Routing Protocols and Concepts – Chapter 11 potx
... Cisco Public Use the command Router #clear ip ospf process This command does not work in PT. OSPF (Single Area OSPF) Routing Protocols and Concepts – Chapter 11 © 2007 Cisco Systems, Inc. ... v4.0 Chapter 1 1 Verifying OSPF Verifying OSPF Show ip protocols – OSPF p rocess ID , p, –the router ID, –networks the router is advertising, – the default ad...
Ngày tải lên: 05/07/2014, 03:20
... chapter/ curriculum. Book: Routing Protocols and Concepts By Rick Graziani and Allan Johnson ISBN: 1-58713-206-0 ISBN-13: 978-58713- 206-3 42 Verifying OSPF Excellent command to begin troubleshooting. ... network Command The network command (same function as when used with other IGP routing protocols) : Any interfaces on a router that match the network address i...
Ngày tải lên: 09/03/2014, 13:20
... RIPv2 Enabling and Verifying RIPv2 Auto-Summary and RIPv2 Disabling Auto-Summary in RIPv2 Verifying RIPv2 Updates VLSM and CIDR RIPv2 and VLSM RIPv2 and CIDR Verifying and Troubleshooting ... following features and limitations: Use of hold-down and other timers to help prevent routing loops Use of split horizon and split horizon with poison reverse to...
Ngày tải lên: 09/03/2014, 13:20
Routing Protocols and Concepts – Chapter 1 potx
... router and the features within the IOS. – Typically the more features in the IOS, the larger the IOS image, and therefore, the more flash and RAM that is required to store and load ... bootstrap p ro g ram. pg –ROM is a form of permanent storage. Cisco devices use ROM to store: –The bootstrap instructions –Basic diagnostic software – Scaled - down version of IOS...
Ngày tải lên: 05/07/2014, 03:20
Tài liệu Routing Protocols and Concepts: Chapter 6 pot
... s0/0/0 VLSM VLSM in Action VLSM and IP Addresses Chapter 6 VLSM and CIDR Routing Protocols and Concepts 17 Classless Routing Protocol Classless routing protocols include the subnet mask with ... hundreds or thousands of hosts. 14 CIDR and Route Summarization Recall from Chapter 2, “Static Routing, ” that you can create one static route for multiple network...
Ngày tải lên: 23/02/2014, 09:20
Tài liệu Routing Protocols and Concepts: Chapter 10 ppt
... link. Implementing Link-State Routing Advantages of a Link-State Routing Protocol Requirements of a Link-State Routing Protocol Comparison of Link-State Routing Protocol Note: Chapter 11 discusses the ... routing issues within an area. Multi-area OSPF and IS-IS are discussed further in CCNP. Link-State Routing Link-State Routing Protocols Introduction to the...
Ngày tải lên: 23/02/2014, 09:20
Routing Protocols and Concepts: Chapter 2 pot
... command is used to display the routing table. l Initially, the routing table is empty if no interfaces have been configured. l Note: Static routes and dynamic routes cannot be added to the routing ... Added to the Routing Table l The debug ip routing displays routing table processes for any route, Ÿ directly connected network Ÿ static route Ÿ dynamic route. l Disable debug ip...
Ngày tải lên: 09/03/2014, 13:20
Routing Protocols and Concepts: Chapter 4 pptx
... Exchange of Routing Information Routing Table Maintenance Periodic Updates Bounded Updates Triggered Updates Random Jitter Routing Loops Defining a Routing Loop Implications of Routing ... receivesreceives 33 Routing Table Maintenance Routing protocols must maintain the routing tables so that they have the most current routing information. How? Dep...
Ngày tải lên: 09/03/2014, 13:20
Routing Protocols and Concepts: Chapter 5 doc
... Classful Routing Protocol Background and Perspective RIPv1 Characteristics and Message Format RIP Operation Basic RIPv1 Configuration RIPv1 Scenario A Enable RIP: router rip Command ... http://www.ietf.org/rfc/rfc1058.txt RIPv1: A Distance Vector, Classful Routing Protocol Background and Perspective RIPv1 Characteristics and Message Format RIP Operation 5 Ba...
Ngày tải lên: 09/03/2014, 13:20
Routing Protocols and Concepts: Chapter 8 doc
... destination IP address of a packet and a route in the routing table, a minimum number of leftmost bits must match between the IP address of the packet and the route in the routing table. The subnet ... parent route 9 Sample Routing Table Entries The routing table hierarchy in Cisco IOS software was originally implemented with the classful routing scheme. Although the r...
Ngày tải lên: 18/03/2014, 14:20