Add Component 8-53 MoldWorks2006 User Guide o ponent length • L - C m Add Component 8-54 MoldWorks2006 User Guide nte ock Female 8.30 Tapered I rl Create a tapered interlock (female part) and hole(s) through the relevant plates. This component is part of the same interlock component group, which goes together. They include male and female parts of the interlock and the 2 shoulder plates. Press to see the parameter scheme. Parameters - use the scroll bar on the right- hand side to access the missing parameters. • D* - Interlock diameter. • D1 - Inner shoulder diameter. • A - Inner shoulder angle. • M - Screw hole. • K - Inner shoulder depth. • L3 - Interlock (male) depth. • L - Component length. D*, D1, A, M and L3 should be identical to the corresponding parameters from the Tapered Add Component 8-55 MoldWorks2006 User Guide Interlock Male. Add Component 8.34 Spring Create springs and spring hole(s) through the relevant plates according to th ersize" values. Press e "Ov to see the parameter scheme. Parameters • D1* - External spring diameter. • D - Internal spring diameter. • L - Spring length (free). Corresponds to catalogue number. • L0 - Spring length in mold (without tension) dictates actual creation length. 8-59 MoldWorks2006 User Guide Add Component 8.35 Stamps Create a stamp and stamp hole(s) through the relevant plate. MoldWorks supports the following stamps (not all the catalogues support all the stamps): The parameters for all of the stamps are the same. Here we give an example of the Week Date Stamp. Press to see the parameter scheme. 8-60 MoldWorks2006 User Guide Add Component 8-61 MoldWorks2006 User Guide Parameters • • D - Stamp diameter. L - Stamp length. . 8-53 MoldWorks2006 User Guide o ponent length • L - C m Add Component 8-54 MoldWorks2006 User Guide nte ock Female 8.30 Tapered I rl Create a tapered interlock (female part) and hole(s). relevant plates. This component is part of the same interlock component group, which goes together. They include male and female parts of the interlock and the 2 shoulder plates. Press to see. Week Date Stamp. Press to see the parameter scheme. 8-60 MoldWorks2006 User Guide Add Component 8-61 MoldWorks2006 User Guide Parameters • • D - Stamp diameter. L - Stamp length.