Camry Repair Manual ENGINE MECHANICAL

... spacer Measured mm (in.) No. backlash EM–14 ENGINE MECHANICAL (5S–FE) BALANCE SHAFT BACKLASH 1186AuthorĂ: DateĂ: EM083–03 S05284 Engine Moving Control Rod No.2 RH Engine Mounting Bracket Generator Drive ... torque * 1 Gasket * 1 Replace only if damaged EM–16 ENGINE MECHANICAL (5S–FE) TIMING BELT 1188AuthorĂ: DateĂ: EM084–04 S05609 S05249 S05296 S05597 ENGINE MECHANICAL (5S–F...

Ngày tải lên: 28/04/2014, 13:24

... glass. AC0LL–02 Z19146 1MZ–FE engine: No. 1 Engine Coolant Temperature (ECT) Switch Compressor Engine Room Junction Block No. 2 z Engine Main Relay (Marking: ENGINE MAIN) z No. 1 Cooling Fan Relay (Marking: FAN NO.1) Engine ... Relay (Marking: FAN NO.3) 5S–FE engine models: Engine Coolant Temperature (ECT) Switch Receiver Pressure Switch Condenser Fan z Fan Motor 1MZ–FE engin...

Ngày tải lên: 28/04/2014, 12:52

... STEERING GEAR HOUSING TO REAR ENGINE MOUNTING BRACKET BY CORD OR EQUIVALENT 31. ATTACH ENGINE SLING DEVICE TO ENGINE HANG- ERS CAUTION: Do not attempt to hang the engine by hooking the chain to any ... ft·lbf) 15. REMOVE TRANSAXLE–TO ENGINE BOLT Torque: 66 N·m (670 kgf·cm, 48 ft·lbf) 16. REMOVE ENGINE HOOD (a) Disconnect the washer pipe. (b) Remove the 4 bolts and engine hood. To...

Ngày tải lên: 28/04/2014, 12:53

... use with a transversely–mounted engine. AX0EP–02 INTRODUCTION HOW TO USE THIS MANUAL IN–1 HOW TO USE THIS MANUAL To assist you in finding your way through the manual, the Section Title and major ... should be prepared before beginning the operation and explains the purpose of each one. REPAIR PROCEDURES Most repair operations begin with an overview illustration. It identifies the c...

Ngày tải lên: 28/04/2014, 13:01

... lock manual switch OFF or UNLOCK No continuity A16 – Ground Door lock manual switch LOCK Continuity A17 – Ground Door lock manual switch OFF or LOCK No continuity A17 – Ground Door lock manual ... Door lock manual switch OFF or UNLOCK No continuity A1 – Ground Door lock manual switch LOCK Continuity A2 – Ground Door lock manual switch OFF or LOCK No continuity A2 – Ground Door l...

Ngày tải lên: 28/04/2014, 13:03

... lock manual switch OFF or UNLOCK No continuity A16 – Ground Door lock manual switch LOCK Continuity A17 – Ground Door lock manual switch OFF or LOCK No continuity A17 – Ground Door lock manual ... Door lock manual switch OFF or UNLOCK No continuity A1 – Ground Door lock manual switch LOCK Continuity A2 – Ground Door lock manual switch OFF or LOCK No continuity A2 – Ground Door l...

Ngày tải lên: 28/04/2014, 13:07

... the caliper. 4. 5S–FE engine: REMOVE 2 ANTI–SQUEAL SPRINGS 5. REMOVE 2 BRAKE PADS 6. REMOVE 4 ANTI–SQUEAL SHIMS 7. 1MZ–FE engine: REMOVE PAD WEAR INDICATOR PLATE 8. 1MZ–FE engine: REMOVE 2 PAD ... kgf·cm, 25 ft·lbf) 4. 5S–FE engine: REMOVE 2 ANTI–SQUEAL SPRINGS 5. REMOVE 2 BRAKE PADS WITH ANTI–SQUEAL SHIMS 6. 1MZ–FE engine: REMOVE 2 PAD SUPPORT PLATES 7. 5S–FE engine: REMOVE 4 PAD...

Ngày tải lên: 28/04/2014, 13:08

... belt which has been used less than 5 minutes on a running engine. z ”Used belt” refers to a belt which has been used on a run- ning engine for 5 minutes or more. z After installing a belt, check ... that there is no abnormal noise from the generator while the engine is running. 7. CHECK DISCHARGE WARNING LIGHT CIRCUIT (a) Warm up the engine and then turn it off. (b) Turn off all acces...

Ngày tải lên: 28/04/2014, 13:08

... part in order. If necessary, replace these parts. Symptom Suspect Area See page 1. Engine mounting (Loosen) – 1 . Engine mounting (Loosen) 2. Clutch disc ( Runout is excessive ) – CL–17 2 . ... specified, using SST, adjust the dia- phragm spring tip alignment. SST 09333–00013 Q10091 1MZ–FE Engine: 5S–FE Engine: CL–22 –CLUTCH CLUTCH UNIT 1801AuthorĂ: DateĂ: 3. APPLY MOLYBDENUM DISU...

Ngày tải lên: 28/04/2014, 13:08

... w/ Oil Cooler: INSTALL OIL FILTER (See page LU–2) 4. FILL WITH ENGINE COOLANT 5. START ENGINE AND CHECK FOR COOLANT LEAKS 6. CHECK ENGINE OIL LEVEL CO06G–03 CO–14 –COOLING (5S–FE) RADIATOR 1588AuthorĂ: ... DateĂ: COOLANT INSPECTION HINT: Check the coolant level when the engine is cold. 1. CHECK ENGINE COOLANT LEVEL AT RADIATOR RESERVOIR The engine coolant level should be between t...

Ngày tải lên: 28/04/2014, 13:10