Tài liệu Power Electronic Handbook P1 ppt

... LLC I Power Electronic Devices 1 Power Electronics Kaushik Rajashekara, Sohail Anwar, Vrej Barkhordarian, Alex Q. Huang Overview • Diodes • Schottky Diodes • Thyristors • Power Bipolar ... CRC Press LLC 1.5 Power Bipolar Junction Transistors Sohail Anwar Power bipolar junction transistors (BJTs) play a vital role in power circuits. Like most other power devices, p...

Ngày tải lên: 25/01/2014, 13:20

... PCU output power. When the PCU output power reaches a maximum level, the input resistance is fixed at the value that produces this level. Presumably when output power is a maximum, input power is ... maximum power from the array. This is done by incorporating maximum power- tracking circuitry into the PCU. Figure 18.4 shows the I – V characteristics of an array with the max...

Ngày tải lên: 13/12/2013, 00:15

... displacement power factor yields the total power factor, 0.75 in this case. Thus, the incandescent lamp, a resistive load, appears to the power system as a 0.75 power factor lagging load. Low power ... it is possible to achieve a power factor greater than 0.99 and a THD less Power factor Average power Apparent power 1 T v s t()i s t() 0 T ∫ V rms I rms == Power factor...

Ngày tải lên: 13/12/2013, 00:15

... 5th European Conference on Power Electronics and Applications, Brighton, U.K., 1993, 134. 8. Seki, N. and Uchino, H., Converter configurations and switching frequency for a GTO reactive power compensator, ... high- power voltage source inverters, IEEE Trans. Power Electron., 7, 189, 1992. © 2002 by CRC Press LLC 25. Corzine, K. A., Delisle, D. E., Borraccini, J. P., and Baker, J. R., M...

Ngày tải lên: 25/01/2014, 13:20

... larger power applications, typically above 1.5 kW, it is advisable to use a higher power supply. In some applications, two of the three phases of a three-phase power system are used as the source powering the ... CRC Press LLC 3. AC power systems can be interconnected employing a DC tie without reference to system frequen- cies, short circuit power, etc. 4. High-speed control of DC...

Ngày tải lên: 25/01/2014, 13:20

... three-phase bridge (Fig. 3.3) converters. The cycloconverter is usually used for three-phase, high -power, low-speed synchronous motor drives and rarely employed for induction motor drives. 3.3

Ngày tải lên: 25/01/2014, 13:20

... Semiconductor Power Converter Conference, 1977. 2. Owen, H. A., Capel, A., and Ferrante, J. G., Simulation and analysis methods for sampled power electronic systems, in IEEE Power Electronics Specialists ... that the input power is equal to the output power, as with ideal transformer analysis. FIGURE 2.20 Basic boost converter. (From Mohan, N., Undeland, T. M., and Robbins, W. P.,...

Ngày tải lên: 25/01/2014, 13:20

... resistors. Introduction to Sensor Electronics The electronics that go along with the physical sensor element are often very impor- tant to the overall device. The sensor electronics can limit the performance, ... signal, sensors tend to be char- acterized in the same way as electronic devices. The data sheets for many sensors are formatted just like electronic product data sheets. How...

Ngày tải lên: 12/12/2013, 23:15

... for power electronics systems. Obviously, advances in raw processing power for personal computers as well as the rapid devel- opment of electronic design software have influenced the field of power ... the simulation of power electronics systems proved to be difficult from the outset, because power electronics circuits typically operate in a highly discontinuous mode, with power se...

Ngày tải lên: 13/12/2013, 00:15

... (1791–1867) experimented with magnetic fields. He wound two coils on an iron ring. When one coil was powered from a battery, he noticed that a transient voltage developed on the second coil and, later,

Ngày tải lên: 13/12/2013, 00:15