daewoo matiz 2000-2013 engine cooling - hệ thống làm mát động cơ trên xe matiz đời 2000-2013

... Outlet Hose 20 Hose Bracket 1D–6 ENGINE COOLING DAEWOO M-150 BL2 RADIATOR/FAN D12D4021 1 Radiator Assembly 2 Electric Cooling Fan Assembly ENGINE COOLING 1D–7 DAEWOO M-150 BL2 DIAGNOSTIC INFORMATION ... the instru- ment panel temperature indicator. The coolant tempera- ture sensor is located on the distributor case with the ECT sensor on an SOHC engine. ENGINE COOLING 1D–5...

Ngày tải lên: 28/05/2014, 13:08

... EM-22 ) 4. INSTALL TIMING BELT (See page EM-22 ) 5. FILL WITH ENGINE COOLANT 6. START ENGINE AND CHECK FOR ENGINE COOLANT LEAKS 7. RECHECK ENGINE COOLANT LEVEL CO0IO-06 -COOLING COOLANT CO-1 1762Author: ... water pump. 2. INSPECT TIMING BELT COMPONENTS (See page EM-20 ) CO0IT-01 B04463 Connect New O-Ring B03030 Seal Width 2 - 3 mm New O-Ring CO-8 -COOLING WATER PUMP 1769Autho...

Ngày tải lên: 24/05/2014, 15:25

... Support No.2 Cooling Fan Connector No.2 Cooling Fan Cooler Condenser RH Engine Under Cover NO.2 COOLING FAN x 6 CO−20 COOLING ELECTRIC COOLING FAN 1996 RAV4 (RM447U) CO18L−01 S01356 (A) S01433 COOLING ... Radiator Support LH Engine Under Cover NO.1 COOLING FAN COOLING ELECTRIC COOLING FAN CO−19 1996 RAV4 (RM447U) COMPONENTS CO0BD−01 COOLING COOLANT CO−1 1996 RAV4 (RM44...

Ngày tải lên: 24/05/2014, 16:24

Ngày tải lên: 26/05/2014, 15:28

... k (D) A128140E02 CO–2 2AZ-FE COOLING – COOLING FAN SYSTEM CO ENGINE2 AZ-FE COOLING COOLING FAN SYSTEM PARTS LOCATION COOLING FAN MOTOR -COOLING FAN RELAY ENGINE ROOM RELAY BLOCK -CDS FAN FUSE -RDI FAN FUSE INSTRUMENT ... Condition 3 - 5 10 Ω or higher 3 - 5 Below 1 Ω (when battery voltage is applied to terminals 1 and 2) 2AZ-FE COOLING – RADIATOR CO–17 CO ENGINE2 AZ-F...

Ngày tải lên: 23/05/2014, 16:27

... includ- ing engine oil and engine coolant. • Bleed air from passages in lines and hoses, such as in cooling system. • After cooling down engine, again check oil/fluid levels, including engine ... includ- ing engine oil and engine coolant. • Bleed air from passages in lines and hoses, such as in cooling system. • After cooling down engine, again check oil/fluid levels, incl...

Ngày tải lên: 12/04/2014, 16:04

... pliers A (SST). SLC932 SLC917A SLC904-A SLC896 CO-1 ENGINE COOLING SYSTEM B ENGINE CONTENTS C D E F G H I J K L M SECTION CO A CO Revision; 2004 April 2003 FX ENGINE COOLING SYSTEM VQ35DE PRECAUTIONS ... 8.6 ( 9-1 /8 US qt, 7-5 /8 lmp qt) SMA182B Reservoir tank engine coolant capacity (at “MAX” level) : 0.8 (7/8 US qt, 3/4 lmp qt) Air relief plug: : 1.19 N·m (0.12 kg-m, 10 ft...

Ngày tải lên: 13/04/2014, 16:26

... NSm (71–106 lb-in). ENGINE EXHAUST 1G–7 DAEWOO M-150 BL2 D12G504B 3. Install the front exhaust pipe to pup-up catalytic con- vertor. Tighten Tighten the bolts to 25–35 NSm (18–25 lb-ft). D102G502 FRONT ... muffler-to-rear muffler nuts. Tighten Tighten the nuts to 25–35 NSm (18–25 lb-ft). 3. Install the exhaust pipe-to-front muffler nuts. Tighten Tighten the nuts to 25–35 NSm (18–25 lb-f...

Ngày tải lên: 28/05/2014, 13:09

Ngày tải lên: 02/03/2013, 16:56

... 2- Xilanh; 3- Piston, 4- Nắp xilanh; 5- Đường nước ra két; 6- Nắp két, 7- Két nước; 8- Không khí làm mát; 9- Quạt gió; 1 0- Đường nước đi vào làm mát động cơ. - Nguyên lý làm việc: Khi động làm ... SÁT HỆ THỐNG LÀM MÁT ĐỘNG CƠ KIA-HA ” Trong phạm vi đồ án này, em chỉ giới hạn tìm hiểu một cách tổng quát về các phương pháp làm mát trong độn...

Ngày tải lên: 27/04/2013, 10:39