Handbook of Corrosion Engineering Episode 1 Part 10 pps

Handbook of Corrosion Engineering Episode 1 Part 10 pps

Handbook of Corrosion Engineering Episode 1 Part 10 pps

... 318 Name ACHILLES ACORD ADVICE AURORA-STACOR AUSCOR BENTEN BLEACH BLEACHER BWR CHEM*COR CL2 CORRCON CORREAU CORRES CORSER CRAI DESAD DIASCC ECHOS FERPRED GENERAL JUNIPER KISS MATGEO OILSTO PBCORR PC6493 PETRO-COR1 POURBAIX PRIME REFMAIN SECOND SSCP-PH1 WELDPLAN WELDSEL WELDSYM DPsPdMPlTrEPNP‡ B§ A¶ * * * * * * * * 10 200 * * 1 140 ** 327 *** ***5 94 * * * * 10 10 0 ***3 * * * 1 10...

Ngày tải lên: 05/08/2014, 09:20

32 370 0
Handbook of Corrosion Engineering Episode 1 Part 10 ppt

Handbook of Corrosion Engineering Episode 1 Part 10 ppt

... 314 Name ACHILLES ACORD ADVICE AURORA-STACOR AUSCOR BENTEN BLEACH BLEACHER BWR CHEM*COR CL2 CORRCON CORREAU CORRES CORSER CRAI DESAD DIASCC ECHOS FERPRED GENERAL JUNIPER KISS MATGEO OILSTO PBCORR PC6493 PETRO-COR1 POURBAIX PRIME REFMAIN SECOND SSCP-PH1 WELDPLAN WELDSEL WELDSYM DPsPdMPlTrEPNP‡ B§ A¶ * * * * * * * * 10 200 * * 1 140 ** 327 *** ***5 94 * * * * 10 10 0 ***3 * * * 1 10...

Ngày tải lên: 05/08/2014, 09:20

32 564 0
Handbook of Corrosion Engineering Episode 1 Part 8 pps

Handbook of Corrosion Engineering Episode 1 Part 8 pps

... the formation of a surface alloy High-Temperature Corrosion 243 0. 01 0 .1 1 10 10 0 0.0 01 0. 01 0 .1 1 Penetration (mm) Carbon steel Nickel Alloy 617 S 310 00 S30400 Alloy 800 H S 410 00 9Cr 1 Mo PO 2 ... Three 0.0 0.5 1. 0 1. 5 2.0 2.5 3.0 3.5 4.0 260 310 360 10 0 ppm H 2 S 10 ppm H 2 S 1 ppm H 2 S 410 460 510 Penetration (mm) Temperature (°C) Figure 3 .19 E...

Ngày tải lên: 05/08/2014, 09:20

40 313 0
Handbook of Corrosion Engineering Episode 1 Part 11 pps

Handbook of Corrosion Engineering Episode 1 Part 11 pps

... weld is recommended. 380 076 516 2_Ch06_Roberge 9 /1/ 99 5: 01 Page 380 modes of corrosion. 15 In this context, a corrosion mode was to be defined by the morphology of corrosion damage, as shown for ... as a function of time. 076 516 2_Ch06_Roberge 9 /1/ 99 5: 01 Page 388 3 71 Corrosion Maintenance through Inspection and Monitoring 6 .1 Introduction 372 6.2 Inspection 374 6...

Ngày tải lên: 05/08/2014, 09:20

33 281 0
Handbook of Corrosion Engineering Episode 1 Part 14 pps

Handbook of Corrosion Engineering Episode 1 Part 14 pps

... 4.6 Ϫ0 .1 1.7 2.8 5.7 7.0 6.3 3.5 3.5 4.6 0 .1 1.8 2.9 6.0 7.0 6.3 3.5 3.5 4.7 0.2 2.0 3 .1 6.0 7 .1 6.7 3.7 3.8 4.8 0.4 2 .1 3.4 6 .1 7.2 6.8 3.8 3.9 4.9 0.5 2.5 3.4 6.2 7.3 6.9 5 .1 4.3 5.0 1. 1 2.9 ... apparatus. 076 516 2_Ch07_Roberge 9 /1/ 99 5: 41 Page 5 01 485 Acceleration and Amplification of Corrosion Damage 7 .1 Introduction 486 7.2 Corrosion Testing 488 7.2 .1 Co...

