Style Guide and Template for OEL[2021-06]

OPTOELECTRONICS LETTERS Vol.XX No.X, date Instructions for the preparation of a manuscript for Optoelectronics Letters * AUTHOR ONE (作作作)1,2**, AUTHOR TWO (作作作)1, AUTHOR THREE (作作作)1 1.Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, China 2.University of Chinese Academy of Sciences, Beijing 100059, China (Received XXXXX; Revised XXXXX) ©Tianjin University of Technology and Springer-Verlag Berlin Heidelberg 2017 The abstract should be in 9-pt Times New Roman font, and alignment double (left and right) justified Indent left and right margins 2.5 characters (0.925 cm) The abstract should be limited to approximately 100 words It should be an explicit summary of the paper that states the problem, the methods used, and the major results and conclusions It also should contain the relevant key words that would allow it to be found in a cursory computerized search Do not include equations inside the abstract The use of complete and properly formatted references is particularly important Adherence to these guidelines will significantly expedite the production of your paper Document code: A Article ID: XXXX-XXXX(XXXX)XX-XXXX-X DOI XX.XXXX/XXXXXX-XXX-XXXX-X Adherence to the specifications listed in this style guide is essential for efficient review and publication of submissions Optoelectronics Letters accepts Word style submissions The express journal style and layout rules have been followed in this guide Page layout and length Paper size should be A4, 21 cm x 29.7 cm The margins for articles published in Optoelectronics Letters are 3.5 cm (top), 1.7 cm (bottom), and cm (left and right) Please ensure that these margins are set for the whole document The manuscript page length for journal article is limited in pages Typographical style The title, author listing, captions for figures and tables and all headers should be in Arial font The rest of the text and body of the article should be Times New Roman 2.1 Title The title should be in 18-pt bold Arial font, and alignment double (left and right) justified The line space should be 20-pt Use initial cap for first word in title or for proper nouns The title will have an asterisk in the end correlating to the foundations at the footnotes of the page 2.2 Author names Please leave one blank line between the title and author names The abstract should be in 9-pt bold Arial font using small caps, and alignment double (left and right) justified Indent left and right margins 2.5 characters (0.925 cm) Lines should be single-spaced Author names should appear as used for conventional publication, with first and middle names or initials followed by surname 2.3 Author affiliations All authors and affiliations should be styled in 9-pt italic Times New Roman font If all authors share one affiliation, superscript numbers are not needed The corresponding author will have two asterisks correlating to an email address marked at the footnotes of the page All authors must be grouped together using superscripts to callout each affiliation Hard returns (Enter key) must be used to separate each individual affiliation Abbreviations should not be used Please include the country at the end of the affiliation 2.4 Main text Please leave two blank lines between the DOI and main text The line space of main text should be 12-pt The first line of the first paragraph of a section or subsection should start flush left The first line of subsequent paragraphs within the section or subsection should be indented one characters (0.37 cm) All main text should be alignment double (left and right) justified The main text should in 9-pt Times New Roman font 2.5 Figures and tables Please leave one blank line before and after each figure and table Place figures and tables as closely as possible to where they are mentioned in the text Figures must be inserted as objects that are fixed and move with the text, not as floating objects Figures should never be placed in a table environment, embedded inside the text, or included within a list All the figures should be centered *This work has been supported by the National High Technology and Development Program of China (No XXXXXXXXXX), and the National Science and Technology Major Project of China (No XXXXXXXXXX) ** E-mail: oel@263.net ·XXXX· All figure captions should be centered beneath the figure Longer figure captions should be centered beneath the figure and alignment double (left and right) justified, but are not to exceed the left and right edge of the main text The abbreviation “Fig.” for figure should appear first followed by the figure number and a period Captions should be in 9-pt bold Arial font Half line of space should be left between the figure and the caption The resolution of grey-scale and color figure should be 150-225 dpi; and the resolution of bitmap should be 600900 dpi Optoelectron Lett Vol.XX No.X equation: nc ( λ ) ∆ L = mλo (1) All equations should be numbered in the order in which they appear and should be referenced from within the main text as Eq (1) 2.7 References References should appear at the end of the article, in the order in which they are referenced in the body of the paper (see