AL FORM dismantling tool manual EN

DISMANTLING TOOLS MANUALS Kumkang Kind’s AL-formworks system 11/3/19 Part 1: PIN & WEDGE DISMANTLING PROCESS 11/3/19 page Strike the Wedge directly 11/3/19 Page Strike the Wedge With the assembling tool 11/3/19 Page Part 2: WALL PANEL DISMANTLING PROCESS Notes: to protect the extended wall panel we must dismantle the panel from the top 11/3/19 page Dismantling tool 11/3/19 Page Supporting point Up Notes: the extended form area is very weak and easy to be broken under too much strength So this area should be gently treated 11/3/19 Page Up Up 11/3/19 Page Optional & not reccommended! Only used when the previous work cannot help If neccesary, it slowly & gently 11/3/19 Page Down Supporting point Supporting point BEFORE 11/3/19 AFTER Page 10 11/3/19 Page 11 11/3/19 Page 12 Pull out 11/3/19 Page 13 Swing to protect the panel footing 11/3/19 Page 14 Part 3: SLAB PANEL DISMANTLING PROCESS 11/3/19 page 15 After removing the pin & long pin dismantle the Beam Down 11/3/19 Page 16 Beam dismantled 11/3/19 Page 17 Dismantle the slab panel Dismantling tool 11/3/19 Page 18 Dismantle the slab panel 11/3/19 Page 19 Thank you for your attention! 11/3/19 page 20 ... the extended wall panel we must dismantle the panel from the top 11/3/19 page Dismantling tool 11/3/19 Page Supporting point Up Notes: the extended form area is very weak and easy to be broken under... much strength So this area should be gently treated 11/3/19 Page Up Up 11/3/19 Page Optional & not reccommended! Only used when the previous work cannot help If neccesary, it slowly & gently 11/3/19...Part 1: PIN & WEDGE DISMANTLING PROCESS 11/3/19 page Strike the Wedge directly 11/3/19 Page Strike the Wedge With the assembling tool 11/3/19 Page Part 2: WALL PANEL DISMANTLING PROCESS Notes: