... (www.springer.com) Handbook of Networks in Power Systems: Optimization, Modeling, SimulationandEconomicAspects This handbook is a continuation of our efforts to gather state-of-the-art research ... Operations Research Specifically, this handbook focuses on aspects of power system networks optimizationand is, as such, a specialization of the broader “Handbook of Power Systems I & II,” published ... and transparent electricity markets underpinned by strong governance structures [3] In UK, The Electricity Pool of England and Wales was created in 1990 to balance electricity supply and demand,...
... cgliu2008@gmail.com K Mombaur and K Berns (Eds.): Modeling, Simulationand Optimization, COSMOS 18, pp 1–15 c Springer-Verlag Berlin Heidelberg 2013 DOI: 10.1007/978-3-642-36368-9_1 C.G Atkeson and C Liu One ... Damme · Bram Vanderborght · Dirk Lefeber Vrije Universiteit Brussel, Pleinlaan 2, 1050 Brussels, Belgium e-mail: pcherell@vub.ac.be K Mombaur and K Berns (Eds.): Modeling, Simulationand Optimization, ... kmombaur@laas.fr K Mombaur and K Berns (Eds.): Modeling, Simulationand Optimization, COSMOS 18, pp 31–42 c Springer-Verlag Berlin Heidelberg 2013 DOI: 10.1007/978-3-642-36368-9_3 32 M Felis and K Mombaur...
... Series Bailey and OUii: Biochemical Engineering Fundamentals Bennett and Myers: Momentum, Heat, amd Mass Transfer Beveridge and Schechter: Optimization: Theory and Practice Brodkey and Hershey: ... Engineering Peters and Timmerbaus: Plant Design and Economics for Chemical Engineers Probstein and Hicks: Synthetic Fuels Reid, Prausnitz, and Sherwood: The Properties of Gases and Liquids Resnick: ... chemical plant and control system I I I - PROCESS MODELING SIMULATION, AND CONTROL FOR CHEMICAL ENGINEERS Thermodynamics and mass transfer Operating pressure, number of plates and reflux ratio...
... 1990; Haynes et al., 1992; Kulkarni and Dudukovic, 1996, 1997 and 1998; Annaland et al., 2001; Annaland et al., 2002 a and b; Annaland and Nijssen, 2002; Kolios et al., 2002; Glocker et al., 2003; ... Xiao and Yuan, 1994; Nieken et al., 1995; van de Beld and Westerterp, 1996; Salinger and Eigenberger, 1996) The effect of convective and diffusive terms for energy (both fluid and solid phases) and ... isobutyric acid to methacrylic acid) Denis and Kabel, 1970; Wandrey and Renken, 1971; Snyder and Subramaniam, 1994 & 1998; Seuffert et al., 1997; Kolios and Eigenberger, 1999; Oxidation of SO2 over...
... (1) where mn, µn, and krn are the mobility, viscosity, and relative permeability of the non-wetting phase (CO2) respectively and mw, µw, and krw are the mobility, viscosity, and relative permeability ... a certain WAG operation would be This choice of the optimization fitness function takes into consideration both the performance andeconomicaspects of adapting the WAG operation, since the water ... Energy and Environment (IJEE), Volume 4, Issue 3, 2013, pp.387-398 (a) (b) Figure Injection scenarios and corresponding pressure response, CPI and two CGI injection cases Appendix A.1 Numerical Simulation...
... orders@intechopen.com Modelingand Control Aspects of Wind Power Systems, Edited by S M Muyeen, Ahmed Al-Durra and Hany M Hasanien p cm ISBN 978-953-51-1042-2 free online editions of InTech Books and Journals ... the PI controller used are set by the trial and error method to get the best results [8-9] 11 12 Modelingand Control Aspects of Wind Power Systems Simulation results In this paper dynamic characteristic ... carried out using offline laboratory standard power system simulation tool PSCAD/EMTDC and Real Time Digital Simulator (RTDS) Detailed modeling, control, and switching scheme of STATCOM have been...
... dependent power loss calculation and a comprehensive thermal model The focus is to develop the theoretical framework and supporting tool for modeling, analysis andsimulation (MAS) of the PEBB dynamic ... dynamic electro-thermal modeling for the intelligent operations of PEBBs in distribution energy resources All modeling methodologies, analysis, andsimulation algorithms proposed and realized, using ... electro-thermal modeling in PEBB applications To achieve requirements for the modeling, an improved power loss distribution with temperature dependent self-improvement ability and an effective RC thermal modeling...
