Process Engineering Equipment Handbook 2009 Part 6 pps
Process Engineering Equipment Handbook 2009 Part 6 pps
...
To obtain
value in Ø
rad/s 1 0.01745 6. 283 0.1047
rad/s
2
degree/s 57.30 1 360 6. 00
degree/s
2
rev/s 0.1592 0.00278 1 0.0 167
rev/s
2
rev/min 9.549 0. 166 7 60 1
rev/min/s
Ø
C-252 Condensers
FIG.
C-283 ... very expensive retrofit
engineering or reengineering, especially if major failures or production-loss events
have occurred, without any warning provided by the existing system. Pro...
Process Engineering Equipment Handbook 2009 Part 1 ppsx
... Claire.
Process engineering equipment handbook / Claire Soares.
p. cm.
Includes index.
ISBN 0-07-05 961 4-X (acid-free paper)
1. Chemical plants Equipment and supplies. I. Title.
TP157.S658 2002
66 0¢.283—dc21 ... Distillation/Fractional Distillation
Armstrong Engineering Associates: P.O. Box 566 M, West Chester, PA 19381-
0 566 USA
Cogeneration
Alstom: Finspong 61 282 Sweden
Com...
Process Engineering Equipment Handbook 2009 Part 20 ppt
... E -66
insulation pillows and, E -65 to E -66
mounting flanges and, E -63 to E -64
noise vs., E -66 to E -67
outer cover of, E -60
pantograph control mechanism and, E -63
proximity of building to, E -64 ... P-275 to P-2 76
axial piston, P- 260 to P- 264
capacity of, P- 267 to P- 268
casings for, P-2 76
classification of, P- 260 to P- 265
design details of, P-274 to P-277
displacement...
Process Engineering Equipment Handbook 2009 Part 2 pdf
... will give a long life, and they
look good as well. A typical system is shown in Figs. A -64 and A -65 .
A -62 Air Filtration; Air Inlet Filtration for Gas Turbines
FIG. A-49 Drain valve. (Source: ... Filsorption II process) is used for separation
of submicron particles, heavy metals, and toxic hydrocarbons by a combination of
filtering, “sorption,” and chemical reaction.
The Wetpac
®
process...
Process Engineering Equipment Handbook 2009 Part 3 doc
... 20.0 — — —
Aluminum oxide (Al
2
O
3
), max, % — 6. 0 — — —
Ferric oxide (Fe
2
O
3
), max, % — 6. 0 — 6. 5 —
Magnesium oxide (MgO), max, % 6. 0 6. 0 6. 0 6. 0 6. 0
Sulfur trioxide (SO
3
),
B
max, %
When (C
3
A)
C
is ... High (precalciner, 20–50% 120– 160 250–400 None CO, THC may
preheater and 180–220 66 0–940 increase
long kilns
SNCR Medium (precalciner 40–70% 61 0–1,250 1,220–1 ,69...
Process Engineering Equipment Handbook 2009 Part 4 pdf
... cylinders.
The process data for this compressor are:
Gas CH
4
(98%) + N
2
(2%)
Suction 1st 1.0 36 bar -1 06 to - 160 °C
Discharge 1st 2.9 bar - 36 to -97°C
Suction 2nd 2.9 bar -33 to -93°C
Discharge 2nd 6. 8 ... LNG at barometric pressure boils off at - 160 °C.
This temperature is well below the limit where some of the common engineering
Compressors C-121
FIG. C-1 06 The labyrinth pi...
Process Engineering Equipment Handbook 2009 Part 5 potx
... 3,700 4,000 5,700* 6, 600* 7,300* 8,100* 9,000*
D 1,840 2,250 2,040 2,140 3,200 3,350 3,800 4,500 5,000
E 500 560 560 63 0 63 0 63 0 63 0 710 710
a 800 900 1,000 1,100 1,200 1,400 1 ,60 0 1,800 2,000
b ... 80
G
2
1.1 1.4 1 .6 2.0 2.3 2.5 3.2 4.5 6. 3
G
3
25 33 40 50 69 85 120 165 230
G
4
36 48 53 66 100 120 155 205 270
mr
2
18 27 45 85 150 280 500 880 1,570
Q 4 passes 325 325 430 5...
Process Engineering Equipment Handbook 2009 Part 7 pdf
... is
essentially little used in the field as it is hard to fit in a process plant. It works
well in test rigs.
Items 1 and 2 handle about 60 percent more flow than orifice plates.
3. Orifice plates. Orifice ... 19 86.
4. Lifson et al., “Assessment of Gas Turbine Vibration Monitoring,” ASME-GT-204.
5. Floyd, “Key Issues and Technology for Future Programs,” Proceedings Fifteenth Annual SFTE
Confer...
Process Engineering Equipment Handbook 2009 Part 8 pot
... pressure at 26 C (mmHg) 46
3. Density (lb/gal at 26 C) 6. 5
4. Viscosity (cps) at 30°C 3.3
5. Surface tension (dynes/cm) at 25°C 19 .6
6. Refractive index at 25°C 1.38
7. Solubility parameter at 26 C
Hansen ... Air Conditioners
FIG.
C-4 36 These twin high-efficiency scroll compressors are part of a small commercially
available cooling system used to chill milk. (Source: Mechanical Engin...
Process Engineering Equipment Handbook 2009 Part 10 pdf
... efficiency: 100 percent for particles of 8 microns and larger, 99
percent for particles of 6 to 8 microns, 90 percent for particles of 4 to 6 microns,
and 85 percent for particles of 2 to 4 microns. ... for particles 3 microns and
larger, and 99.98 percent for particles less than 3 microns.
Solids removal efficiency: 100 percent for particles of 3 microns and larger, and 99.5
percent for pa...
Từ khóa:
- bài giảng công nghệ sản xuất bánh kẹo part 6 ppsx
- thiết kế bài giảng lịch sử 7 part 6 ppsx
- giáo trình mỹ thuật trang phục part 6 pps
- động cơ máy bay part 6 ppsx
- thiết kế bài giảng sinh học 11 nâng cao tập 2 part 6 pps
- thiết kế bài giảng sinh học 11 nâng cao tập 1 part 6 pps
- 15 actual toeic listening tests book part 6 ppsx
- sổ tay tiếng anh kỹ thuật part 6 pps
- giáo trình thí nghiệm công nghệ thực phẩm part 6 ppsx