Electric Circuits, 9th Edition P41 potx

... resistor-capacitor (RC) circuits, 220-224,231-236,246, 472-473 resistor-inductor (RL) circuits, 214-220,231-236,246 resistor-inductor-capacitor (RLC) circuits, 266-279 series RLC circuits, 285-289 ... (RL) circuits, 212,214-220,224-228, 236-238,246 resistor-inductor-capacitor (RLC) circuits, 264-305, 473^175 second-order circuits, 264-305 sequential switching, 236-240,...

Ngày tải lên: 06/07/2014, 16:20

... Perspective Electrical Safety At the beginning of this chapter, we said that current through the body can cause injury. Let's examine this aspect of electrical safety. You might think that electrical ... level is not the sole RSPECWE determinant of potential injury due to electrical shock, consider the case of a static electricity shock mentioned in the Practical Perspective at t...

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

... After introducing the techniques for analyzing the natural and step responses of first-order circuits, we discuss some special cases of interest. The first is that of sequential switching, ... that is, we have a natural-response problem. RL and RC circuits are also known as first-order circuits, because their voltages and currents are described by first-order differential equation...

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

... of this example, it is important to point out that safety analysis is an essential part of an electrical engineer's work. Now that we have modeled the controls for the hair dryer, let's ... Recall from Chapter 4 that certain systems—for example, those that trans- mit information via electric signals—depend on being able to transfer a maximum amount of power from the source to

Ngày tải lên: 06/07/2014, 16:20

... Distribution of Electric Power In this chapter we introduce circuits that are designed to handle large blocks of electric power. These are the circuits that are used to transport electric power ... considering only balanced circuits. The analysis of unbalanced three-phase circuits, which you will encounter if you study electric power in later courses, relies heav- ily on an u...

Ngày tải lên: 06/07/2014, 16:20

... M Practical Perspective Transient Effects As we learned in Chapter 9, power delivered from electrical wall outlets in the U.S. can be modeled as a sinusoidal volt- age or current source,

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20

... for a) = 0; Fig. 14.28(c) presents the equivalent circuit for to = 00. In both equivalent circuits, the output voltage is defined over an effective open circuit, and thus the output and

Ngày tải lên: 06/07/2014, 16:20

... specifications. 558 Active Filter Circuits Up to this point, we have considered only passive filter circuits, that is, filter circuits consisting of resistors, inductors, and capaci- tors. There ... Component scale factors • 15,2 Scaling In the design and analysis of both passive and active filter circuits, working with element values such as 1 ft, 1 H, and 1 F is convenient. Alt...

Ngày tải lên: 06/07/2014, 16:20

Ngày tải lên: 06/07/2014, 16:20