International Standard INTERNATIONAL ORGANIZATION FOR STANDARDIZATIONWlE>KJ1YHAPO~HAR OPrAHM3AUMR ll0 CTAH~APTbl3A~MM ORGANISATION INTERNATIONALE DE r; lORMALISATION Hot rolled steel bars Part 3 Dimen[.]
International Standard INTERNATIONAL ORGANIZATION FOR STANDARDIZATIONWlE>KJ1YHAPO~HAR OPrAHM3AUMR ll0 CTAH~APTbl3A~MM.ORGANISATION INTERNATIONALE DE r;lORMALISATION Hot-rolled steel bars Part : Dimensions of flat bars Barres en acier lamin4es chaud Partie : Dimensions des barres plates First edition _UDC Descriptors - 1980-11-01 Ref No 669.14-422 : metal products, iron and steel products, hot rolled products, steel products, metal bars, flat bars, ISO 1035/3-1980 (EI dimensions Price based on page Foreword ISO (the International Organization for Standardization) is a worldwide federation of national Standards institutes (ISO member bedies) The work of developing International Standards is carried out through ISO technical committees Every member body interested in a subject for which a technical committee has been set up has the right to be represented on that committee International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work Draft International Standards adopted by the technical the member bodies for approval before their acceptance the ISO Council committees are circulated as International Standards to by International Standard ISO 1835/3 ISO/TC 17, Steel, and was circulated was developed by Technical Committee to the member bodies in December 1978 lt has been approved bodies by the member of the following Germany, F R Hungary India Italy Korea, Dem P Rep sf Korea, Rep of Netherlands New Zealand Poland Austria Belgium Bulgaria Canada Czechoslovakia Denmark Egypt, Arab Rep of Finland France The member bodies of the following on technical grounds : countries expressed Australia Japan USA International Printed Organkation in Switzerland for Standardkation, 1980 countries : Romania South Africa, Rep of Spain Sweden Switzerland Thailand Turkey United Kingdom USSR disapproval of the document INTERNATIONAL STANDARD ISO 1035/3-1980 (EI AMENDMENT SLIP Published 1981-01-15 ORGANIZATION Hot-rolled steel bars - Part : Dimensions MODIFICATION The following FOR STANDARDIZATION l MEXfi’YHAPOflHAJl INTERNATIONAL TO FOREWORD OPrAHM3A~MII I’IO CTAHfiAPTM3ALJMM *ORGANISATION INTERNATIONALE DE NORMALISATION of flat bars (hside front cover) sentence is to be added at the end of the foreword : “This International Standard cancels and replaces ISO Recommendation technical revision.” R 1035/3-1969, of which it constitutes a This page intentionaily left blank ISO 1035/3-1980 INTERNATIONALSTANQARD (E) Hot-rolled steel bars Part : Dimensions of flat bars Scope and field This international Standard specifies series hot-rolled steel flat bars of application dimensions of 3.1 metric Table - of Dimensions and tolerantes The dimensions of flat bars are given in the table 3.2 Unless otherwise specified in the Order, the tolerantes on the dimensions of flat bars shall be the normal tolerantes specified in ISO 1035/4 Tokances tighter than those specified in ISO 1035/4 will form the subject of a future International Standard Reference ISO 103514, Hot-rot’ed steel bam - Part : Tolerantes round, Square and flat Bars - Metric series Dimensions and massesl) per unit length Dimensions in millimetres 2,36 The values of mass at-e based on a density of steel of 7,85 kg/dm? - ihis page intentionally left blank