;****************************************************************************** ; MSP430G2x21/G2x31 Demo - SPI full-Duplex 3-wire Master ; ; Description: SPI Master communicates full-duplex with SPI Slave using ; 3-wire mode The level on P1.4 is TX'ed and RX'ed to P1.0 ; Master will pulse slave P1.2 which resets USICNT counter for synch start ; ACLK = n/a, MCLK = SMCLK = Default DCO ; *******THIS IS MASTER CODE****** ; Slave Master ; MSP430G2x21/G2x31 MSP430G2x21/G2x31 ; ; | XIN|/|\| XIN|; | | | | | ; | XOUT| |RST XOUT|; | | /|\ | | ; | RST/NMI| +< |P1.2 | ; LED LED ; | SDI/P1.7|< -|P1.6/SDO | ; | SDO/P1.6| ->|P1.7/SDI | ; | SCLK/P1.5|< -|P1.5/SCLK | ; ; D Dang ; Texas Instruments Inc ; October 2010 ; Built with Code Composer Essentials Version: 4.2.0 ;****************************************************************************** cdecls C,LIST, "msp430g2221.h" ; -.text ; Program Start ; -RESET mov.w #0280h,SP ; Initialize stackpointer StopWDT mov.w #WDTPW+WDTHOLD,&WDTCTL ; Stop watchdog timer SetupP1 mov.b #010h,&P1OUT ; P1.4 set, else bis.b #010h,&P1REN ; P1.4 pullup bis.b #001h,&P1DIR ; SetupUSI bis.b #USIPE7+USIPE6+USIPE5+USIMST+USIOE,&USICTL0; Port, SPI master bis.b #USIIE,&USICTL1 ; Counter interrupt, flag remains mov.b #USIDIV_4+USISSEL_2,&USICKCTL ; /16 SMCLK bic.b #USISWRST,&USICTL0 ; Enable USI mov.b &P1IN,&USISRL ; init-load TX data ResetSlave bis.b #004h,&P1DIR ; Reset Slave bic.b #004h,&P1DIR ; clr.w R4 ; Delay for Slave Delay dec.w R4 ; jnz Delay ; mov.b #08h,&USICNT ; init-load counter, clear flag ; Mainloop bis.b #LPM0+GIE,SR ; CPU off w/ interrupts enabled nop ; Required for debugger only ; ; -USI_ISR; ; -mov.b &USISRL,R4 ; Temp save RX'ed char mov.b &P1IN,&USISRL ; bic.b #01h,&P1OUT ; bit.b #010h,R4 ; jnc L2 ; L1 bis.b #01h,&P1OUT ; L2 mov.b #08h,&USICNT ; re-load counter, clear flag reti ; Exit ISR ; ; -; Interrupt Vectors ; -.sect ".reset" ; MSP430 RESET Vector short RESET ; sect ".int04" ; USI Vector short USI_ISR ; end