seismic design for vessels

... 3-3: Seismic Design for Vessels, 120 Procedure 3-4: Seismic Design- Vessel on Unbraced Legs, 125 Procedure 3-5: Seismic Design- Vessel on Braced Legs, 132 Procedure 3-6: Seismic Design- Vessel on Rings, ... 3-11: Design of Saddle Supports for Large Vessels, 177 Procedure 3-12: Design of Base Plates for Legs, 184 Procedure 3-13: Design of Lug Supports, 188 Procedure 3-14: Design of Base Details for ... 140 Procedure 3-7: Seismic Design- Vessel on Lugs #1, 145 Procedure 3-8: Seismic Design- Vessel on Lugs #2, 151 Procedure 3-9: Seismic Design- Vessel on Skirt, 157 Procedure 3-10: Design of Horizontal...

Ngày tải lên: 02/04/2014, 16:47

... Banno for the PLD2 antibody, Dr Greg Hannon for the pSM2 vector, Dr Roger Y Tsien for the pRSET-B-mCherry, and Dr Jen-Chih Hsieh for the pRK-human IgG construct We also thank Dr Jian Cao for allowing ... oligos including cohesive ends and a specific sequence for each artificial miRNA (64 nucleotides for the miR155based system and 67 nucleotides for the miR30-based system) were annealed, and cloned ... target sequences and design of artificial miRNA stem-loops were based on the algorithms accessible at http://www.invitrogen.com/rnai (for miR155 system), http:// codex.cshl.edu (for miR30 system),...

Ngày tải lên: 07/03/2014, 11:20

... Isolating transformers and safety isolating transformers Specification for transformers for reduced system voltage BS EN 60742 Isolating transformers, and safety isolating transformers BS 3676/BS ... selecting a switch for, Design of electrical services for buildings say, fluorescent lighting It was for this reason that some of the older switches had to be de-rated when they were used for discharge ... electrical designer relies on information and assistance from specialists in related but separate fields This applies in particular to controls for heating and air conditioning, which are designed...

Ngày tải lên: 23/03/2014, 08:20

... and Quality of the Design Process”, describes the managerial aspect and the basic principles of the design process Definitions for design and system design • • • “The best design is the simplest ... system calculation vi Design of Hydraulic Systems for Lift Trucks Chapter Introduction Preface The purpose of this book is to illustrate design principles and methods for designing and calculating ... the foundation for designing any system on your own It is more difficult to design hydraulic systems for smaller lift trucks That is because these systems must have the same performance as the...

Ngày tải lên: 23/03/2014, 11:37

... is designed for explicit awareness of performance Thus error feedback on these attributes can be utilized immediately by the participant to correct movement performance in a subsequent trial For ... this feedback mapping expressed For all participants, for example, forearm rotation error improved by more in trials that followed the triggered feedback mapping for forearm rotation error (i.e image ... observe movement of his end-point by monitoring formation of the image, and when needed, apply this information for online control of his movement to adjust for vertical or horizontal deviations Movement...

Ngày tải lên: 19/06/2014, 08:20

... signal-dependent forms) are designed, the corresponding controls are defined, and the trade-offs and comparisons with the SCI are given In Section 3, the designed MCI system is used for the realtime ... practice Some simple implementations of the architectures for TF analysis are presented in [10, 13–19] An architecture for VLSI design of systems for TF analysis and time-varying filtering based on the ... this way In this paper, we develop an MCI of a special purpose hardware for TF analysis based on the SM, suitable for the VLSI design In the proposed implementation, each step in the TFDs execution...

Ngày tải lên: 22/06/2014, 23:20

... = for option A, and β = 0.5 for option B However, Fig shows that the points of intersection with the real axis are far from each other for the two options For option A: ReJ(Ω) = −0.0188, and for ... plant being type servo system formula (20) remains valid for integrating plants too If applied to the transfer functions of multiple integrators, this formula allows for deriving the the LPRS of ... odd Analysis of Closed-Loop Performance for Sliding Mode Control Systems 61 with either ReJr−int (ω) being zero for all odd r = n − m or ImJr−int (ω) being zero for even r Take magnitudes of the...

Ngày tải lên: 01/07/2015, 09:37

... thanks to my boyfriend for bringing me so much joy and for his everlasting patience Last but not the least, I wish to thank my parents for bringing me up and for their forever love I have always ... considerations for the design of the 60 GHz and 77 GHz filters in CMOS ix LIST OF TABLES 3.1 Model Parameters of MOSFET L60 with VD = 0.6 V and ID = mA 49 4.1 Design Parameters for Inductors ... 79 6.1 Design Parameters for Inductors 102 6.2 Performance Comparison of Previously Published Narrow Bandpass Filters and This Work 107 6.3 Design...

Ngày tải lên: 12/09/2015, 09:42

... before the mature gene coding for pIII, which enables the peptides to be expressed at the N-terminus of fusion pIII (Figure 2.3c) Dodecapeptide PSD library is available only in linear forms For ... Suggestions for future work 150 REFERENCES 153 APPENDIX I LIST OF PUBLICATIONS 162 VI SUMMARY Naturally occurring biomolecular machinery provides excellent platforms for ... concentrations for either LacI-C7AC or LacI-STB1 exhibit the same slope The ΔD - Δf plots for LacI-C7AC or LacI-STB1 binding to TiO2 surface (not shown) look similar to those for SiO2 surface...

