Animation the mechanics of motion
Animation the mechanics of motion
... drawings – will determine the speed of youranimation. Remember, the greater the distance between the drawings, the quicker the action; the closer togetherthey are, the slower the timing will be.K51666-Ch01.qxd ... straight-aheadanimation the animator makes the first drawing, or sets theposition of the model for the first frame of animation, andthen goes on...
Ngày tải lên: 13/09/2012, 14:19
Tài liệu ON THE MECHANICS OF ECONOMIC DEVELOPMENT* pptx
... productivity. The body of theory that does this is called the theory of 'human capital', and I am going to draw extensively on this theory in the remainder of these lectures. For the moment, however, ... contrast to the model of section 2) has not been fully analyzed in the literature. The text gives a self-contained derivation of the main features of bal...
Ngày tải lên: 20/02/2014, 20:20
Inside the Structure of Defined Contribution/401(k) Plan Fees: A Study Assessing the Mechanics of the ‘All-In’ Fee pot
... representative of the universe results using the experience of the survey respondents, there is the question of whether to report results on a plan, participant, or asset basis. The answer to ... as compared with the universe. In the case of this Study, the share of large plans in the sample is higher than the share of large plans in the 401(k) universe....
Ngày tải lên: 07/03/2014, 13:20
Adhesion science and engineering volume 2, the mechanics of adhesion surfaces, chemistry applicat
... be caused by the interdiffusion or interdigitation of the materials, or they may be simply the result of structuring of the adhesive layer adjacent to the interface due to the asymmetric ... adhesion’. Because of the rather short-range nature of molecular interactions, they occur principally between the outermost molecular layers of the adherend and the mol...
Ngày tải lên: 26/04/2014, 15:36
Motion Control Theory Needed in the Implementation of Practical Robotic Systems
... to the disk, the controlling input r = radius of the disk l = length to the center of mass of the pendulum m = mass of the pendulum g = acceleration due to gravity A simulation of the ... control the angle of the pendulum to upright. During the tuning of both controllers the authors became experts on the behavior of the system and made observ...
Ngày tải lên: 05/11/2013, 21:15