Managing the Exchange 2007 Mailbox Server Role • Chapter 4 197 4. Type the name the Department fi eld of the recipients you want to have listed in the address list. In this example, we want to list all recipients belonging to the management department. Click Add to add department(s) to the list (see Figure 4.30), then click OK. Figure 4.29 Specifying the Conditions for the New Address List 198 Chapter 4 • Managing the Exchange 2007 Mailbox Server Role 5. Now click the Preview button to verify that the respective recipients are listed as in Figure 4.31, and then click OK again. Figure 4.30 Specifying the Department NOTE You can also create an address list based on a custom recipient fi lter (also called an OPath fi lter), but doing so is only possible using the EMS. Once you’ve created an address list using a custom recipient fi lter, you can also only manage it via the Managing the Exchange 2007 Mailbox Server Role • Chapter 4 199 6. We now have the option of specifying when the address list should be applied and the maximum length of time it is permitted to run. In this example, we will apply it immediately, but you could also schedule it to be applied sometime in the future. Click Next when you have decided when to apply the address list (see Figure 4.32). Figure 4.31 Address List Preview EMS. To create an address list using a custom recipient fi lter, you need to use the following command: New-AddressList –Name <String> -RecipientFilter <String>. For examples as well as a further explanation, see the Exchange 2007 Help File or type Get-Help New-AddressList in the EMS. 200 Chapter 4 • Managing the Exchange 2007 Mailbox Server Role 7. You now will see a Confi guration Summary. Here you can see the type of recipients that will be included in the address list, and you can also see the recipient fi lter. If everything looks good, click New to create and apply the list see (Figure 4.33). Figure 4.32 Specifying When the Address List Should Be Applied Managing the Exchange 2007 Mailbox Server Role • Chapter 4 201 8. After a few seconds, the New Address List Wizard will have completed successfully, and you can then click Finish (see Figure 4.34). Figure 4.33 The New Address List Summary Page . recipients that will be included in the address list, and you can also see the recipient fi lter. If everything looks good, click New to create and apply the list see (Figure 4.33). Figure 4.32 Specifying. • Chapter 4 199 6. We now have the option of specifying when the address list should be applied and the maximum length of time it is permitted to run. In this example, we will apply it immediately,. Preview EMS. To create an address list using a custom recipient fi lter, you need to use the following command: New-AddressList –Name <String> -RecipientFilter <String>. For examples as well