word 2010 macro update table of contents

Ngày tải lên: 27/06/2014, 23:20

... methods of exploration, such as SPT, CPT, etc. to establish stratification of the subsurface materials, the profile of the top of bedrock and bedrock quality, depth to groundwater, limits of types of ... be unsuitable for field verification of nominal axial resistance of soft silts or clays where a large amount of setup is anticipated and it is not feasible to obtain dynamic measurement of pile ... right of way restrictions, proximity of adjacent structures, and schedule constraints  Identify areas of geologic concern on the site and potential variability of local geology  Identify areas of...

Ngày tải lên: 06/09/2012, 15:57

... lower portion of the shaft. The value of is often considered to vary as a function of S u . Values of for drilled shafts are recommended as shown in Equations 2 and 3, based on the results of back-analyzed, ... bottom of the base or over the depth of penetration of the drilled shaft in the founding stratum. The value of N u may be assumed to vary linearly from 0.0 at D b /D p = 0.75 to a value of 8.0 ... distance of 1.5B above the top of the weaker layer to the base resistance of the weaker layer at the top of the weaker layer. C10.8.3.5.3 The distance of 1.5B represents the zone of influence for general...

Ngày tải lên: 29/09/2013, 12:20

... types of cement for various types of sulfate exposure. For prestressed concrete, ACI 318 recommends a maximum water-soluble chloride ion of 0.06 percent by weight of cement. Cathodic protection of ... RESISTANCE OF PILE GROUPS IN COMPRESSION For pile groups in clay, the nominal axial resistance of the pile group shall be taken as the lesser of:  The sum of the individual nominal resistances of each ... shear strength of clays (KSF) n h = rate of increase of soil modulus with depth for sands as specified in Table 10.4.6.3-2 (KSI/FT) 10.7.4 Extreme Event Limit State The provisions of Article 10.5.5.3...

Ngày tải lên: 29/09/2013, 12:20

... the zone of overbreak or fracturing. Evaluation of seepage forces and hydraulic gradients should be performed as part of the design of foundations that will extend below the groundwater table. ... bottom of the footing to 1.5B below the bottom of the footing. B = footing width (FT) C wq , C w = correction factors to account for the location of the ground water table as specified in Table ... for timing of closure pours as a function of settlement, simple support of spans and/or periodic jacking of bearing supports. Where laboratory test results are expressed in terms of void ratio,...

Ngày tải lên: 29/09/2013, 12:20

... methods of exploration, such as SPT, CPT, etc. to establish stratification of the subsurface materials, the profile of the top of bedrock and bedrock quality, depth to groundwater, limits of types of ... (KSI) n h = rate of increase of soil modulus with depth as defined in Table C2 (KSI/FT) z = depth in feet below the ground surface (FT) Table C10.4.6.3-2 – Rate of increase of Soil Modulus with ... subsurface conditions observed, the intent of Table 1 regarding the minimum level of exploration needed should be carried out. The depth of borings indicated in Table 1 performed before or during design...

Ngày tải lên: 29/09/2013, 12:20

... [NWAN96] __________ Tilburg University, Tilburg, The Netherlands, the 9 th of July 1996 1 Intelligent Software Agents on the Internet Table of Contents ... Intelligent Software Agents on the Internet: an inventory of currently offered functionality in the information society & a prediction of (near-)future developments by ... Hermans __________ "[ ] Agents are here to stay, not least because of their diversity, their wide range of applicability and the broad spectrum of companies investing in them. As we move further and further...

Ngày tải lên: 05/10/2013, 13:20

... German TM TABLE OF CONTENTS Field 17: German PART 1: G ENERAL I NFORMATION A BOUT THE AEPA AND T EST P REPARATION A N O VERVIEW OF THE AEPA 1-1 Test Development Process Characteristics of the ... adequacy of the information presented, including the number of ideas, the development of ideas, and the depth and specificity of supporting details ã COHERENCE: the organization and clarity of the ... understanding of the main idea or details in a spoken passage, a telephone message, a public address announcement, a sequence of steps described in a set of oral directions, a stated cause or effect of...

