Modeling and optimization of liquefied natural gas process

... MODELING AND OPTIMIZATION OF A LIQUEFIED NATURAL GAS PROCESS M M FARUQUE HASAN (BSc in Chem Engg., Bangladesh University of Engineering & Technology) A THESIS SUBMITTED FOR THE DEGREE OF PHD ... Although natural gas (NG) is the natural choice among fossil fuels, most NG reserves are offshore and away from demand sites Liquefied natural gas (LNG) is the most eco...

Ngày tải lên: 14/09/2015, 08:45

... aspects of fulfilling the main objective of this thesis 18 CHAPTER ONE – INTRODUCTION RESEARCH OBJECTIVES Modeling and Optimization of the FO Process: Parameters Selection, Flux Prediction and Process ... this thesis seeks to suggest the use of the forward osmosis (FO) process for the low cost production of clean drinking water and an alternative...

Ngày tải lên: 10/09/2015, 15:48

... overall consumption of these utilities/gases in the entire refinery This thesis mainly addresses the modeling and optimization of such gas networks in a refinery The refinery gas networks considered ... process modeling and optimization to minimize the cost of design and operation of the gas networks in the refinery namely the hydrogen networks...

Ngày tải lên: 02/10/2015, 17:14

... Is the primary root valve available and accessible to shut off the line? Could water be FIRE-PROTECTION CONSIDERATIONS FOR THE DESIGN AND OPERATION OF LIQUIFIED PETROLEUM GAS (LPG) STORAGE FACILITIES ... Institute FOREWORD This publication covers aspects of the design, operation, and maintenance of liqueÞed petroleum gas (LPG) storage fac...

Ngày tải lên: 27/03/2014, 14:07

... the reliability modeling and optimization of some networked systems The reliability of a system is usually dependent on the structure of the system and the resources spent on the maintenance and ... As many of today’s systems are large and complicated, the reliability analysis of such systems has drawn much attention, see Cook and RamirezMarquez (2009),...

Ngày tải lên: 10/09/2015, 15:51

... 1.3 Microbial Fuel Cells ……………………………………………………………….2 1.4 Microbial Fuel Cells for wastewater treatment and energy recovery ……………… Chapter : Literature Review 2.1 Principle of a Microbial ... 22 2.4 Microbial Fuel Cell Modeling …………………………………………………… 22 Chapter : Theoretical developments 24 3.1 Modeling of our Microbial Fuel Cells …………………………………………….24 3.1.1 Descrip...

Ngày tải lên: 16/10/2015, 15:39

... of engine parameters on performance and emissions of a pilot ignited natural gas diesel engine Energy 2010;35:1129–38 [11] Wannatong K, Akarapanyavit N, Siengsanorh S, Chanchaona S Combustion and ... A2 T þ A3 T þ A4 T þ Þ ð5Þ [16] Mbarawa M, Milton BE, Casey RT Experiments and modeling of natural gas Cp ¼ð where (A0 ), (A1 ), (A2 ), (A3 ), and (A4 ) are con...

Ngày tải lên: 15/06/2014, 09:26

... GAUSSIAN PROCESS- BASED DECENTRALIZED DATA FUSION AND ACTIVE SENSING AGENTS: Towards Large- Scale Modeling and Prediction of Spatiotemporal Trafc Phenomena CHEN JIE (M.Eng, ... FAS Gaussian process- based decentralized data fusion DAS and active sensing decentralized active sensing FDAS fully decentralized active sensing PDAS par...

Ngày tải lên: 10/09/2015, 09:04

... status and achievements of mathematical modeling of both avascular and vascular tumor growth It included the models of avascular tumors, multicellu- 18 2.1 Mathematical modeling of cancer growth ... field of modeling of avascular tumor growth has been quoted extensively and form the basis for most of the future works According to Burton (1966), the tumor...

Ngày tải lên: 10/09/2015, 15:48

... work and discussions with Mr Sukanta Kumar Hazra and Mr Wang Haiguang Many others have contributed to making the author’s candidature at the Institute for Infocomm Research a satisfying and enlightening ... either not change throughout a flow, or typically increase with small deltas between consecutive packets of a flow Header compression capitalizes on the behavioral patt...

Ngày tải lên: 16/09/2015, 12:35

... 8.1 Introduction 117 vi 8.2 Principle and modeling of micro/nanoELID grinding 118 8.2.1 Modeling of the work surface 121 8.2.2 Modeling of the ELID -grinding wheel surface 123 8.2.3 Modeling the ... conventional grinding 53 Figure 5.3 Normal and tangential forces and dressing current during the ELID grinding 54 Figure 5.4 Normal and tangential grinding forces...

Ngày tải lên: 16/09/2015, 17:11

... HIGH- SPEED MILLING OF TITANIUM ALLOYS: MODELING AND OPTIMIZATION WANG ZHIGANG (B Eng, M Eng) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF MECHANICAL ENGINEERING ... milling of titanium alloys This chapter introduces an overview of high- speed machining of titanium alloys; then a brief overview of milling process modeling...

Ngày tải lên: 16/09/2015, 17:13