noise in receiving systems

Water and energy sustainable management in irrigation systems network

Water and energy sustainable management in irrigation systems network

... decision makers in evaluating water policies and developing sustainable water resource management plans. WEAP operates following the basic principles of water balance accounting and links water supplies ... stored in reservoir zone j involves an increase in the target function given by Eq. 4, which, since k j are negative by default, in fact mean a decrease in the target functi...

Ngày tải lên: 05/09/2013, 14:58

28 519 0
Security Issues in Wireless Systems

Security Issues in Wireless Systems

... was developed in response to the increasing use of mobile computers in order to enable computers to maintain Internet connection during their movement from one Internet access point to another. ... encrypted messages being exchanged. Such information could be useful to the attacker as it can reveal useful information in guessing the nature of the information being exchanged [2,3]. In...

Ngày tải lên: 29/09/2013, 21:20

14 368 0
Technologies in Information Systems

Technologies in Information Systems

... learning and two learning ows. At individual level, the intuiting process takes place. At group level, the interpreting and integrating processes are developed. Finally, the institutionalizing ... to sites targeted at China and Chinese-speaking audiences, including user and consumer behavior patterns, categorizing China using Hofstede’s cultural dimensions, examining traditional and hi...

Ngày tải lên: 18/10/2013, 17:15

351 319 1
Mitigation Techniques To Reduce Alien Crosstalk Noise In 10GBE Channels Using UTP Cabling

Mitigation Techniques To Reduce Alien Crosstalk Noise In 10GBE Channels Using UTP Cabling

... Mitigation 060625 Mitigation Techniques To Reduce Alien Crosstalk Noise In 10GBE Channels Using UTP Cabling These mitigation techniques are good installation practices that will benefit both Class E and ... applications by applying where possible a combination of some of the following; At the Floor Distributor Remove cable ties from bundles in the telecommunication room racks, cabinets...

Ngày tải lên: 27/10/2013, 17:15

2 284 0
Tài liệu ADC KRONE - Guide - Mitigation Techniques To Reduce Alien Crosstalk Noise In 10GBE Channels ppt

Tài liệu ADC KRONE - Guide - Mitigation Techniques To Reduce Alien Crosstalk Noise In 10GBE Channels ppt

... between socket mounting holes (that the socket clips into). General Consider doing several mitigation techniques together (e.g. removing fasteners, unbundling and applying Random Lay, plus changing patch ... the entire length. Separating only at the beginning of the channel improves the ANEXT, but it does not improve AACR-F. Replace the existing Category 6 cabling with CopperTen cabling. At t...

Ngày tải lên: 20/12/2013, 22:15

2 328 0
Advanced topics in control systems theory II

Advanced topics in control systems theory II

... considered independently.Inthis sense it canbeconsideredasanonlinearcounterpart of the well-known separation principleu sed in linear systems. In ter estingly ,t his res ult canb ea pplied to systemsthatare ... ), is ob viously ex po nen tiallyd eca ying. Holdingthis simpleviewpoint, it is natural to wonder whetherasimilar reasoningwould hold to inferstabilityand convergence properties o...

Ngày tải lên: 01/01/2014, 18:39

294 398 1
TransienTs in electrical systems

TransienTs in electrical systems

... page intentionally left blank Electrical power systems are highly nonlinear and dynamic in nature: circuit breakers are closing and opening, faults are being cleared, generation is varying in ... natural response, Y 2 (s) is the term involving factors of q(s), and Y 3 (s) is the term involving partial fraction expan- sion of the terms involving d(s). Taking inverse Laplace transform...

Ngày tải lên: 02/01/2014, 10:44

737 486 9
Tài liệu Digital Modulation in Communications Systems – An Introduction doc

Tài liệu Digital Modulation in Communications Systems – An Introduction doc

... determining I and Q values for each symbol (“slicing”) 5. decoding and de-interleaving 6. expansion to original bit stream 7. digital-to-analog conversion, if required In more and more systems, ... 2. Trends in the Industry The polar diagram shows several symbols at a time. That is, it shows the instantaneous value of the carrier at any point on the continuous line between and includin...

Ngày tải lên: 26/01/2014, 04:20

48 598 0
w