Ngày tải lên: 22/10/2013, 12:15

... Cycling: Corning SMF-28 0.900 mm 1.0 Log2N (where N = number of channels) 0.5 dB maximum (see table below) (see table below) < -55 dB 55 dB (see table below) .45 kg (1.0 lb.) maximum for .250 mm and ... of the frame the FCB is to be mounted on Adapter/Connector Type Specific adapter/connector type required in the FCB Pigtail Type Type of pigtail required Number of Pigtail Assemblies Number of ... the left side of the frame) or a “right” orientation (mounts on the right side of the frame). The cable exit direction will be either “upward” (cables terminated to the rear side of the block...

Ngày tải lên: 10/12/2013, 17:15

... vi Table of Contents Completing File and Directory Names 62 Changing Your Password 62 Customizing Your Account 63 4. File Management 66 File...

Ngày tải lên: 11/12/2013, 03:15

... Table of contents Managementhandbook 01 - chapter 01 Page 1 of 2 Table of contents Nr. Designation Pages 01. Table of contents 1 02. Modifications 3 03. Declaration of ... Pages 01. Table of contents 1 02. Modifications 3 03. Declaration of liability 3 04. Administration of the manual 1 05. Company portrait 1 06. Introduction 1 07. QE-Politics, continuous improvement...

Ngày tải lên: 12/12/2013, 00:15

... COMPLETE TABLE OF CONTENTS AND GLOSSARY Lesson 11: Passwords 11.0 Introduction 11.1 Types of Passwords 11.1.1 Strings of Characters 11.1.2 Strings of Characters plus a token 11.1.3 Biometric Passwords ... security organization in the UK. 9 COMPLETE TABLE OF CONTENTS AND GLOSSARY COMPLETE TABLE OF CONTENTS AND GLOSSARY social engineering – The act of obtaining or attempting to obtain otherwise ... Biometric Passwords 11.2 History of Passwords 11.3 Build a Strong Password 11.4 Password Encryption 11.5 Password Cracking (Password Recovery) 11.6 Protection from Password Cracking Lesson 12: Legalities...

Ngày tải lên: 15/12/2013, 14:15

... tray with chip 5. Select number of cable clamps (0-9) 6. Select number of compression fittings (0-9) 7. Select number of bonding grounding kits (0-9) 8. Select number of radius limiters (0-9). Not ... connector on back of bulkhead) ST đ Hybrid (ST đ connector on front; SC connector on back of bulkhead) Multimode 9 D 5 Y Singlemode 2 L F 7 N J E 4 P K X 1 3 Connector Style Number of Ports Loaded Number ... Minneapolis, Minnesota USA 55440-1101 Specifications published here are current as of the date of publication of this document. Because we are continuously improving our products, ADC reserves...

Ngày tải lên: 17/01/2014, 10:20

... Editor of the IEEE Transactions on Neural Networks. Andrew Kusiak is a Professor of Industrial Engineering at the University of Iowa, Iowa City. His interests include applications of ... University of Calgary Canada Nallan C. Suresh State University of New York at Buffalo U.S.A. University of Groningen The Netherlands Wai Sum Tang The Chinese University of Hong Kong China ... affiliated with a number of major professional societies such as IEEE, ASME, SME, IIE, and their counterparts in Europe, Asia, and the rest of the world. The book is a source of new information for...

Ngày tải lên: 23/01/2014, 01:20

... Accountability Office (I) Office of Management and Budget (1) Office of the Chief Financial Officer Director, Planning and Accountability Division (1) Japan Export Investigation Report For Official ... 2005: GOJ conducted audits of 11 U.S. plants. AMS audited all of these establishments in advance of GOJ officials visit in order for them to observe actual production of product for Japan (as ... processed and distributed in Japan”. A final assessment of equivalency of the terms of the EV program would be the basis of Japan’s lifting of its ban on U.S. beef. August 8, 2005: USG assessed...

Ngày tải lên: 06/03/2014, 23:20

Ngày tải lên: 15/03/2014, 07:20

Ngày tải lên: 15/03/2014, 14:20

Ngày tải lên: 17/03/2014, 04:20

Ngày tải lên: 19/06/2014, 08:20