lubricants and hydraulic fluids Episode 1 pps

... Reducers 11 -4 11 -6Couplings 11 -5 11 -8Hoists and Cranes 11 -6 11 -9Wire Rope Lubrication 11 -7 11 -10 Chain Lubrication 11 -8 11 -14 Trashrake Systems and Traveling Water Screens 11 -9 11 -17 Gates and ... Interval 10 -4 10 -12 Chapter 11 Lubrication ApplicationsIntroduction 11 -1 11- 1Turbines, Generators, Governors, and Transformers 11 -2 11 -1 Main Pumps and Motors 11 -3 11 -5Gears, Gear Drives, and Speed ... Valves 11 -10 11 -17 Navigation Lock Gates, Culvert Valves, and Dam Gates 11 -11 11 -24Information Sources for Lubricants 11 -12 11 -26Chapter 12 Operation and Maintenance ConsiderationsIntroduction 12 -1...

lubricants and hydraulic fluids Episode 11 ppsx

... and 14 µm (c) 17 /15 /12 (c) 17 /15 /12 (c) ISO 4406-99 (ISO 11 1 71 Cal.) Appearance Clear & Bright Clear & Bright Visual Observation * At the conclusion of the 1, 000 hours test, ... EM 11 10-2 -14 24 31 Jul 06 Change 1 C-3 SPECIFICATION FOR TURBINE OIL TURBINE OIL TABLE OF CONTENTS 1. GENERAL 2. REFERENCES 3. SUBMITTALS 4. TURBINE OIL CHARACTERISTICS AND ... Rust Preventive Characteristics, Procedures “A” Pass Pass ASTM D 665 EM 11 10-2 -14 24 31 Jul 06 Change 1 C-8 and “B” Water Content, parts per million (ppm), maximum 250 250 ASTM D...

lubricants and hydraulic fluids Episode 3 docx

... usable temperature (EC)Maximum usable temperature (EF) 79 17 5 12 1350 93200 11 0230 13 5275 17 7350 17 7350 17 7350 17 7350 17 7350Water resistance Good toexcellentPoor tofairGood toexcellentExcellent ... (EF) 11 0230 16 3 -17 7325-350096 -10 4205-220 13 5 -14 3275-290 17 7-204350-400260+500+260+500+260+500+243470260+500+Maximum usable temperature (EC)Maximum usable temperature (EF) 79 17 5 12 1350 ... toexcellentAppearance Smooth and clearSmoothtofibrousSmooth and butterySmooth and butterySmooth and butterySmooth and butterySmooth and butterySmooth and butterySmooth and butterySmooth and butteryOther...

lubricants and hydraulic fluids Episode 4 ppt

... Champaign, IL 618 26-9005.EM 11 10-2 -14 2428 Feb 998 -1 Chapter 8Environmentally Acceptable Lubricants 8 -1. GeneralMineral-oil-based lubricating oils, greases, and hydraulic fluids are found ... productsEM 11 10-2 -14 2428 Feb 999 -1 Chapter 9 Gears9 -1. Generala. Energy is transmitted from a power source to a terminal point, through gears that change speeds,directions, and torque. Gear lubricants ... aspects directly related to and affected by lubrication, including wear,scuffing, and contact fatigue. Refer to ANSI/AGMA Standard 10 10-E95, and ASM Handbook Volume 18 , for photographs illustrating...

lubricants and hydraulic fluids Episode 5 docx

... wedges. There are many different configurations EM 11 10-2 -14 24 31 Jul 06 Change 1 11 -1 Chapter 11 Lubrication Applications 11 -1. Introduction This chapter discusses lubrication ... bearingsCalcium(conventional) 1, 2, and 350 Wet or dry 60 14 0 -10 14 14 0 cSt at 37.7 EC (10 0 EF)Calcium EP 1 and 2 50 Wet or dry 60 14 0 -5 25 14 .5 cSt at 98.8 EC( 210 EF)Sodium(conventional)3 75 /10 0 Dry 80 17 5 -30 ... MinimumEECEEFEECEEFLithiumLithium23 10 0 75 10 0 75Wet or dryWet or dry 10 0 13 5 10 0 13 5 210 275 210 275-25-25 -13 -13 Up to 14 0 cSt at 37.7 EC (10 0 EF)Multipurpose, not advised at max....