below) The words “References” should be in 10-pt bold Arial font, double-spaced and alignment double (left and right) justified The content below should in 9-pt Times New Roman font The line space should be 12-pt All references should be hanging indented 0.74 cm This journals use numerical notation in brackets for bibliographic citations At the point of citation within the main text, designate the reference by typing the number in after the last corresponding word [1] Reference numbers should precede a comma or period [2] Two references [3,4], should be included together, separated by a comma, while three or more consecutive references should be indicated by the bounding numbers and a short dash [1–4] Fig.1 Sample caption References Authors must use Word’s Table editor to insert tables Authors must not import tables from Excel Tables should use horizontal lines to delimit the top and bottom of the table and column headings All table captions should be centered above the table Longer table captions should be centered above the table and alignment double (left and right) justified, but are not to exceed the left and right edge of the main text The abbreviation “Tab.” for table should appear first followed by the table number and a period Captions should be in 9-pt bold Arial font Half line of space should be left between the table and the caption The content in the table should be in 8-pt Times New Roman font 2.6 Equations This journal not accept equations built using the Word 2007 or 2010 Equation Builder All display equations should be created in MathType (or the Microsoft Equation editor from Design Science) Inline equations can be created with these tools or by using keyboard and Unicode characters where needed for the best quality line spacing We strongly encourage authors to use MathType 6.7 Equations should be indented one characters (0.37 cm), and equation numbers should appear at the righthand margin, in parenthesis For long equations, the equation number may appear on the next line For very long equations, the right side of the equation should be broken into approximately equal parts and aligned to the right of the equal sign The equation number should appear only at the right hand margin of the last line of the Journal [1] OJALA T, PIETIKAINEN M, MAENPAA T Multiresolution gray-scale and rotation invariant texture classification with local binary patterns [J] IEEE transactions on pattern analysis and machine intelligence, 2002, 24(7)作971-987 Book [2] YARIV A, YEH P Optical electronics in modern communications [M] Chen H M, Shi W H, Wang J L, et al, Transl 6th ed Beijing 作 Electronic Industry Press, 2014作5-28 [3] DHAKAD S K, DWIVEDI U, BAUDHA S, et al Performance improvement of fractal antenna with electromagnetic band gap (EBG) and defected ground structure for wireless communication [M]//Gnanagurunathan G, Sangeetha R, Kiran K Optical and microwave technologies Lecture Notes in Electrical Engineering, Singapore作Springer, 2018, 468作9-19 Conference Papers [4] CHEN S T, CHENG J H, GAO W A phase modulation method for improving the scale factor stability of fiberoptic gyroscope [C]//Proceedings of 2008 IEEE International Conference on Mechatronics and Automation, August 5-8, 2008, Takamatsu, Japan New York作IEEE, 2008, 978作37-42 [5] KORN G, LEGARREC B, RUS B ELI extreme light infrastructure science and technology with ultra-intense laser [C]//2013 Conference on Lasers and Electro-Optics (CLEO), June 9-14, 2013, San Jose, CA, USA New York作IEEE, 2008, 14381056 OPTOELECTRONICS LETTERS [6] BOULLET J, DUBRASQUET R, BELLO-DOUA R High average power, high energy fiber laser system 作 operation at 977 nm and frequency doubling at 488 nm [C]//Advanced Solid-State Photonics 2010, January 31February 3, 2010, San Diego, California, United States Washington作Optical Society of America, 2010作AwA5 Standard [7] Information and documentation-the Dublin core metadata element set 作 ISO 15836 作 2009 [S/OL] [2013-03-24] http 作 //www.iso.org/iso/home/store/catalogue_tc/ catalogue_detail.htm? csnumber=52142 Patent [8] LIU J L Multi-functional disposable tongue spatula 作 CN92214985.2 [P] 1993-04-14 [9] TACHIBANA R, SHIMIZU S, KOBAYSHI S, et al Electronic watermarking and system 作 US6915001 [P/OL] 2005-07-05[2013-11-11] http作//www.google.co.in/patents/US6915001 Report [10] World Health Organization Factors regulating the immune response 作report of WHO Scientific Group [R] Geneva作WHO, 1970作66 Network literature [11] Dublin core metadata element set 作version 1.1 [EB/OL] (2012-06-14) [2014-06-11] http作//dublincore.org/documents/dces/ Vol.XX No.X, date ... Performance improvement of fractal antenna with electromagnetic band gap (EBG) and defected ground structure for wireless communication [M]//Gnanagurunathan G, Sangeetha R, Kiran K Optical and. .. top and bottom of the table and column headings All table captions should be centered above the table Longer table captions should be centered above the table and alignment double (left and right)... centered beneath the figure and alignment double (left and right) justified, but are not to exceed the left and right edge of the main text The abbreviation “Fig.” for figure should appear first