shop manual ktln 3

... X^NG I I I 3- 4 * VằN HNH TAY GA I I I 3- 4 LC GI CH (2) C C R 22 -30 THỳNG HÂI MY CH (3) C C C 3- 6 BU GI I R I 3- 6 * KHE Hè x pp I I I I 3- 8 DU NHẻT MY R R R R 3- 9 * MN LC NHẻT MY C 3- 11 ** LC ... NHẻT MY C 3- 11 ** TC [ẩ CM CHNG I i i i 3- 12 XCH TI 3- 12 DU PHANH ch (4) I I I 3- 17 MN B/ GUC PHANH I I I 3- 18 H THNG PHANH I I I I 3- 18 * cng tổc [N phanh I I I 3- 20 {ẩ...

Ngày tải lên: 15/01/2014, 14:40

Ngày tải lên: 29/10/2012, 15:06

... TEMPERATURES °F -70 -60 -50 -40 -30 -20 -10 0 +10 +20 +30 +40 +50 +60 +70 +80 +90 +100 +120 Lubricant ° C -57 -51 -46 -40 -34 -29 - 23 -18 -12 -7 -1 +4 +10 +16 +21 +27 +32 +38 +49 OE/HDO Lubricating ... TEMPERATURES °F -70 -60 -50 -40 -30 -20 -10 0 +10 +20 +30 +40 +50 +60 +70 +80 +90 +100 +120 Lubricant ° C -57 -51 -46 -40 -34 -29 - 23 -18 -12 -7 -1 +4 +10 +16 +21 +27 +32 +38 +49 OE/HDO Lub...

Ngày tải lên: 22/10/2012, 09:13

... position. AM09 034 0A AM09 038 0A HEAT OFF ON START AM09 039 0A HEAT OFF ON START Ambient temperature Preheating time Above 0° C - 0°C to -10°C 20 seconds -10°C to -20°C 30 seconds AM09 036 0A OFF HEAT ON START OPERATION ... minutes. When starting in low temperatures, do as follows. AM09 034 0A AM09 035 0A HEAT OFF ON START AM09 036 0A OFF HEAT ON START AD324280A OPERATION OPERATION 115 1. S...

Ngày tải lên: 22/10/2012, 09:45

... remover NT546 Removing tie-rod outer end a: 33 mm (1 .30 in) b: 50 mm (1.97 in) r: R11.5 mm (0.4 53 in) KV401021S0 (—) Bearing race drift NT1 53 Installing wheel bearing outer race KV40105400 (J36001) Wheel bearing lock ... oil seal a: 54.5 mm (2.15 in.) b: 34 .5 mm (1 .36 in.) GI MA EM LC EC FE CL MT AT TF PD SU BR ST RS BT HA SC EL IDX REAR AXLE Preparation (Cont’d) AX- 23 AFA1 43 3....

Ngày tải lên: 22/10/2012, 11:50

... SWITCH 31 Check 31 Replacement 32 STEERING SWITCH 33 Check 33 HEADLAMP (FOR USA) 34 System Description 34 Wiring Diagram - H/LAMP 35 Trouble Diagnoses 36 Bulb Replacement 37 Aiming Adjustment 38 HEADLAMP ... (Cont’d) EL-10 SEL544T Unit: mm (in) *1 39 0 (15 .35 ) *5 145 (5.71) *2 160 (6 .30 ) *6 1 43 (5. 63) *3 379 (14.92) *7 225 (8.86) *4 140 (5.51) *8 535 (21.06) *...

Ngày tải lên: 22/10/2012, 11:51

... Max. X ms P0 131 0AH 84H Min. X mV P0 130 0BH 04H Max. X mV P0 132 0CH 04H Max. X mV P0 134 0DH 04H Max. X s P0 139 19H 86H Min. X mV/500ms P0 137 1AH 86H Min. X mV P0140 1BH 06H Max. X mV P0 138 1CH 06H ... Max. X mV P0 135 29H 08H Max. X mV P0 135 2AH 88H Min. X mV P0141 2DH 0AH Max. X mV P0141 2EH 8AH Min. X mV P0400 31 H 8CH Min. X ℃ P0400 32 H 8CH Min. X ℃ P0400 33 H 8CH Min. X ℃ P040...

Ngày tải lên: 22/10/2012, 11:51

... No. 1-2 3- 5 1-2 3- 7 3- 8 3- 9 3- 4 3- 6 AAT551A 2. If NG, check again with manual control linkage disconnected from manual shaft of A/T assembly. Refer to step 1. 3. If OK on step 2, adjust manual ... 33 OBD-II Function for A/T System 33 One or Two Trip Detection Logic of OBD-II 33 OBD-II Diagnostic Trouble Code (DTC) 33 Malfunction Indicator Lamp (MIL) 37 CONSULT-II...

Ngày tải lên: 22/10/2012, 11:51

... AND ELECTRIC UNIT, BR -31 .) DESCRIPTION ABS System Components BR -30 BRAKE SYSTEM SECTION BR CONTENTS PRECAUTIONS 3 Supplemental Restraint System (SRS) ″AIR BAG″ and ″SEAT BELT PRE-TENSIONER″ 3 Precautions ... stop lamp switch and ASCD switch 0 .3 - 1.0 mm (0.012 - 0. 039 in) A: Pedal free play 1-3mm(0.04 - 0.12 in) If necessary, adjust brake pedal free height. SBR 930 1. Loosen lock...

Ngày tải lên: 22/10/2012, 11:51

... (Cont’d) BT -33 ABT455 EXTERIOR Removal and Installation (Cont’d) BT -34 ABT456 GI MA EM LC EC FE CL MT AT TF PD AX SU BR ST RS HA SC EL IDX EXTERIOR Removal and Installation (Cont’d) BT -35 ABT 432 EXTERIOR Removal ... assembly. ABT451 GI MA EM LC EC FE CL MT AT TF PD AX SU BR ST RS HA SC EL IDX BACK DOOR TRIM Removal and Installation BT -31 Removal and Installation NGBT00 13 ABT4 53...

Ngày tải lên: 22/10/2012, 11:51