table of contents in pages 2013

... 2002) Application Minimum Number of Exploration Points and Location of Exploration Points Minimum Depth of Exploration Retaining Walls A minimum of one exploration point for each retaining wall. For retaining walls ... be determined using one or more of the following methods:  in- situ testing during the field exploration program, including consideration of any geophysical testing conducted,  laboratory testing, ... jacking and shimming 10-8  = projected direction of load in the plane of a footing subjected to inclined loads (°) (10.6.3.1.2a)  = elastic settlement of footings on rock (ft); settlement of...

Ngày tải lên: 06/09/2012, 15:57

... of shaft (FT) S u = undrained shear strength (KSF) The value of S u should be determined from the results of in- situ and/or laboratory testing of undisturbed samples obtained within a depth of ... estimating axial compressive resistance of shafts embedded in rock. Where end bearing in rock is used as part of the axial compressive resistance in the design, the contribution of skin friction in ... center-to-center spacing of 4.0 diameters or more. For intermediate spacings, the value of may be determined by linear interpolation. C10.8.3.6.3 The bearing resistance of drilled shaft groups in sand is...

Ngày tải lên: 29/09/2013, 12:20

... driving, a higher blow count 10-97 setup occurs, a more accurate result may be obtained by combining the end bearing determined using the signal matching analysis obtained for the end of driving ... of:  The sum of the individual nominal resistances of each pile in the group, or  The nominal resistance of an equivalent pier consisting of the piles and the block of soil within the area bounded ... spacing of 2.5 diameters,  η = 1.0 for a center-to-center spacing of 6.0 diameters.  For intermediate spacings, the value of η may be determined by linear interpolation. If the cap is in firm...

Ngày tải lên: 29/09/2013, 12:20

... seepage forces in the bottom of excavations can result in piping loss of soil and/or heaving and loss of stability in the base of foundation excavations. Dewatering with wells or wellpoints can control ... the location of the ground water table as specified in Table 10.6.3.1.2a-2 (DIM) D f = footing embedment depth taken to the bottom of the footing (FT) The nominal bearing resistance, in KSF, for footings ... in the upper layer of a two-layer system, assuming the upper layer is infinitely thick (KSF) 10-51 10.6.1.5 ANCHORAGE OF INCLINED FOOTINGS Footings that are founded on inclined smooth solid rock...

Ngày tải lên: 29/09/2013, 12:20

... voids from solution weathering or mining activity, or slope instability potential Table 1 shall be used as a starting point for determining the locations of borings. The final exploration program ... be determined using one or more of the following methods:  in- situ testing during the field exploration program, including consideration of any geophysical testing conducted,  laboratory testing, ... signal matching at beginning of redrive conditions only of at least one production pile per pier, but no less than the number of tests per site provided in Table 3. Quality control of remaining piles...

Ngày tải lên: 29/09/2013, 12:20

... Intelligent Software Agents on the Internet: an inventory of currently offered functionality in the information society & a prediction of (near-)future developments by ... least because of their diversity, their wide range of applicability and the broad spectrum of companies investing in them. As we move further and further into the information age, any information-based organisation ... does not invest in agent technology may be committing commercial hara-kiri." Hyacinth S. Nwana in [NWAN96] __________ Tilburg University, Tilburg, The Netherlands, the 9 th of July 1996 1 Intelligent...

Ngày tải lên: 05/10/2013, 13:20

... shopping, dining); and determining appropriate language for expressing attitudes, opinions, and judgments. LANGUAGE STRUCTURES 0007 Demonstrate understanding of the linguistic components of German. For ... (e.g., arranging for lodging, booking tickets for a group); determining appropriate language for social situations (e.g., canceling an appointment, expressing a compliment); determining appropriate ... variety of current foreign language methodologies used in a classroom setting. For example: determining an appropriate methodology in a given instructional situation (e.g., introducing and expanding...

