Phần 1 (Tài liệu bằng tiếng anh) gồm: - Kết cấu thân xe - Kết cấu phần điện - CHASSIS - Kích thước xe - Động cơ xe
BODY ELECTRICAL – METER02KBE21YTaiwanese Models with 2GR-FE Engine02KBE22YG.C.C. Countries Models with 2AZ-FE EngineMulti-information DisplayLCD (Liquid Crystal Display) Type Multi-information DisplayService TipIf the LEDs malfunction, the entire combination meter assembly must be replaced. Refer to theCamry Repair Manual.BE-48METERJCOMBINATION METER1. GeneralD An optitron display type combination meter is used as standard on some models other than 2AZ-FE enginemodels for Australia and G.C.C. Countries.D On some models, a multi-information display is provided on the speedometer. The settings vary dependingon the grades.D An analog type combination meter is used as standard on 2AZ-FE engine models for Australia and G.C.C.countries. In addition, an LCD (Liquid Crystal Display) type multi-information display has been providedbelow the tachometer on some models. The settings vary depending on the grades.D A meter ECU and buzzer are enclosed in the combination meter. This ECU maintains communication withother ECUs through the CAN (Controller Area Network).D Illumination control, which turns on the combination meter illumination at different time intervals whenthe power source* is switched to IG-ON, has been provided.D A step-motor type movement is used to actuate the indicators of the speedometer, the fuel gauge, theengine coolant temperature gauge and the tachometer.D A speed warning system has been provided as standard on models for G.C.C. Countries. When the vehiclespeed exceeds 120 km/h, the system warns the driver by sounding the buzzer and flashing the warning light.*: The power source condition can be changed by operating the engine switch on models with the smart keysystem, and the ignition switch on models without the smart key system.*: The power source condition can be changed by operating the engine switch on models with the smart entryand start system, and the ignition switch on models without the smart entry and start system BEBODY ELECTRICAL – METER02KBE23YSteering Pad SwitchDISP SwitchSkid Control ECUSpeed Sensor SignalEngine ECUWarning Light ControlFlasher RelayFuel Sender GaugeAlternator L TerminalWasher FluidLevel Switch*3Oil Pressure SwitchBrake Fluid LevelWarning SwitchHeadlight Beam Level ECU*2D Warning Light ControlMeter ECUVehicle Speed SignalD Engine ECUD Main Body ECU*1D Audio Head UnitD Wiper ECU*2Rheostat SignalMain Body ECUClock DisplaySeat Belt Reminder Light (Front Passenger)D AFS ECU*2D Seat Belt Control ECU*2D Distance Control ECU*2CAN(CAN No.2 Bus)CAN (CAN No.1 Bus)D CAN Gateway ECU*4D Engine ECUD A/C ECUD Skid Control ECUD Airbag Sensor AssemblyD Main Body ECUCAN(MS Bus)D Certification ECU*2D Clearance Sonar ECU*2BE-492. System Diagram*1: Only for models with the smart entry and start system.*2: Setting vary depending on the destination and engine type. For details, see the equipment list in ModelOutline.*3: Only on models for Taiwan, Thailand, Philippines, Vietnam, Malaysia and Indonesia*4: Only for models with the intelligent AFS, the pre-crash safety system, and the radar type cruise controlsystem BODY ELECTRICAL– METERBE-50" Input and output communication signals of the meter ECU AProtocol ECU Input Signal to meter ECUOutput Signal from meterECUEngine ECUDEngine speedDEngine coolant temperatureDFuel injection volumeDStarter conditionDShift positionDS mode indicator*1DCurrent range positionDBuzzer sounding requestDIndicator light controlDDiagnosis (Cruise)DEngine type information—A/C ECU Outside temperature Vehicle speedCAN(CAN No.1Bus)Airbag SensorAssemblyDWarning light controlDSeat belt remainder control (D)DDiagnosisVehicle speedSkid ControlECUDWarning light controlDIndicator light controlDVehicle SpeedDDiagnosis—Main Body ECUDLighting statusDParking brake switchDCourtesy switchDBuzzer sounding requestDAuto dimmer signalDUnlock Warning SwitchDWarning display controlDDiagnosisVehicle SpeedAFS ECU*2DIndicator light control —CANSeat BeltControl ECU*2DWarning display controlDDiagnosis—(CAN No.2Bus)DistanceControl ECU*2DWarning display controlDBuzzer sounding requestDCruise control status indicationDDiagnosis—CANCertificationECU*2DWarning display controlDBuzzer sounding request—(MS