...
London(config-if)#ip ospf network point- to- multipoint
1 - 6 Semester 5: Advanced Routing v2.0 - Lab 4.6.3 Copyright 2001, Cisco Systems, Inc.
4.6.3: Configuring Point- to- Multipoint OSPF Over Frame Relay ... relationships. To avoid these complications, you must manually override the
Non-Broadcast Multi-Access (NBMA) OSPF network type and configure OSPF to run as
a point- to- multipoint network. In ... headquarters to San Jose
using Frame Relay in a hub-and-spoke topology. You are asked to configure OSPF
routing over this type of network, which is known for introducing complications into OSPF...
... provided in
Chapter 2, Point- to -Point GRE over IPsec Design and
Implementation.”
2-19
Point- to -Point GRE over IPsec Design Guide
OL-9023-01
Chapter 2 Point- to -Point GRE over IPsec Design and ... Description
Chapter 1, Point- to -Point GRE over IPsec
Design Overview.”
Provides an overview of the VPN site -to- site design topology and
characteristics.
Chapter 2, Point- to -Point GRE over IPsec
Design ... configured to allow the tunnel traffic bi-directionally. The crypto headend must be
accessible to the branch router.
2-21
Point- to -Point GRE over IPsec Design Guide
OL-9023-01
Chapter 2 Point- to- Point...
...
Thuật to n Lempel-Ziv (LZS) (RFC 1974
) cung cấp cơ chế nén và giải nén nhanh dữ
liệu. Thuật to n này được sử dụng trong cơ chế nén STAC trong PPP, ISDN và Frame
Relay.
Point toPoint Protocol ... hai cơ chế
chứng thực Password Authentication Protocol (PAP) hay Challenge Handshake
Authentication Protocol (CHAP).
• Network Control Protocol (NCP): NCP làm nhiệm vụ thiết lập, điều chỉnh ... hủy.
RFC 1333
mô tả Link Quality Monitoring.
Compression
Việc nén dữ liệu có thể là nén mềm sử dụng một số tiện ích như Wellfleet Compression
Protocol (WCP) (giao thức này được sử dụng...
... loopbacks and PM
Ethernet loopbacks and PM
Ethernet cable testing with TDR
WAN Protocol: RFC1661: Point- to -Point Protocol (PPP) and Link Control Protocol (LCP)
RFC1990: PPP Multilink Protocol (ML-PPP)
RFC3518: ...
Extend Ethernet Services to All Customers Over Readily Available T1/E1 Facilities
2
www.adc.com • +1-952-938-8080 • 1-800-366-3891
Benefits
• Cost-effective approach to deliver Ethernet services over ... (19" and 23")
Full front access (ETSI form factor)
Temperature hardened (option)
-40° to +65° C (operating)
-40° to +70° C (storage)
Regulatory: UL Listed
EN/UL 60950
CE Mark
FCC Part 15 Class...
... transport
medium for 10Gbps over copper.
KRONE, recently acquired by ADC, took on the challenge
and returned to the IEEE 802.3 Study Group just weeks
later to demonstrate CopperTen, the first augmented
Category ... for the cable and
connectors.
When in doubt, follow the IEEE lead.
The IEEE 802.3 Study Group was formed to discuss how
best to approach running 10Gbps transmission over a
copper infrastructure. ... pair
combinations. Today, CopperTen has achieved greater
than 31 Gbps over 100 meters—offering more than
enough additional throughput to handle noise induced
by active electronics.
Have vendors had a tough...
... for 10Gbps Ethernet
over UTP
Questions to Ask When Planning the Cabling Plant
Planning for 10Gbps Ethernetover UTP
Page 4
With the AirES innovation of introducing air—the best
insulator against ... in development today and expected
to market in 2006, the cabling plant must be able to handle the new protocol.
Can Category 6 cabling support 10Gbps Ethernetover UTP?
Actually, Category 6 cabling ... excessive
propagation delay is often due to cable that is just too
long.
By utilizing the higher quality AirES insulation with air
channels between FEP and the copper conductor,
CopperTen cable requires a...
... and/or T1 services over DS3.
Applications:
• Ethernet- enable an existing SONET ADM
• Back -to- back Ethernetover DS3 facilities
• High-speed Internet access
• Storage Networks
• Voice over IP (VoIP) ... the
customer’s Ethernet connection using a built-in Time Domain Reflectometer (TDR).
Central office or hub
GigE
T1s
Switch/router
Switch/router
Switch/router
Ethernet
T1
T1
Ethernet
Ethernet ... remote management capability allows carriers to extend IP management
visibility all the way to the remote customer edge. From a single operator viewpoint, a full range of performance
statistics,...
... for 10Gbps Ethernetover UTP
Questions to Ask When Planning
the Cabling Plant
Planning for 10Gbps Ethernetover UTP
Page 4
With the AirES innovation of introducing air—the best
insulator against ... in development today and expected
to market in 2006, the cabling plant must be able to handle the new protocol.
Can Category 6 cabling support 10Gbps Ethernetover UTP?
Actually, Category 6 cabling ... excessive
propagation delay is often due to cable that is just too
long.
By utilizing the higher quality AirES insulation with air
channels between FEP and the copper conductor,
CopperTen cable requires a...
... transport
medium for 10Gbps over copper.
KRONE, recently acquired by ADC, took on the challenge
and returned to the IEEE 802.3 Study Group just weeks
later to demonstrate CopperTen, the first augmented
Category ... for 10Gbps Ethernetover UTP
Questions to Ask When Planning
the Cabling Plant
Planning for 10Gbps Ethernetover UTP
Page 4
With the AirES innovation of introducing air—the best
insulator against ... for the cable and
connectors.
When in doubt, follow the IEEE lead.
The IEEE 802.3 Study Group was formed to discuss how
best to approach running 10Gbps transmission over a
copper infrastructure....