Ngày tải lên: 14/09/2015, 14:08

... and foremost, I am grateful to Dr Paula Lam for supervising this project and for her endless support, guidance, advice and friendship I would like to extend my gratitude to Prof Hui Kam Man for ... Solution I for DNA extraction 2.1.12 Lysis solution for DNA extraction 2.1.13 Neutralizing buffer for DNA extraction 27 27 27 27 27 27 28 28 28 28 28 28 29 29 ii 2.1.14 Lysis buffer for isolating ... Binding buffer for isolation of nuclear extract for Electromobility shift assay (EMSA) (Wu et al., 2001) 2.1.43 Buffer A for isolation of nuclear extract (Wu et al., 2001) 2.1.44 Buffer C for isolation...

Ngày tải lên: 16/09/2015, 15:54

... CFC: Cloning forming cell CFU-E: Colony forming unit erythrocyte colony-forming units CFU-GEMM: Colony forming unit granulocyte, erythrocyte, monocyte, megakaryocyte CFU-GM: Colony forming unit ... product for transplantation 2.2.1 Selection of candidate cells for expansion There are a number of issues related to the selection of a candidate stem population for ex vivo expansion Before determining ... the standard long-term biological assays for stem cells are impractical for quantitating the level of expansion Therefore, the only practical criteria for infusion would likely be based on phenotypic...

Ngày tải lên: 04/10/2015, 15:44

... Learning Vector Quantization 6.4 SelfOrganized Maps Conclusions and Further Research Performance of modern techniques for rating model design Introduction Credit risk forecasting is one of the leading ... Mr Nasir Ahmed for their valuable advices and also to my supervisor: Mr Uwe Schmock, for helpful discussions and suggestions Performance of modern techniques for rating model design 22 References: ... with the following forms: G C V (λ ) = MSE (λ ) ⋅  S (λ )  1 −  N   S (λ ) 1+ N F P E (λ ) = MSE (λ ) ⋅ S (λ ) 1− N Performance of modern techniques for rating model design where S (λ )...

Ngày tải lên: 16/04/2013, 20:00

... permeability for the gas phase (KP ) The relative permeability accounts for the reduction in pore space available for one phase due to the existence of the second phase [7] The momentum equation for ... the cell width of the electrode For optimal fuel cell performance, a uniform current density generation is desirable, and this could only be achieved with a non-uniform catalyst distribution, possibly ... a new design air-breathing micro-structured PEM fuel cell that incorporates the significant physical processes and the key parameters affecting fuel cell performance The model accounts for both...

Ngày tải lên: 05/09/2013, 14:58

Ngày tải lên: 17/10/2013, 19:15

... closed loop system There are well developed methods for defining performance criteria and for designing linear closed loop systems which meet the performance requirements It would then be desirable, ... response for small exogenous signals (reference commands and disturbances) One way to design controllers for systems with bounded controls, would be to solve an optimal control problem; for example, ... initial investigation was made on the effects on performance of the reset windups for MIMO systems [11] showing potential for improving the performance of the system A simple case study was also...

Ngày tải lên: 18/02/2014, 10:20

... considering pseudoatoms [23] performed for 20 ps to explore several possible conformations that the peptide can acquire The trajectory from high temperature dynamics was analyzed for similarities between ... on Ó FEBS 2004 Design of peptides for T-cell adhesion inhibition (Eur J Biochem 271) 2879 biological activity, cyclic hexapeptides were designed These hexapeptides were truncated forms of the 12-mers ... derived structures for the cyclic peptides with average structure for (A) cER and (B) cVY Only heavy atoms are shown for clarity The residues which are involved in b-turn conformation are labeled...

Ngày tải lên: 19/02/2014, 13:20

... synthesis gas via reforming [34] There are two major designs appropriate for black liquor gasification to syngas for transportation fuels: fluidized bed black liquor steam reforming at low temperatures ... bar [94, 97] The electricity requirement for the ASU is 261 kWe/kgO2, for a total of 55.7 MWe for the design [97] 3.2.1 Gasifier Scale and Fuel Yield For economic production of DME fuel, about ... cycle analysis of DME and FTD designs 68  Figure 27: Mass and energy flow of DME design and FTD design 69  List of Tables Table 1: Bleaching chemicals for ECF and TCF bleaching processes...

Ngày tải lên: 26/02/2014, 14:20

... [2831], therefore in this study we analysed a novel synthetic peptide, AP1 (GEQGALAQFGEWL), as a potential anionic a-AMP against Escherichia coli The sequence of AP1 was designed to form a membrane-interactive ... at 15 minute intervals for h and then hourly intervals for h At each time interval, samples were surface-spread on to nutrient agar plates, which were incubated at 37 C for 12 h As a FEBS Journal ... user-friendly software for the analysis of aminoacid sequences Biotechniques 26, 11701172 Keller RC, Killian JA & de Kruijff B (1992) Anionic phospholipids are essential for alpha-helix formation of the...

Ngày tải lên: 07/03/2014, 12:20

... given a set of possibly well-formed trees; b alternatively, in some cases, information which is implicit for one type of interpreter may need to be made explicit for another, causing violation ... the data for the task, plus details of the interpretation scheme used to apply the declarative information to the data base Again, as in a production system, it is important that the information ... representation for all linguistic description Examples where other styles of expression may well be more fitting are in the description of morphological paradigms for highly inflected languages or the formulation...

Ngày tải lên: 08/03/2014, 18:20