Bus)ClearanceSonar ECU*2DWarning display control Vehicle speed*1:Only on models with multi-mode automatic transmission*2:Setting vary depending on the destination and engine type. For details, see the equipment list in ModelOutline (see page MO-42). BEBODY ELECTRICAL – METER02KBE24YEngine Coolant Temp.Gauge NeedleFuel Gauge NeedleTachometer NeedleSpeedometer NeedleMulti-information Display02KBE25Y02KBE26Y1) The needles of the speedometer, tachometer, fuel gauge and engine coolant temperature gauge areilluminated and “Camry” appears on the multi-information display.2) After the multi-information display illuminates, the meter illumination gradually fades in.3) All illuminations other than the multi-information display go off, and “Camry” appears on themulti-information display. Then the “Camry” disappears and the multi-information display turns off.BE-513. Illumination ControlD When the power source is switched to IG-ON, the illumination control operates as follows (1, 2). However,all illuminations turn off while the engine is cranked.D When the power source is switched to OFF, the illumination control is as follows (3). BODY ELECTRICAL– METERBE-524.Multi-information DisplayGeneralDThe multi-information display has three modes:ModeOutlineCruise Information(See page BE-54)DFive types of information can be displayed.DThe display can be switched by using the DISP switch.DOptitron display type combination meter: outside temperature,driving range, average fuel consumption since refueling, time drivensince engine start, and average speed since engine start.DAnalog type combination meter: outside temperature, driving range,average fuel consumption since refueling, distance driven sinceengine start, and average speed since engine start.Warning*(See page BE-55)Interrupts the multi-information display immediately when a warningoccurs.Diagnosis*(See page CH-169)DTC (Diagnostic Trouble Code) for the brake control system (TRC andVSC) can be displayed.*: Only for the optitron display type combination meter BEBODY ELECTRICAL – METER02KBE27TEDisplay OFFSmart Entry and Start System*1Warning: OccursInterrupts display even duringwarning mode.WHEN STARTING THE ENGINE,DEPRESS THE BRAKE PEDAL*1Door Unlock Mode*1D Issues warning if entry unlock mode switched.Warning: RepairedMOONROOF OPEN*2Power Source: IG ON.Opening(3 Second Display)Contents*3Immediately interrupts display when new warning occurs.OutsideTemperatureWarning Display Mode*4,5Odo/TripDriving RangeAverage Fuel Consumption Since RefuelingImmediately interrupts display when this mode is selected.Odo/TripTime Driven Since Engine StartRader Cruise Display Mode*6,7Distance Driven Since Engine StartWarning: OccursPower Source: OFFSmart Entry and Start System*1Warning: RepairedWHEN STARTING THE ENGINE,DEPRESS THE BRAKE PEDAL*1Farewell(3 Second Display)MOONROOF OPEN*2Display OFFBE-53Flow of The Multi-information Display IndicationThe multi-information display mode can be changed as shown in the flow chart below:*1: Only for models with the smart entry and start system*2: Only for models with the sliding roof system*3: The first screen to be displayed is the same as that displayed when the power source was last turned OFF.*4: If multiple new warnings occur, they are automatically displayed at 2 second intervals.*5: If the display is changed from warning display mode to another mode, it automatically returns towarning display mode after 6 seconds.*5: Immediately interrupts the display if data pertaining to the radar cruise display mode is received.*7: Only for models with the dynamic radar type cruise control system BODY ELECTRICAL – METER02KBE28TE(1)(3)(4)*1Odo/TripmeterOdo/Tripmeter(5)(2)02KBE129Y(1) (3)(5) (4)*2(2)BE-54Cruise Information ModeThe cruise information is displayed in the following order, changing each time the DISP switch is pressed.However, pressing the DISP switch for approximately 1 second or more changes the display to the outsidetemperature indication." Models with the Optitron Display Type Combination Meter A" Models with the Analog Type Combination Meter AInformation Outline(1)Displays the outside temperature in accordance with the outside temperature sensor signalfrom the A/C ECU.(2)D Displays the range, calculated by the combination meter which continuously monitors andstores fuel consumption data and the residual fuel volume when IG-ON has been selected.D Updated every 1 seconds.