using the tree for classification

... the FDR The Board also approved the FDR protocol, which includes the history, the aim, the definitions, and the variables of the FDR Any given change will be listed in the protocol Ahead of the ... were the proximal femur (40%), the distal forearm (22%) and the ankle (16%) Secondary procedures for the long bone fractures were most often recorded for fractures in the ankle (27%) and in the ... total of 40% of the primary treatments and 38% of the secondary treatments For the primary treatments the median age among the children was years for girls and 10 years for boys The most frequently...

Ngày tải lên: 13/08/2014, 23:20

... modes When the MODE pin is low, the MCP2120 is in command mode, when the MODE pin is high, the MCP2120 is in data mode The MODE pin is sampled during the start bit Changing the state of the MODE ... garbage ; The PICDEM board should be reset with the MCLR button before ; doing the demo ; This demo starts with the MCP2120 and the host (this code) ; at 9.6KB When the RA1 button is pressed the MCP2120 ... latched when the device is reset, either from the RESET pin or a power-on reset After a device reset, changing the value of the BAUD2:BAUD0 pins has no effect on the device’s baud rate The MCP2120...

Ngày tải lên: 11/01/2016, 11:38

... problem-free solution The major pitfalls are: Active termination is recommended to overcome the pitfalls of passive termination The recommended configuration that complies with the SCSI requirements ... states quickly The resistor divider results in a characteristic impedance of 132Ω, which results in reflections due to the mismatch with the 110Ω cable Unlike passive termination, the 1100Ω termination ... signal quality Thermal shutdown and current limiting are integrated in the TC1264 to prevent system damage from an over-temperature or short circuit condition The TC1264 is available in either DDPAK-3,...

Ngày tải lên: 11/01/2016, 11:40

... Since the GaAs PA must be able to efficiently meet these industry standard power requirements, the RF losses in the duplexer must also be considered in the design of the PA GaAs has become the ... Assuming the output is loaded to at least 20% of the maximum available current, the power efficiency of the inductorless boost/ buck regulator can be estimated as the absolute value of the regulated ... ripple waveform is superimposed on the nominal –5.0VDC and has a fundamental frequency of 200KHz “PA_BIAS_ENABLE” is the power control signal for the regulated negative bias generator from the subscriber...

Ngày tải lên: 11/01/2016, 14:26

... importance of the linkage types The goal is at the top of the model 4.4.2 The Actors Like the AHP model formulated for overall linkage judgment, the second level in the hierarchy model for individual ... to the others For example, the flow from University to Industry and vice versa Therefore, these flows become the main factor in the individual model and are considered as the third level The ... structural The former is the familiar contextual dependence of elements on other elements in performing their function, whereas the later is the dependence of the priority of elements on the priority...

Ngày tải lên: 23/04/2013, 10:29

... attributes of the element Listing 16.1 shows an example SELECT statement that retrieves the top three rows from the Customers table The results of the SELECT are returned as XML using the FOR XML ... 'ALFKI' The Tag column specifies the numeric position of the row in the XML hierarchy The Parent column identifies the parent, which is in the previous SELECT statement; that's because this row is the ... 2002) Using the ELEMENTS Option You use the ELEMENTS option to indicate that the column values are returned as subelements of the row; otherwise the column values are returned as attributes of the...

Ngày tải lên: 14/12/2013, 22:15

... the language games are not well chosen, therefore they are either too challenging with high required level of the target language or too easy with the language unsuitable for the content of the ... Design of the study The study consists of parts: Introduction, Development, and Conclusion Part I is the Introduction In this part, the reasons, the aims and the objectives, the scope, the methods, ... including the participants themselves, their collective experiences, the physical environment and the purpose for speaking 1.1.1.2 The nature of speaking Speaking involves language production and is therefore...

Ngày tải lên: 19/12/2013, 15:47

... he/she focuses on the problem or issue (facts) instead of on the coachee or the other people involved c) Asks enough questions to understand/clarify the situation d) Clarifies the boundaries and ... respect for coachees by providing helpful suggestions and advice that allows them to a better job and by acknowledging their contributions and abilities II THE ABILITY TO HANDLE CONFLICT (i.e., using ... EXAMPLES OF ACTUAL BEHAVIOR I THE ABILITY TO DEVELOP EFFECTIVE 1:1 RELATIONSHIPS (i.e Build Trust) a) Takes the time to know coachees personally; their interests, their family, their values b) Is always...

Ngày tải lên: 18/01/2014, 15:20

... of the text as they can recall, they generally 17 remember some bits of the text and forget others By and large, they can not fulfill the tasks if they focus on linguistic items rather than the ... This helps them take the information or whatever they have produced in the previous stage, and other meaningful activities There are two common forms that post-listening tasks can take They are ... reactions to the content of the text, and analysis of the linguistic features Therefore, the students can use language naturally in target situations Also, they acquire more deeply the language...

Ngày tải lên: 05/02/2014, 22:02

... of the coordinators Other information was gathered from the web page of the organization We used standard approaches to statistical analysis of data including frequencies and percentages for the ... focused on the reasons for the use of quality schemes and pointed out the advantages of their implementation in improving services [24,55,56] On the other hand, Ritchie and Dale suggest the existence ... but they also take part in the service process, influencing both the process’s performance and the perception of quality of the service produced [90] One of the most commonly used techniques for...

