Dynamic Mechanical Analysis (DMA) doc

... damping. FREQUENTLY ASKED QUESTIONS Dynamic Mechanical Analysis (DMA) A Beginner’s Guide This booklet provides an introduction to the concepts of Dynamic Mechanical Analysis (DMA). It is written for ... the test. DMA is also called DMTA for Dynamic Mechanical Thermal Analysis. Q How does DMA differ from Thermomechanical Analysis? A Thermomechanical Analysis,...

Ngày tải lên: 31/03/2014, 23:20

... g ’s except the 0 hour of post-cure T g were undetectable by DSC. DYNAMIC MECHANICAL ANALYSIS Kevin P. Menard CRC Press Boca Raton London New York Washington, ... curves vs. time. (We will come back to FIGURE 6.6 Analysis of a cure. The DMA cure profile of a two-part epoxy showing the typical analysis for minimum viscosity, gel time, vitrific...

Ngày tải lên: 28/10/2013, 00:15

... both directions WHY - WHY ANALYSIS TRAINING ☯ OBJECTIVES: ☯ To understand the definition of Why - Why Analysis. ☯ To clarify the procedure for developing a Why - Why Analysis. ☯ To stress the ... observable facts or events WHY - WHY ANALYSIS ☯ REVIEW VS. OBJECTIVES: ☯ Understand the definition of Analysis ☯ Clarify the procedure for developing a Why - Why Analysis. ☯ Stress the i...

Ngày tải lên: 12/12/2013, 00:15

Ngày tải lên: 13/12/2013, 03:15

... between ICA and factor analysis, in which the nongaussianity of the data is not taken into account. In fact, ICA could be considered as nongaussian factor analysis, since in factor analysis, we are ... the other components. In fact, in factor analysis it is often claimed that the factors are independent, but this is only partly true, because factor analysis assumes that the data has a...

Ngày tải lên: 13/12/2013, 14:15

Ngày tải lên: 26/12/2013, 01:18

Ngày tải lên: 26/12/2013, 01:18

Ngày tải lên: 26/12/2013, 01:18

Ngày tải lên: 26/12/2013, 01:18

... is planned dynamically and is always up-to- date. All the information that the system needs to know such as “where is the goal (the dock),” “what is the required final orientation (the docking angle),” ... errors. Especially at high speed and high dynamic loading operating conditions, the serial-link manipulators show poor dynamic performance. To improve the dynamic performance and achie...

Ngày tải lên: 19/01/2014, 17:20