lubricants and hydraulic fluids Episode 6 doc

... on the factors and conditions noted above and operating experience.EM 11 10-2 -14 2428 Feb 99 11 -10 (2) SAE Recommended Practice J1707, “Service Maintenance of SAE J1703, Brake Fluids in MotorVehicle ... conditions in (1) above. For these conditions anNGLI No. 0 or No. 1 grease with a high-viscosity base oil (higher than 19 8 cSt at 40 EC (10 4 EF)) shouldbe used. EM 11 10-2 -14 2428 Feb 99 11 -15 lubricant ... should be above 15 8 EC ( 316 E F) for temperatureranges of -29 EC (-20 EF) to 66 EC (15 0 EF). It should not contain any grit, abrasive, or fillers. EM 11 10-2 -14 2428 Feb 99 11 -17 depends on operating...

lubricants and hydraulic fluids Episode 10 docx

... DTE 11 M Mobil DTE 11 M Mobil DTE 11 M 14 4.8 ( 210 0)EM 11 10-2 -14 2428 Feb 99B -10 Hydraulic Fluids Lock bar (psi) or Testing Pump Type of ChangeLock Gates Culvert Valves Dam Gates Hydraulic Fluids ... Multigrade SAE 15 W-40, 6 monthsEM 11 10-2 -14 2428 Feb 99B -1 Appendix BSurvey of Locks and Dams for Lubricants EM 11 10-2 -14 2428 Feb 99B-5Culvert Valves - Reverse Tainter and TainterLock and Range ... to 11 0) Duty GreaseEP NLGI 2EM 11 10-2 -14 2428 Feb 99A-8Firestone 19 97Firestone, C. M. May 19 97. Exclusive Guide to Synthetic Lubricants, Plant Engineering.Fisher 19 91 Fisher, J. May 19 91. ...

lubricants and hydraulic fluids Episode 2 Episode 2 pptx

... viscosity (EC)Density (g/ml) 0. 91 1. 01 1 .12 0.97 1. 06 1. 04 1. 02 1. 88Viscosity index 14 5 14 0 0 200 17 5 19 5 16 0 10 0-300Flash point (EC) 230 255 200 310 290 270 18 0Spontaneous ignition Low Medium ... between cSt and SUS viscosities atstandard temperatures can also be obtained from ASTM D 216 1.EM 11 10-2 -14 2428 Feb 994 -1 Chapter 4 Hydraulic Fluids 4 -1. Purpose of Hydraulic Fluids a. Power ... Very hightemperatureThermal conductivity 0 .15 0 .14 0 .13 0 .16 0 .15 0 .15 0 .15 (W/M EC)Thermal capacity (J/kg EC) 2,000 1, 700 1, 600 1, 550 1, 550 1, 550 2,000Bulk modulus Medium Medium Medium...

lubricants and hydraulic fluids Episode 2 Episode 3 potx

lubricants and hydraulic fluids Episode 2 Episode 5 doc

... bearingsCalcium(conventional) 1, 2, and 350 Wet or dry 60 14 0 -10 14 14 0 cSt at 37.7 EC (10 0 EF)Calcium EP 1 and 2 50 Wet or dry 60 14 0 -5 25 14 .5 cSt at 98.8 EC( 210 EF)Sodium(conventional)3 75 /10 0 Dry 80 17 5 -30 ... MinimumEECEEFEECEEFLithiumLithium23 10 0 75 10 0 75Wet or dryWet or dry 10 0 13 5 10 0 13 5 210 275 210 275-25-25 -13 -13 Up to 14 0 cSt at 37.7 EC (10 0 EF)Multipurpose, not advised at max. ... satisfactory performance and long life.(Reference: Neale, M. J., Lubrication: A Tribology Handbook. Butterworth-Heinemann Ltd, Oxford, England)EM 11 10-2 -14 2428 Feb 99 10 -11 Table 10 -8Correction Factors...

Xem thêm