Ngày tải lên: 05/08/2014, 09:20

34 282 0
Handbook of Corrosion Engineering Episode 1 Part 14 ppsx

Handbook of Corrosion Engineering Episode 1 Part 14 ppsx

... Amplification of Corrosion Damage 489 076 516 2_Ch07_Roberge 9 /1/ 99 5: 41 Page 489 References 1. Moreland, P. J., and Hines, J. G., Hydrocarbon Processing, 17 (1) :1 31 (19 78). 2. Timmins, P. F., Predictive Corrosion ... CANMET, 19 92, pp. 17 -1 17 -7. 34. Agarwala, V. S., “Chemical Sensors for Integrity of Coatings,” Tri-Service Conference on Corrosion, 19 92, pp. 315 –325...

Ngày tải lên: 05/08/2014, 09:20

34 439 0
Handbook of Corrosion Engineering Episode 2 Part 10 pps

Handbook of Corrosion Engineering Episode 2 Part 10 pps

... concentration, M NaCl, M Unprotected Protected 0.5 10 Ϫ5 360 0.64 0.5 10 Ϫ3 74 1. 1 0.5 10 1 81 5 .1 510 Ϫ5 49,000 0. 41 510 Ϫ3 29,000 1. 0 510 1 2,000 5.3 TABLE 12 .2 Current Requirements for Anodic Protection Current ... 0.5 M 5 M 10 0 10 0 23 ϩ0.36 ϩ0.47 91 0.95 3.9 ϩ0.06 ϩ0 .14 77 0 .11 0.82 ϩ0.07 ϩ0.08 49 0.020 0.20 ϩ0.03 ϩ0.06 27 0. 012 0.0 41 ϩ0.02 ϩ0....

Ngày tải lên: 05/08/2014, 09:20

33 301 0
Handbook of Corrosion Engineering Episode 1 Part 1 pptx

Handbook of Corrosion Engineering Episode 1 Part 1 pptx

... xi Introduction 1 1 .1 The Cost of Corrosion 1 1.2 Examples of Catastrophic Corrosion Damage 3 1. 3 The Influence of People 5 References 12 Chapter 1. Aqueous Corrosion 13 1. 1 Introduction 13 1. 2 Applications ... Economics 10 01 C .1 Introduction 10 01 C.2 Cash Flows and Capital Budgeting Techniques 10 02 C.3 Generalized Equation for Straight Line Depreciat...

Ngày tải lên: 05/08/2014, 09:20

31 304 0
Handbook of Corrosion Engineering Episode 1 Part 1 ppt

Handbook of Corrosion Engineering Episode 1 Part 1 ppt

... Economics 10 01 C .1 Introduction 10 01 C.2 Cash Flows and Capital Budgeting Techniques 10 02 C.3 Generalized Equation for Straight Line Depreciation 10 04 C.4 Examples 10 06 C.5 Summary 10 09 References 10 09 Appendix ... Compositions of Engineering Alloys 10 61 Appendix F. Thermodynamic Data and E-pH Diagrams 11 01 Appendix G. Densities and Melting Points of Meta...

Ngày tải lên: 05/08/2014, 09:20

31 336 0
Handbook of Corrosion Engineering Episode 1 Part 2 docx

Handbook of Corrosion Engineering Episode 1 Part 2 docx

... 0 9.06 18 .08 27 .11 36 .11 Temperature, °C ppm 0 14 .58 13 .70 12 .78 11 .89 11 .00 5 12 .79 12 .02 11 .24 10 .49 9.74 10 11 .32 10 .66 10 . 01 9.37 8.72 15 10 .16 9.67 9.02 8.46 7.92 20 9 .19 8.70 8. 21 7.77 ... potential is E ϭ E eq ϩ b log 10 (I) Ϫ b log 10 (I 0 ) and the applied current can then be written as log 10 (I) ϭϩlog 10 (I o ) ϭϩlog 10 (I 0...

Ngày tải lên: 05/08/2014, 09:20

36 387 0
w