APPLETALK Key Commands Shows and Debugs Appletalk routing ! Appletalk routing eigrp 10 Appletalk route-redistribution <- don't forget!!! ! interface ethernet 0 appletalk cable-range 10-20 10.1 <- specify node! Appletalk zone Admin Appletalk zone Marketing Appletalk protocol eigrp No appletalk protocol rtmp ! On NBMA HUBS!!! Appletalk local-routing Interface serial 0 no appletalk eigrp-spplithorizon no appletalk rtmp-splithorizon Show apple route Show apple interface s 0 <- most important command Debug apple routing Debug apple zip Debug apple arp Show appletalk interface Show appletalk neighbor Additional Commands Static routes: Apple static cable-range 10-20 to 50.1 zone MyZone Apple static network 50 to 50.1 zone MyZone (Phse I) AURP Tunnel: Interface tunnel 0 <- no cable-range or zone on tun No ip address Appletalk protocol aurp Tunnel mode aurp Tunnel source 10.1.1.1 Tunnel destination 10.1.1.2 GRE tunnel. Do nor remove the "appletalk iptalk" Interface tunnel 0 that is automaticaly Tunnel source 10.1.1.1 placed on the int. Tunnel destintion 10.1.1.2 Tunnel mode gre ip Appletalk cable-range 20-30 Appletalk zone MyZone Appletalk protocol eigrp <- can run either No appletalk protocol rtmp Dialer-list 1 protocol appletalk permit ! frame-relay map appletalk 10.2 105 BROADCAST Spot The Issue Notes Cable ranges go from 1-253. 0, 254 and 255 reserv Ping appletalk codes: R: unrouteable E: encapsulation failed .: timeout !: Echo received When in doubt, reload. On NBMA hubs: appletalk local routing • Appletalk EIGRP requires UNIQUE EIGRP PROCESS NUMBERS!! • In "show apple zone" if a zone shows up with a ":20" this represents a <space> entered at the end of the zone name. Zone names must match between routers! So, "Marketing" and "Marketing:20" wouldn't agree. • When you have a GRE tunnel established, try to tunnel multiple protocols on it rather than running parallel tunnels • Doing a "no appletalk routing" then "appletalk routing" re-initializes appletalk, BUT, it takes out and replaces all basic commands (like RTMP) but not commands related to eigrp or aurp. • AURP uses UDP port 387. Make sure it's NOT filtered through an access-list!! • AURP needs to be full mesh! Won’t router . interface ethernet 0 appletalk cable-range 10-20 10.1 <- specify node! Appletalk zone Admin Appletalk zone Marketing Appletalk protocol eigrp No appletalk protocol. ip Appletalk cable-range 20-30 Appletalk zone MyZone Appletalk protocol eigrp <- can run either No appletalk protocol rtmp Dialer-list 1 protocol appletalk