1. Trang chủ
  2. » Kỹ Thuật - Công Nghệ

Toyota training smart key handout

3 347 5

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Định dạng
Số trang 3
Dung lượng 197,03 KB

Nội dung

Code to this vehicle • Certification ECU is functioning • Door oscillator is functioning • T • Key battery is above 2.2V • V • Certification ECU verified vehicle and Key ID codes fr When

Trang 1

Code) to this vehicle • Certification ECU is functioning • Door oscillator is functioning • T

• Key battery is above 2.2V • V

• Certification ECU verified vehicle and Key ID codes fr

When the key is taken inside the vehicle the key LED flashes

Engine/Power switch LED illuminates green after the brake pedal is depr

• ID Code Box is functioning • Steering Lock ECU is functioning • S code verified • L code verified

• Lock bar in unlock position signal sent to the certification ECU • ECM is functioning • 3 bit code has been sent to the ECM

Trang 2

S MART K EY

Starting Questions

1 What is the vehicle battery voltage?

2 Was the car jumped, or did the battery go flat?

3 Is the Smart Key system turned off?

4 Does the wireless remote lock and unlock the doors?

5 Will the car crank or start with the immobilizer over ride?

6 Is the key battery good?

7 Does the red light on the key flash when you walk up to a locked car or get into the car?

8 Can you verify key RF transmission with SST?

9 Does the green light on the engine/power switch light up?

10 What is the status of the steering lock?

11 Does the car crank?

12 Does the car crank, start, and stall?

13 Is the security light on or flashing?

14 Health Check - DTCs?

15 Can you display a Smart Access ECU data list?

16 Service History?

Trang 3

Required after installation of

fi cation ECU

Communication ID Registration)

at DLC3 (TC to CG for 30-44 minutes

Communication ID Registration)

at DLC3 (TC to CG for 30-44 minutes

Ngày đăng: 21/09/2017, 06:05

TỪ KHÓA LIÊN QUAN

w