Fabrication of proton beam micromachined scaffolds for cell behaviour studies

... FABRICATION OF PROTON BEAM MICROMACHINED SCAFFOLDS FOR CELL BEHAVIOUR STUDIES ZHANG FANG (B.Sc.) A THESIS SUBMITTED FOR THE DEGREE OF MASTER OF SCIENCE DEPARTMENT OF PHYSICS NATIONAL ... conclusion of this project: proton beam micromachined scaffolds for cell behaviour Some suggestions for further development are discussed Chapter Fabrication o...

Ngày tải lên: 06/10/2015, 20:42

... Culture Applications 13 2.1.4 Nanofiber Modification for Cell Culture Applications 15 2.1.4.1 Doping of Bioactive Molecules 16 2.1.4.2 Nanofiber Surface Modification 17 2.2 Biomaterials Design for ... studies of bio- functionalization of electrospun nanofibers, which can serve as cell culture scaffolds that can promote cell- substrate interactions and are bioac...

Ngày tải lên: 12/09/2015, 09:08

... synthesis enhanced by T7 RNA polymerase Prior to the preparation of 15N-labelled samples of hCypA and analysis by NMR spectroscopy, the performance of the cell-free expression system was explored ... 2004 Cell-free synthesis of 15 N-labelled proteins (Eur J Biochem 271) 4087 Optimization of other conditions for in vitro protein synthesis Fig Cell-free...

Ngày tải lên: 16/03/2014, 18:20

... promising for the improvement of electroluminescence (EL) devices The effect of reducing the size of nanocrystals /nancmposites is expected to improve the performance of these devices and also their ... materials of II-VI semiconductors can be used as light emitting material for preparation of electroluminescence devices Semiconductor nanocrystals exhibit many unique...

Ngày tải lên: 28/04/2014, 10:50

... abundance of various-shaped gold nanostructures Figure exemplifies that the profile of the nanostructure after gold evaporation is different for conformal and non-conformal gold nanostructures, as well ... angles of h = 60°, 60°, 60° and u = 0°, 120°, 240° to the nanosphere kinds of gold depositions are simulated for wet etching: a–d are for 3D conformal gold de...

Ngày tải lên: 22/06/2014, 00:20

Ngày tải lên: 14/11/2014, 12:55

... including the review of nanofiltration, industrial applications of nanofiltration, especially the applications for sustainable pharmaceutical manufacture, fabrication of nanofiltration membranes, and ... 1.3 Applications of nanofiltration membranes 1.3.1 General applications 1.3.2 NF membranes for sustainable pharmaceutical manufacture 1.4 Fabrication of...

Ngày tải lên: 12/09/2015, 11:29

... the solar cell performance as compared to solar cell w/SLAR structure To investigate the performance of silicon nitride SWS before fabricating on a real silicon solar cell, we simulated the solar ... efficiency of 0.8% can be seen for silicon solar cell with silicon nitride SWS over a cell with single layer silicon nitride ARCs and only 0.3% less in e...

Ngày tải lên: 22/06/2014, 00:20

... et al.: A case report of pseudoprogression followed by complete remission after proton-beam irradiation for a low-grade glioma in a teenager: the value of dynamic contrastenhanced MRI Radiation ... Tsuyuguchi N, Iwai Y, Yamanaka K, Higashiyama S, Takami T, Ohata K: Diagnostic accuracy of 11C-methionine PET for differentiation of recurrent br...

Ngày tải lên: 09/08/2014, 10:20

... great advancements in the area of lab- on- a- chip devices In this chapter, a variety of micro and nano -fabrication techniques are discussed This discussion starts from an array of conventional ... development of proton beam writing for the fabrication of lab- on- a- chip devices Chapter introduces alternative micro- and nano -fabrication techno...

Ngày tải lên: 12/09/2015, 11:29

... common fuel cell types are Polymer Electrolyte Membrane Fuel Cell (PEMFC), Alkaline Fuel Cell (AFC), Phosphoric Acid Fuel Cell (PAFC), Molten Carbonate Fuel Cell (MCFC), and Solid Oxide Fuel Cell ... Hoogers, Fuel Cell Technology Handbook, CRC Press LLC, (2003) Chapter Polymer Electrolyte Membrane Fuel Cell (PEMFC) 2.1 Introduction Polymer Electr...

Ngày tải lên: 06/10/2015, 20:42

... results of PHB, PHBV( 5%), PHBV( 8%) and PHBV( 12%) microspheres before and after degradation 75 Table 4.13 DSC results of PHB, PHBV( 5%), PHBV( 8%) and PHBV( 12%) microspheres before and after degradation ... 4.10 Mass loss of the PHB, PHBV( 5%), PHBV( 8%) and PHBV( 12%) microspheres one year after degradation 73 Table 4.11 Contact angle measurements...

Ngày tải lên: 06/10/2015, 20:43

... FACS analysis of the internalization of the full-length Tat protein construct and the Tat CPP Differences in the mechanisms of internalization between the Tat peptide and the Tat fused protein ... at the surface of the Tat- containing recombinant proteins and call other reasons to explain the differences in the mechanism of interna...

Ngày tải lên: 21/02/2014, 03:20

... provided by the biological–inorganic complex Use of peptide nanostructures to form conductive nanowires Another key research direction for the fabrication of biological fibrils involves the use of peptide ... attachment of the intercalator [11] The use of metal- coated DNA molecules was also demonstrated for DNA-assisted wiring of gold electrodes on silicon...

Ngày tải lên: 16/03/2014, 12:20

... and encapsulated using glass rings and a biocompatible epoxy glue Please cite this article in press as: X.T Vu, et al., Fabrication and application of silicon nanowire transistor arrays for biomolecular ... et al., Fabrication and application of silicon nanowire transistor arrays for biomolecular detection, Sens Actuators B: Chem (2009), doi:10.101...

Ngày tải lên: 16/03/2014, 15:24