television receiver

A low power high dynamic range broadband variable gain amplifier for an ultra wideband receiver

A low power high dynamic range broadband variable gain amplifier for an ultra wideband receiver

... the receiver. A Multi-Band Orthogonal-Frequency-Division-Multiplexing (MB-OFDM) based Ultra-Wideband (UWB) receiver system is widely adapted in the industry. The analog baseband of the receiver ... (VGA) is needed in many baseband circuits for communication applications. For example, in a RF receiver, it is required to use a VGA between the filter and the analog to digital converter (ADC), ... power consumption. In addition, due to the characteristics of the OFDM communication system, the receiver s group delay variation within the band of interest should be reduced as much as possible....

Ngày tải lên: 06/11/2012, 10:26

121 386 0
56 Digital Television

56 Digital Television

... 1988. [7] Hopkins, R., Advanced televisions systems, IEEE Trans. Consumer Electronics, 34(1), 1-15, Feb. 1988. [8] UnitedStates Advanced Television Systems Committee, Digital Television Standard for ... Committee on Advanced Television Services (ACATS) was formed in 1987 to advise Federal Communications Commission (FCC) on the facts and circumstances regarding advanced television systems for ... Video ATM AdaptationLayerfor Digital Video ã Cell Loss Protection References 56.1 Introduction Digital television is being widely adopted for various applications ranging from high-end applica- tions,...

Ngày tải lên: 18/10/2013, 04:15

16 282 0
LECTURE 16 8250 UART : UNIVERSAL ASYNCHRONOUS RECEIVER TRANSMITTER

LECTURE 16 8250 UART : UNIVERSAL ASYNCHRONOUS RECEIVER TRANSMITTER

... Telecommunications, Winter 2000 Lecture_16 UART UART or Universal Asynchronous Receiver Transmitter: UART or Universal Asynchronous Receiver Transmitter is an integrated circuit used in PC serial ports ... Introduction to Telecommunications, Winter 2000 Lecture_16 UART 8250 UART : UNIVERSAL ASYNCHRONOUS RECEIVER TRANSMITTER Serial communications is sufficiently complex that special chips have been ... the strings of bits that comprise serial data. Such a chip is called a universal asynchronous receiver transmitter or UART. Without UARTs, communications programming would be very complicated....

Ngày tải lên: 26/10/2013, 20:15

9 367 2
Digital Television Applications P1

Digital Television Applications P1

... A moving receiver cannot receive analogue television signals [2] however, with digital television moving receivers (i.e. located in cars, buses, trams, trains and even hand-held television ... digital television receives high quality signals as binary coded data at the receiver with little loss of information. Digital television produces sharper images than traditional analogue television ... Digital Television …………………… …………………… 84 6 Decoding of DVB Digital Television subtitles…………………… ………………… 91 7 Integration of Applications into Digital Television Environment…… ……………… 97 8 Digital Television...

Ngày tải lên: 28/10/2013, 14:15

25 225 0
Digital Television Applications P2

Digital Television Applications P2

... 37 6 RETURN CHANNEL COMMUNICATION MODELS Interactive television is a new paradigm that will merge appeal and mass audience of traditional television viewing with the interactivity of the World ... is not suitable for digital television applications. Using the standard Java AWT widget set increases rendering time and memory consumption, therefore a set of television- specific user interface ... Applications 19 2.5 S UBTITLES Digital television subtitle services do not belong to the category of interactive applications, however digital television uses a new digital subtitling system,...

Ngày tải lên: 07/11/2013, 07:15

25 354 0
RECEIVER SENSITIVITY / NOISE

RECEIVER SENSITIVITY / NOISE

... Noise) for a receiver depends on the intended use of the receiver. For instance, a receiver that had to detect a single radar pulse would probably need a higher minimum S/N than a receiver that ... at the input and amplified by the receiver& apos;s full gain greatly exceeds the noise generated further along the receiver chain. The noise performance of a receiver is described by a figure ... noise appearing in the output of an ideal receiver is proportional to the absolute temperature of the receiver input system (antenna etc) times the bandwidth of the receiver. The factor of proportionality...

Ngày tải lên: 08/11/2013, 19:15

9 288 0
RECEIVER TESTS

RECEIVER TESTS

... Source Directional Coupler 5-7.1 Figure 1. Receiver Test Setup When Antenna Can Be Removed Figure 2. Receiver Test Setup When Antenna Is Active RECEIVER TESTS Two tone and spurious response (single signal) receiver tests ... D 2 4 9 5-7.2 Figure 3. Frequency Areas in a Sample 2-4 GHz Receiver is still advisable to directly measure the input to the receiver whenever there is a suspected receiver failure. This test does not need to ... problem LO=6 * Frequency 0 dB - dB 2 GHz 4 GHz UDF #1 UDF #2 5-7.6 Figure 9. Multi Band Receiver with Common IF Figure 10. Receiver Band with Multiple UDF Entries As shown in Figure 9, assume that in band...

Ngày tải lên: 08/11/2013, 19:15

10 182 0
Xem thêm

Bạn có muốn tìm thêm với từ khóa:

w