Emission Control Systems

... communication, DLC terminal is reserved for the CAN High (CAN_ H or CAN+ ) circuit and terminal 14 is reserved for the CAN Low (CAN_ L or CAN- ) circuit Since not all OBD I/M test equipment or scan ... Prior to CAN, DLC terminals & 14 were open for any use by the vehicle manufacturers (some restrictions apply – for details refer to SAE J1962), but as CAN is implemented on...

Ngày tải lên: 13/05/2014, 08:37

... HWT, two water valves 10 E70 Climate Control Systems Air Flow Control/ Blower Speed Control Air flow control is dependent on the following settings and parameters Blower control automatic mode If ... blower 19 E70 Climate Control Systems Operation and setting air conditioning, driver seat climate, front passenger seat climate With the optional seat climate equipmen...

Ngày tải lên: 19/10/2012, 13:50

Ngày tải lên: 05/03/2013, 17:01

... MIL-STD-461B/C RE-02 Army Equipment Figure MIL-STD-461 Narrowband Radiated Emissions Limits Note that in MIL-STD-461D, the narrowband radiated emissions limits were retitled RE-102 from the previous RE-02

Ngày tải lên: 05/11/2013, 22:15

... dellortnoc eb ot metsys eht htiw gnikrow yltcerid ot srefer ”smetsys ngiseD no sdnaH“ “Hands-on” Design of Control Systems metsys redro dnoces fo esnopseR petS :5 erugiF 0 20 40 60 time (secs) 80 100 ... hcihw maeb a no sedils m ssam fo llab A :4 giF ni nwohs metsys maeB-dna-llaB eht redisnoC Ball -and- Beam deniatbo stluser eht no tnemmoC 1x ssam tsrfi eht fo noitisop eht fo daetsni derus...

Ngày tải lên: 12/12/2013, 07:15

Ngày tải lên: 14/12/2013, 12:15

... SOFTWARE FOR DIGITAL CONTROL 28.12.1 Digital Control Hardware 28.12.2 Software for Digital Control 28.13 909 909 911 FUTURE TRENDS IN CONTROL SYSTEMS 28.13.1 Fuzzy Logic Control 28.13.2 Neural ... 28.5 CONTROL LAWS The control logic elements are designed to act on the error signal to produce the control signal The algorithm that is used for this purpose is called the contro...

Ngày tải lên: 17/12/2013, 14:15

... consists of ten objects and can be described using two concepts, namely “d = 0” and “d = 1.” As already mentioned, two conflicts, namely objects x5 and x7, and objects x6 and x8, exist in the data ... amplitudes in bands less than ‘1X’ and ‘1X’ A1: the ratio of peak amplitudes in band ‘1X’ and its initial record (in good condition) A2: the ratio of peak amplitudes in bands ‘2X’...

Ngày tải lên: 22/12/2013, 21:18

... magnitude of the sensitivity-function is made arbitrarily small 1.8 CONTROL SYSTEM ANALYSIS AND DESIGN OBJECTIVES Control systems engineering consists of analysis and design of control systems ... control systems Some of the terms commonly used to describe the operation, analysis, and design of control systems are presented 1.2 CONTROL SYSTEMS...

Ngày tải lên: 01/01/2014, 18:43