(3)D Displays the value calculated by the combination meter based on the distance drivensince refueling and the fuel consumption volume, which is calculated from the fuelinjection signals from the No.1 injector. (For 2GR-FE engine models for Australia andG.C.C. Countries, the value is displayed in liters per 100 km.)D The combination meter determines the vehicle has been refueled through the signalfrom the fuel sender gauge.D Updated every 10 seconds.(4)*1D Displays the length of time has elapsed since engine start.D Updated every 60 seconds.(4)*2D Displays the value calculated by the combination meter based on the distance drivensince engine start.D Updated every 1 km (0.6 miles).(5)D Displays the average speed calculated by the combination meter based on the length oftime and the distance driven since engine start.D Updated every 10 seconds. BEBODY ELECTRICAL – METER025BE19P: FlashBuzzer: Sound025BE20P: FlashBuzzer: Sound025BE21P 025BE22P025BE23P025BE24P025BE25P 025BE26P02KBE112TE02HBE84TE025BE27P: Flash: FlashBuzzer: Sound: IlluminateBuzzer: Sound: FlashBuzzer: Sound: FlashBuzzer: Sound: Flash*Buzzer: Sound*: IlluminateBuzzer: Sound*: Flash*: IlluminateBuzzer: Sound*: Flash*BE-55Warning Mode1) GeneralD When a warning is necessary, the warning display interrupts the multi-information display.D The master warning light may illuminate or flash and the buzzer may sound depending on the itemin the multi-information display.WarningDetail Warning DetailThe key is not inside thevehicle.(On models with smart entry and start system)The driver door is openedwith the shift lever in anyposition other than P.(On models with smartentry and start system)Steering lock has not been released.(On models with smart entry and start system)Steering lock ismalfunctioning.(On models with smartentry and start system)The power source is switched from OFF to ACCtwice with the brake pedal released.(On models with smart entry and start system)TRC and VSC aremalfunctioning.(On models with BrakeControl System [ABS withEBD, Brake Assist, TRCand VSC])Key battery is low.(On models with smart entry and start system)Parking brake is stillengaged with the vehiclehaving reached a speed of 5 km/h (3 mph).Any door is open.Engine hood is open.(Except G.C.C. CountriesModels)*: The vehicle having reached a speed of 5 km/h (3 mph).yp*: The vehicle having reached a speed of 5 km/h (3 mph).Luggage compartment dooris open.*: The vehicle having reached a speed of 5 km/h (3 mph).(Continued) BODY ELECTRICAL – METER025BE32P025BE31P025BE33P02KBE114TE 02KBE115TE02KBE116TE02KBE117TE02KBE118TE 02KBE119TE: FlashBuzzer: Sound025BE30P: FlashBuzzer: Sound: IlluminateBuzzer: SoundDisplayed for 8 sec.: FlashBuzzer: Sound:IlluminateBuzzer: SoundBuzzer: Sound: IlluminateBuzzer: Sound: IlluminateBuzzer: Sound: FlashBuzzer: Sound: FlashBuzzer: Sound:IlluminateBE-56Warning Detail Warning DetailEngine oil pressure is low.Engine coolant temperatureis high.Washer fluid level is low.The sliding roof is open andthe driver door is open.(On models with sliding roof system)Pre-crush safety system is malfunctioning.(On some models for Taiwan and Thailand)Pre-crush safety system is not currently functional.(On some models for Taiwan and Thailand)Toyota parking assist is malfunctioning.Toyota parking assist is dirty or covered with ice.Dynamic radar cruise control system is malfunctioning.(On some models for Taiwan and Thailand)Dynamic radar type cruise control system is unable to judge vehicle-to-vehicle distance.(On some models for Taiwan and Thailand) BEBODY ELECTRICAL– METERBE-575.BuzzerGeneralThe table below shows the warning and reminder functions of the buzzer.FunctionItemWarningDMulti-information Display Warning Mode Indication (See page BE-55)DShift Down Warning (See page CH-59, 102)ReminderD Key Reminder (See page BE-166)DSeat Belt Reminder (See page BE-201) . ELECTRICAL – METER025BE32P025BE31P025BE33P02KBE 114 TE 02KBE 115 TE02KBE 116 TE02KBE 117 TE02KBE 118 TE 02KBE 119 TE: FlashBuzzer: Sound025BE30P: FlashBuzzer: Sound: IlluminateBuzzer:. system BODY ELECTRICAL – METER02KBE28TE (1) (3) (4)*1Odo/TripmeterOdo/Tripmeter(5)(2)02KBE129Y (1) (3) (5) (4)*2(2)BE-54Cruise Information ModeThe cruise information