The design of tall buildings ETABS tutorial 1

The Design of Tall Buildings ETABS Tutorial 1 Define New Model Define New Model • • Choose Choose “ “ NO NO ” ” Building Parameters Building Parameters • • Columns 30 Columns 30 ” ” x30 x30 ” ” • • Beams 24 Beams 24 ” ” x24 x24 ” ” • • Shear walls: Shear walls: – – Outer walls: 84 Outer walls: 84 ” ” – – Inner wall: 24 Inner wall: 24 ” ” – – Transverse wall: 8 Transverse wall: 8 ” ” Shear Wall Preliminary Design Shear Wall Preliminary Design Define 1 Define 1 st st Storey Storey • • Choose Choose “ “ Grid Only Grid Only ” ” – – Model 1 Storey properly, run analysis, and check for any Model 1 Storey properly, run analysis, and check for any improperly connected nodes. improperly connected nodes. Ready to Begin Ready to Begin Define Properties Define Properties • • Material Properties Material Properties • • Frame Sections Frame Sections • • Slab/Wall Sections Slab/Wall Sections • • Static Load Cases Static Load Cases • • Load Combinations Load Combinations Material Properties Material Properties • • Add new material Add new material Frame Sections Frame Sections • • Add new Rectangular Sections Add new Rectangular Sections [...]... Sections • Always choose Shell for walls/slabs • Membrane and Plate are remnants from previous versions Add Slab Define Load Cases • Self Weight is to be counted as dead load Load Combinations • DDL = Design Dead + Live • SDL = Service Dead + Live Draw Columns Draw Beams Delete Beam/Columns to Place Shear Walls Draw Shear Walls Draw Slab Turn on Object Fill Delete Slabs Inside Core Draw Slabs Around . The Design of Tall Buildings ETABS Tutorial 1 Define New Model Define New Model • • Choose Choose “ “ NO NO ” ” Building. 8 ” ” Shear Wall Preliminary Design Shear Wall Preliminary Design Define 1 Define 1 st st Storey Storey • • Choose Choose “ “ Grid Only Grid Only ” ” – – Model 1 Storey properly, run analysis,. be counted as dead load. dead load. Load Combinations Load Combinations • • DDL = Design Dead + Live DDL = Design Dead + Live • • SDL = Service Dead + Live SDL = Service Dead + Live Draw Columns Draw