using the pen tool and placing images

... A and B, equation (10) can be written by equation (11): (11) PA and PB are the partial vapor pressures of the components A and B XA, XB are the mole fraction of the component A and B So, XA and ... of the substances, which is called the solvent, and may itself be a mixture, is treated differently than the other substances, which are called solutes If the sum of the mole fractions of the ... interact within the organic phase Solid solutes tend not to mix with other ones and they behave independently each other In this case, mixture’s solubility of solids is frequently the sum of the solubility...

Ngày tải lên: 03/11/2015, 14:21

... another of the thousands of IRC channels.) IRC ops, on the other January 2002 13:14 126 Chapter 6: Using the Internet and Other Networks hand, are technical people in charge of the servers themselves; ... happening on the server and the channel; the bottom part (a single line) is where you type commands and text In between the two parts is a status line with the time of day, your nick, and other information ... Chapter 6: Using the Internet and Other Networks Following are four sample ssh and rsh command lines (You may need to substitute rlogin for rsh.) The first pair show the way to log in to the remote...

Ngày tải lên: 17/01/2014, 16:20

... responsible for the conception of the study, analyzing the data, and writing the article RC contributed to analyzing the data and the interpretation of the results RS contributed to analyzing and collecting ... Bland-Altman plots were created to compare the agreement among the three EQ-5D scores (Figures 2A–C) These plots showed the differences between scores (Yaxis) and the means of scores (X-axis) The ... mean of the differences (d) and the limits of agreement were indicated by dotted lines The 95% limits of agreement were obtained by using the following formula [20]: d ± 1.96*SD of d The Bland-Altman...

Ngày tải lên: 18/06/2014, 19:20

... into the following components: the Start condition and control byte, the word address, and the data byte and Stop condition Note that, due to the size of the 24LC256, two bytes are used for the ... except that the PEN bit (I2C1CONbits .PEN) is used for the Stop condition Figure shows the transmission of the data byte, as well as the Stop condition indicating the end of the operation The right ... some of the specific details of the I2C protocol The focus is to provide the designer with a strong understanding of communication with the 24XXX series serial EEPROMs using the I2C1 module and I2C,...

Ngày tải lên: 11/01/2016, 16:38

... 'current' Furthermore, only the PTSD and depression sections of the K-SADS-PL were administered The screen interview and diagnostic supplement format is unique to the K-SADS-PL and greatly facilitates ... endorsed on both the K-SADS and the CATS (recurrent thoughts/ images of event and efforts to avoid thoughts of the event) are also among the symptoms most frequently reported in other studies [11,12], ... automatically placing a cap on the level of agreement General Implications of Findings The K-SADS and CATS yield different information about the level and type of trauma exposure, therefore researchers and...

Ngày tải lên: 08/08/2014, 21:20

... and atmospheric condition The samples were taken then acidified and analyzed for residual arsenic concentration A mixture of 70% As[III] and 30% As[V] was used in all of the experiments and the ... in the values of the regression coefficient r2 Therefore, adsorption process of arsenic onto LA and AC-Fe may be described by Langmuir isotherm and the adsorption capacities were 0.48mg/g and ... for LA and AC-Fe are 0.48mg/g and 1.18mg/g, respectively) However, it is also possible to realize that the longer the portion of AC-Fe, the higher the adsorbent cost Therefore, optimizing the AC-Fe...

Ngày tải lên: 05/09/2013, 09:38

... ports, and timers externally to make them functional Make the system bulkier and much more expensive Have the advantage of versatility on the amount of RAM, ROM, and I/O ports Microcontroller The ... from memory In general, the more and bigger the registers, the better the CPU Registers can be 8-, 16-, 32-, or 64-bit The disadvantage of more and bigger registers is the increased cost of such ... recognized by the CPU, it must be assigned an address The address assigned to a given device must be unique The CPU puts the address on the address bus, and the decoding circuitry finds the device...

Ngày tải lên: 04/10/2013, 19:10

... it, and then use the Tools ® Attach to Process menu option to choose the program you want to debug If the program has debugging symbols (generated by the -g option) and the debugger can find them, ... summarizes the members of the fsi value 309 7575Ch12.qxp 310 4/27/07 1:07 PM Page 310 CHAPTER 12 I THE F# TOOL SUITE AND NET PROGRAMMING TOOLS Table 12-12 The Properties of the F# Interactive Command’s ... program execution and quitting the compiler, that just aren’t relevant to the command-line compiler Table 12-11 describes the fsi.exe commands Table 12-11 The F# Interactive Commands Command Description...

Ngày tải lên: 05/10/2013, 10:20

... wouldn’t be the end of the world if the receipt wasn’t dispensed Apply the rule to the other Use Cases, and you’ll find that really, none of them describe the goal of the user The goal of the user ... part of the consortium, including Hewlett-Packard, Microsoft and Oracle The UML was adopted by the OMG2 in 1997, and since then the OMG have owned and maintained the language Therefore, the UML ... and Design using the UML Chapter An Overview of the UML Before we begin to look at the theory of the UML, we are going to take a very brief run through some of the major concepts of the UML The...