Ngày tải lên: 22/10/2013, 12:15

... mm Products Table of Contents Introduction 1 Frames Fiber Main Distributing Frame (FMDF) 2 Front Facing Fiber Main Distributing Frame (F3MDF) 3 Fiber Slim Rack 4 Blocks Fiber Termination Blocks ... tracing of jumpers - Minimizes risk of microbends or damage to fiber Built -in Jumper Storage Panel Minimizes number of required jumper lengths Maintains fiber bend radius Simplifies frame installation - ... Cable* House Cable* Corning Corning Corning Corning Corning Corning Corning Corning Sumitomo Sumitomo Sumitomo Sumitomo Sumitomo Sumitomo Sumitomo Alcatel Alcatel Alcatel 7 OSP Cable Type Singlemode 72...

Ngày tải lên: 10/12/2013, 17:15

... Wildcards 67 Cr eating and Editing Files 69 Managing Your Files 74 Printing Files 81 5. Redirecting I/O 87 Standard Input and Standard Output 87 Pipes and Filters 92 6. Using the Internet and Other ... vi Table of Contents Completing File and Directory Names 62 Changing Your Password 62 Customizing Your Account 63 4. File Management 66 File and ... 97 Remote Logins 97 Windows from Other Computers 100 Lynx, a Text-based Web Browser 101 Transferring Files 104 Electr onic Mail 108 Usenet News 118 Interactive Chat 123 7. Multitasking 130 Running a...

Ngày tải lên: 11/12/2013, 03:15

... Table of contents Managementhandbook 01 - chapter 01 Page 1 of 2 Table of contents Nr. Designation Pages 01. Table of contents 1 02. Modifications 3 03. Declaration of ... Modifications 3 03. Declaration of liability 3 04. Administration of the manual 1 05. Company portrait 1 06. Introduction 1 07. QE-Politics, continuous improvement 4 08. Organization 2 09. QE-Managementsystem...

Ngày tải lên: 12/12/2013, 00:15

... OF CONTENTS AND GLOSSARY COMPLETE TABLE OF CONTENTS AND GLOSSARY social engineering – The act of obtaining or attempting to obtain otherwise secure data by conning an individual into revealing ... SMTP 12 COMPLETE TABLE OF CONTENTS AND GLOSSARY Table of Contents Lesson 1: Being a Hacker 1.0 Introduction 1.1 Resources 1.1.1 Books 1.1.2 Magazines and Newspapers 1.1.3 Zines and Blogs 1.1.4 ... the best route between any two hosts. routing table – In internet working, the process of moving a packet of data from source to destination. Routing is usually performed by a dedicated device...

Ngày tải lên: 15/12/2013, 14:15

... clamp Compression fittings Bonding grounding kit Radius limiters (set of two) 5 6 7 8 Accessories 6paks (with or without fiber) installed into panel 6pak placement ordering guide in panel is factory installed 3 4 Adapters ... VCG with integrated mounting holes FL2000 System Mounting Options – 19" (48.26 cm) Rack Mounting 19" (48.26 cm) Maximum Mounting Note: Standard mounting in a rack equipped with inner-IMP 2/01 ... Telecommunications, Inc., P.O. Box 1101, Minneapolis, Minnesota USA 55440-1101 Specifications published here are current as of the date of publication of this document. Because we are continuously improving...

Ngày tải lên: 17/01/2014, 10:20

... and technology innovation. The applications of computational intelligence in manufacturing, in particular, play a leading role in the technology development of intelligent manufacturing systems. ... in applications have inspired renewed interest in practitioners from industry and service organizations. The truly interdisciplinary environment of the research and development offers rewarding ... University Singapore Y. F. Zhang National University of Singapore Singapore â2001 CRC Press LLC PART III Process Planning and Scheduling 8 Soft Computing for Optimal Planning and Sequencing...

Ngày tải lên: 23/01/2014, 01:20

... Conduct an investigation of the 11 Mandate further training of FSIS validation that the training has been On-going. FSIS has provided additional training interactive web-based training for responsible ... resuming trade. These actions include delisting and investigating the plant that exported the ineligible product, requiring a second signature on export certificates, providing training to inspection ... sell Page of 26 9 Following the investigation, USDA determined appropriate additional action steps to address the findings of the investigation. For example, to be certain that FSIS inspection...

Ngày tải lên: 06/03/2014, 23:20

Ngày tải lên: 15/03/2014, 07:20

Ngày tải lên: 15/03/2014, 14:20

Ngày tải lên: 17/03/2014, 04:20

Ngày tải lên: 19/06/2014, 08:20

Ngày tải lên: 20/06/2014, 02:20