on the one module. 110
systems allows one or the other, NOT BOTH.
Patch-By- Yes No Useful for temporary moves and changes.
Exception This feature allows you to leave jumpers in
place and patch to the new temporary
location.
Number of 2 1 HIGHBAND guarantees you two
conductors conductor terminations per slot.
per slot
Insertion Low High The high insertion force needed
force to terminate the 110 type blocks
can cause stress on the wire.
Stranded Yes No Contact angle and reduced wire stress
conductor allows reliable stranded conductor
termination termination.
page fourteen
page fifteen
FEATURE KRONE RJ Cross EXPLANATION
HIGHBAND8 Connect
Low cost Yes No RJ cross connection requires 19” rack
mounting system mounting. Depending on the size of the
installation this can be quite expensive.
Jumper & patch Yes No RJ allows for patch only.
Patch-By-Exception Yes No The flexibility of the HIGHBAND module
allows either jumpering or patching.
Test access point Yes No The HIGHBAND centre port allows for test
access.
Single pair Yes No With RJ when one wire is connected all are
administration connected and pairs cannot be managed.
HIGHBAND allows for single, double and
four pair management.
Work access Yes No With the HIGHBAND module all
from front connections are made from the front which
of module makes cable termination much easier.
Extremely high Yes No HIGHBAND has far superior transmission
transmission NEXT Loss @ NEXT Loss @ performance. Eliminates performance
performance 100MHz = >63dB 100MHz typically reducing compromises inherent in the
= 45dB modular connector design
Easy to configure Yes No RJ does not allow splitting or paralleling
to star ring or of pairs
bus topology
TECHNOLOGY COMPARISON-HIGHBAND VS RJ
. TECHNOLOGY COMPARISON - HIGHBAND VS 110 TYPE
FEATURE KRONE 110 EXPLANATION
HIGHBAND TYPE
Bandwidth NEXT Loss @ NEXT. splitting or paralleling
to star ring or of pairs
bus topology
TECHNOLOGY COMPARISON - HIGHBAND VS RJ