Ngày tải lên: 10/12/2013, 14:16

... piston The product of the piston velocity and the post-yield plastic damping coefficient The product of the piston position and the factor that accounts for the accumulator stiffness and the MR ... mi is the mass of the ith floor, ¨ B is the ground acceleration and qi is the ith restoring force, including viscous damping The quantities ui are the relative displacement of the ith and the i ... function of time, then the value of the force at the instant time t will depend not only on the value of the displacement x at the time t, but also on the past values of x The following simplifying...

Ngày tải lên: 12/12/2013, 22:41

... the observations=inputs and the parameter values The M-step involves system identification using the state estimates from the smoother Therefore, at the heart of the EM learning procedure is the ... outputs, and the conditional distributions over the hidden states For the model we have described, the parameters define the nonlinearities f and g, and the noise covariances Q and R (as well as the ... by picking randomly the values of the nodes that have no parents It then picks randomly the values of their children Stationarity means here that neither f nor the covariance of the noise process...

Ngày tải lên: 23/12/2013, 07:16

... configuration, issue the clear ip bgp * command on ISP1A Wait several seconds, and then use the show ip bgp command to view ISP1A’s BGP table Both paths should again be present in the table, but the best ... Configure BGP for normal operation Enter the appropriate BGP commands so that SanJose3 advertises its Ethernet network and the other routers advertise the 10.0.0.0 network: ISP1A(config)#router ... always-compare-med Issue the clear ip bgp * command on SanJose3, wait several seconds, and then check SanJose3’s BGP table with the command show ip bgp SanJose3 should have two paths to the 10.0.0.0 network,...

Ngày tải lên: 18/01/2014, 05:20

... providing helpful suggestions and advice that allows them to a better job and by acknowledging their contributions and abilities II THE ABILITY TO HANDLE CONFLICT (i.e., using Principle Based Decision ... focuses on the problem or issue (facts) instead of on the coachee or the other people involved c) Asks enough questions to understand/clarify the situation d) Clarifies the boundaries and principles ... V1 THE ABILITY TO PROVIDE EFFECTIVE AND BALANCED FEEDBACK TO OTHERS a) Provides timely and frequent feedback to coachees and the feedback is balanced to reinforce strengths and contributions and...

Ngày tải lên: 18/01/2014, 15:20

... see the final HTML for the DataGrid control The lines of code that you will need to add are the ones for OnUpdateCommand, OnCancelCommand, OnEditCommand, and OnDeleteCommand By entering these ... about the record; it had only been added to the data table and not sent back to the server You can see the data being updated back to the server for the add and edit in the next step One other ... to handle the exception that occurs when you try to write the value to the column When you're writing the cells into the columns of the data row, the Trim function is used Because of using the...

Ngày tải lên: 21/01/2014, 12:20

... to the current column name chosen in cboSortColumns If the two are the same, then the column name is assigned to the Sort property with the DESC keyword added on If not, then the name of the ... from the ComboBox The current setting of the Sort property is compared to the column name that is chosen If the Name matches, then the expression DESC is added to the value that is assigned to the ... assigned to the Sort property Steps Open and run the VB.NET-Chapter solution From the main form, click on the command button with the caption How-To 3.4 When the form loads, click on different...

Ngày tải lên: 21/01/2014, 12:20

... Note: Make sure that the screensaver and any other programs that automatically start are temporarily disabled or they can interrupt the defragmenting process Troubleshooting If Scandisk reports a ... resolve the problem There is an option to convert recovered data to a text file However, this will clutter the drive with many text files of garbled information Select the option to discard the information ... information Select the option to discard the information and continue Reflection List any other utilities that come with Windows that can help in the preventative maintenance of a system: ...

Ngày tải lên: 24/01/2014, 19:20

... forget others By and large, they can not fulfill the tasks if they focus on linguistic items rather than the message or the information The top-down view of listening is the use of inside the head ... person These facts result in ineffective and theoretical outcome which is backward and no longer meet the demand of the development, the integration and globalization of our country in the modern ... guest speakers, and current events to teach the lessons The role of the teacher was to monitor the students and give advice or ideas so that they may draw conclusions and solutions independently or...

Ngày tải lên: 05/02/2014, 22:02

... through the center of the sample and reference sensors of the DSC cell Thermal isolation was maintained by using beryllium metal foil to seal the X-ray optical path identification and understanding ... between the first and second scan may have contributed to the small shift in the onset temperature The endotherm was not observed during the third scan, because the sample melted at 210 °C during the ... detector (PSD) The incident beam was collimated using a 1° divergent slit The active area on the PSD subtended approximately 5° 2θ The source was operated at 35 kV and 30 mA, and the samples were...

Ngày tải lên: 14/02/2014, 03:20

... with the tool With the tip of the tool, lift and roll back the clay to form the lips Hold the head with your thumb and forefingers, and press gently to form the depression behind the eye at the ... side of the nose at the bridge The bottom line of the slide is the jowl line, and the top is the upper cheek, just below the edge of the eye socket (the bottom of the "bag") Depending on the individual, ... line from the corner of the mouth to the nostril Lay the tool flat along the line and press gently towards the back of the head to form the jowl line Repeat for the other side Formation of the jowl...

Ngày tải lên: 07/03/2014, 02:20