Ngày tải lên: 14/02/2014, 06:20

... the root of the given sub -tree as presented in Fig Therefore the ker- nel function can be simplified to only capture the sub-structure rooted at the root of the sub -tree ∆ , , where and are the ... a tree pair , , the baseline approach first takes all the links between the sub -tree pairs as alignment hypotheses, i.e., the Cartesian product of the two sub -tree sets: ,…, ,…, ,…, ,…, By using ... | Root directed Subset Tree Monolingual Tree kernels achieve decent performance using the SSTs due to the rich exploration of syntactic information However, the sub -tree alignment task requires...

Ngày tải lên: 20/02/2014, 04:20

... calculated using the kappa statistic that was first proposed by (Cohen, 1960) This measure calculates and removes from the agreement rate the amount of agreement expected by chance Therefore, the results ... inconsistent, but nonetheless are useful for producing tentative conclusions To determine why the annotators were having difficulty agreeing, we calculated the kappa score for each category For the “N”, “C” ... automaton depends on two values: the threshold α of the MDI algorithm and the amount of label sequences used for learning The closer α is to 0, the more general the inferred automaton becomes 35...

Ngày tải lên: 20/02/2014, 12:20

... errors, and the other is the corresponding correct string (the former string is referred to as the ErrorPart, and the latter as the Correct-Part respectively) These parts are extracted from the speech ... similar to the string including errors from the StringDatabase (the former string is referred to as the Similar-String, and the latter as the Error-String) Finally, the correction is made using the ... position of the error-block, the procedure branches in the following way If P1 is less than T (T=4), then go to the step for a top If a value L - P2 + T is less than T, then go to the step for a tail...

Ngày tải lên: 20/02/2014, 18:20

... followed their own customs and traditions in using the forest and land as they had done since the time of their ancestors The National Forest Meeting in 1989 raised the importance of the forest for the ... and Forest Classification for planting trees and conservation of the forest 1994, the Forestry Law 1996, the Land Law 1997, the amended Land Law 2003, and the Decree on the implementation of the ... increase the number of trees It was strictly forbidden to sell forest land which has been allocated by the state However it was possible for the state to change the objective for the use of the forest...

Ngày tải lên: 21/02/2014, 04:20

... Centre for Medium-Range Weather Forecasts (ECWMF) The conversion function which has been used to adjust climate change scenarios is the product of MAGICC/SCENGEN The conversion functions formed ... software need more consideration In the study, the temperature and rainfall scenarios are built in the monthly form of decades of the 21st century However, within the scope of this paper, we only ... (Table 1) have been tested for the statistic reliability through: + Assumption testing the magnitude of the correlation coefficient Rxy + Assumption testing the magnitude of the coefficient of regression...

Ngày tải lên: 05/03/2014, 16:20

... ViewState The Model aspect refers to the data source of the application, which for our purposes will be a SQL database The Controller is the brain of the operation, fetching the appropriate information ... pretty penny Why even bother reinventing the wheel when so many off -the- shelf solutions exist? The crux of the issue hinges on two points: • First, the organization for which the system described ... polyglot expert before tackling those sections I Caution I am using the Team System edition of Visual Studio 2010 for the writing of this book because there are components to the IDE that are...

Ngày tải lên: 15/03/2014, 07:20

... chloride (99.9%) and further milled for 12 hours before washing the additives with distilled water The slurry was dried in oven at 60-80oC before calcination at 250oC for 150 A reference sample, ... reduction Therefore, a close distance between cobalt and copper site affects the ability of the metals to the disproportionation of CO This is a prerequisite for higher alcohol synthesis catalyst ... for the synthesis of higher alcohols from syngas as a distance of a metallic copper atom from a cobalt site is within atomic Consequently, the requirement for the perovskite precursor is therefore...

Ngày tải lên: 22/03/2014, 09:20

... first report of the clinical use of the Lung Flute in diagnosis of TB The device may represent a new technology for sputum induction for the diagnosis of pulmonary TB The Lung Flute for sputum induction ... saline inhalation for the diagnosis of TB In summary, use of the Lung Flute may be a promising technique for the rapid diagnosis of pulmonary TB The diagnostic yield using the Lung Flute needs ... through the Lung Flute and to repeat the manoeuvre for a total of 20 sets of two blows each Printed instructions were handed to the patients, and they were directly supervised in the use of the device...

Ngày tải lên: 29/03/2014, 03:20

... from the library item A onto each of the views We gave the UIButton on the left the label Play, and the UIButton on the right the label Back To make the Play button navigate to the view on the ... us to navigate from one view to the other The first step is to add the buttons, and then to configure the navigation Figure 1–7 shows these views being wired up for navigation Figure 1–7 Storyboard ... game for the iPhone or iPad It is the goal of this book to educate the reader on the many facets of building a game The topics range from the mundane tasks of organizing your start screen to the...

Ngày tải lên: 24/04/2014, 10:13

... you scroll down the output box until the numbers in column 'y' (the output) start to correspond with the numbers in column 'd' (the desired output), then the values shown in the output box under ... not, then you could worse than to buy Phil Picton's book Using the code OK, very briefly, I set up an SDI using inheritance from CFormView On the dialog, I added a number of text boxes for the ... this function takes the data from the edit boxes and handles the iteration process, passing the data for each of the four input patterns to the a a i e d l n function in turn The weights are adjusted...

Ngày tải lên: 28/04/2014, 10:10