OPTIMIZATION OF SURFACE ROUGHNESS IN MICRO HIGH SPEED END MILLING OF SODA LIME GLASS USING UNCOATED TUNGSTEN CARBIDE TOOL WITH COMPRESSED AIR BLOWING

... designs, the resistance against axial rotation was assessed using FEM on the one hand and the analytical model on the other With respect to the FE models, the analytical model predicts a very stiff stability ... loads The run time of an FE analysis ranged from 45 minutes up to 60 minutes The run times of the MATLAB implementation of the analytical model...

Ngày tải lên: 20/06/2014, 01:20

... arrangements of flow third tank Figure Schematic diagram for improvement of water quality by removal of SS and biological filtration in closed water bodies a a: screw motor Ｍ b: biological carrier ... Water and Environment Technology, Vol.1, No.2, 2003 Conclusion The experiment on improving water quality was carried out by removal of SS and biol...

Ngày tải lên: 05/09/2013, 08:40

Ngày tải lên: 31/03/2014, 05:21

... Significantly, more patients were achievers in the dobutamine group than in the volume group, especially in the intraoperative period If therapy-induced differences in oxygen delivery determine better ... (Figure 1) The patients randomized to the dobutamine group received the first fluid cycle during 60–90 minutes followed by increasing doses of dobutamine, beginning...

Ngày tải lên: 12/08/2014, 23:23

... 4.3 Measurement of radiated emission from interconnects in simple RF circuits 113 4.4 Measurement of radiated emission from interconnects in digital circuits 118 4.4.1 Measurement ... modeling and measurement of electromagnetic radiated emission from interconnects in digital circuits Since the radiated emission is investigated i...

Ngày tải lên: 09/09/2015, 08:12

... MANAGEMENT OF FIBER PHYSICAL EFFECTS IN HIGH- SPEED OPTICAL COMMUNICATION AND SENSOR SYSTEMS YANG JING (B Eng., Xi’an Jiaotong University, China) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF ... in both optical transmission and sensor systems In this chapter, the physical effects of optical fibers are introduced in section 1.1 The limitation...

Ngày tải lên: 11/09/2015, 10:01

... properties of a thin gate insulating layer fabricated by plasma oxidation of Si depends greatly on the inert gas mixed in the oxygen plasma The gate insulating layer plasma oxidized in the Kr and O2 ... then on, a great deal of interest has been taken in MTJs The advantage of TMR devices is that the larger change in resistance can be obtained in smaller fields and the re...

Ngày tải lên: 14/09/2015, 18:30

... HIGH- SPEED MILLING OF TITANIUM ALLOYS: MODELING AND OPTIMIZATION WANG ZHIGANG (B Eng, M Eng) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF MECHANICAL ENGINEERING ... milling of titanium alloys This chapter introduces an overview of high- speed machining of titanium alloys; then a brief overview of milling process modeling...

Ngày tải lên: 16/09/2015, 17:13

... the solubilization of excess sludge by high speed rotary disk process This method is a kind of physical treatment The excess sludge from final sedimentation tank in wastewater treatment plant was ... 813-818 Hasegawa, S., Miura, M., Katsura, K (1997) Solubilization of organic sewage by thermophilic bacteria Journal of Japan Sewage Works Association, Vol.34,...

Ngày tải lên: 05/09/2013, 08:40

... Algorithms in Search, Optimization & Machine Learning AddisonWesley, Boston, 1989 Zhang Z., Agarwal R.K Numerical Simulation and Optimization of CO2 Sequestration in Saline Aquifers for Vertical and ... [4] Zhang Z., Agarwal R.K Numerical Simulation and Optimization of CO2 Sequestration in Saline Aquifers in: Proceedings of 10th Annual Confer...

Ngày tải lên: 05/09/2013, 16:10

... 16 Neural Networks and Neural- Fuzzy Approaches in an In- Process Surface Roughness Recognition System for End Milling Operations 16.1 16.2 16.3 16.4 Joseph C Chen Iowa State University Introduction ... of cutting force and surface generation in dynamic milling, ASME J Eng Ind., 113 (1), pp 160-168 Sutherland and Babin 1985, You, S J and Ehmann, K F.,...

Ngày tải lên: 23/01/2014, 01:20

... fruitful ways of investing public (and private) money RESULTS The energy cost-benefit analysis One of the main ecological justifications of the HSR projects would be the energy savings and the expected ... partridges and wolves) and a very rich diversity of flower The first HSR proposal dates back to the end of the eighties, and soon after the oppositi...

Ngày tải lên: 20/02/2014, 19:20

... natural protein substrate, the inhibitors, including the symmetric ones, tend to bind in an asymmetric fashion [40,42] Compounds 3, and were made in order to exploit the asymmetric binding Electron ... in uences the positioning of the inhibitor in the active site and thereby the structure of the protease Ó FEBS 2003 Optimization of HIV-1 protease inhibitors...

Ngày tải lên: 08/03/2014, 02:20

... the emulsification in the field of papermaking unique /67/ 37 INTERNAL SIZING OF PAPER AND BOARD The word sizing is used when talking about paper and board hydrophobation Two kinds of sizing; internal ... Merisalo Title of Thesis Optimization of ASA emulsification in internal sizing of paper and board Abstract In paper- and boardmaki...

Ngày tải lên: 09/03/2014, 01:20

... between helices 1–8 of Homo sapiens retinoid X receptor (HsRXR) and helices 9–12 of Locusta migratoria RXR (LmRXR)] as a partner of Choristoneura fumiferana ecdysone receptor (CfEcR), and shows low ... sapiens retinoid X receptor (HsRXR) and helices 9–12 of Locusta migratoria retinoid X receptor (LmRXR) A double mutant A62S:T81H of LmRXR A...

Ngày tải lên: 15/03/2014, 23:20