... warranty and preventive maintenance modeling 19 CHAPTER LITERATURE REVIEW In this chapter, we provide some background information for warranty and preventive maintenance (PM) cost modelingandoptimization ... 2.1) and more complex system structure and ageing mechanism For interested readers, we refer to Sheu (1996), Wang and Pham (1999), Frickenstein and Whitaker (2003), Sheu and Chang (2001), and ... product demand xiv CHAPTER INTRODUCTION In this thesis, we investigates several important issues in the post-sale cost modelingandoptimization from both the manufacturer’s (seller) and consumer’s...
... (2004),Agarwal and Renaud (2004), Azaiez and Bier (2007), Bier et al (2005) Genetic Levitin (2001), Levitin and Lisnianski (2001), Zhao and Liu (2003), Algorithm Ramirez-Marquez and Coit (2004), Yun and ... Nahas and Nourelfath Algorithm (2005), Dorigo (2001), Maniezzo and Carbonaro (2001), Liang and Smith (1999) SA and TS Others Wattanapongsakorn and Levitan (2004), Ryoo (2005) Nourelfath and Dutuit ... analysis andoptimization of various types of binary and multi-state system Levitin et al (1998) generalize a redundancy optimization problem to multi-state series-parallel systems, and use UGF...
... Sensitivity analysis 61 3.5.4 NSGA parameters and objectives definition 61 3.5.5 Optimization results and discussion 63 3.6 Summary 67 Modeling, SimulationandOptimization of an Industrial Hydrocracking ... description 69 4.3 Hydrocracking kinetics andmodeling 73 4.4 Modelingandsimulation of the hydrocracking unit 75 4.5 Feed and product characterization and property prediction 81 4.6 Model calibration: ... model for simulationandoptimization Chapter describes the development and assessment of a generic MPMLE software tool for process simulationand MOO A case study on styrene reactor unit and plant...
... Compression Transparency 36 3.7 The Optimization of a Scheme 37 ii 3.7.1 The Goal of Optimization 37 3.7.2 The Optimization Procedure 38 3.8 Modeling Different Source and Deployment Scenarios The IPID ... work and discussions with Mr Sukanta Kumar Hazra and Mr Wang Haiguang Many others have contributed to making the author’s candidature at the Institute for Infocomm Research a satisfying and enlightening ... between compression gains and implementation cost [18] The cost and performance due to the context establishment has been studied using an analytical model in [15] and the handover aspect was analyzed...
... heated reboilers and watercooled condensers The overheads of debutanizer comprise mainly of C4’s and bottoms are C5’s and higher [13] 2.1.2 Analysis andOptimizationSimulationandoptimization of ... SIMULATIONAND MULTI-OBJECTIVE OPTIMIZATION OF SHRUTI COLD-END SEPARATION PROCESS OF AN ETHYLENE PLANT PANDEY 2013 SIMULATIONAND MULTI-OBJECTIVE OPTIMIZATION OF COLD-END ... gas compressor and refrigeration compressor suction pressures, typical column variables (reflux, reboiler, and pressure), and converter temperature and H2 ratio Advanced control and optimization...
... experimental study and USACE & USBR data Ho et al made a comparison on crest pressures and discharges over a standard ogee spillway by 2D and 3D simulations in Flow 3D Software and USACE data and also ... predicted by numerical simulations and compared with the physical modeling observations Flow over the steppes and energy dissipation along the spillway were computed numerically and compared with ... Representation (FAVOR) and the renormalization group (RNG) were implemented to simulate the fluid surface, obstacles and turbulence The continuity and momentum equations for flow and transport equation...
... both data and command When Command is added, it is placed to the head + b) Separate FIFO for command and data When transferring, the HBA check the command FIFO first Figure 3.8 Command Frame ... commands preemptively These measures are collectively named as the Command-First Algorithm Data Data Data Data Data Data Data Data FIFO head Data Data Data Data Command Command Command Command ... effective and detailed simulation model is built to support frame and transmission word level simulation; z Hardware trace level calibration and actual system experiment comparison are performed for simulation...
... conceptualization of the multiplicity and salience of major challenges to development and security, all of which require political and public awareness andeconomic resources for timely and efficient policy treatment ... of risks, costs and benefits of handling these hazards using a multicriteria and systems approach towards the setting of policy priorities and resource sharing In addition to and developing from ... ‘long tail’ and intergenerational modes of climate change impact and thus implies special monetary and/ or insurance funds to cover respective costs and expected damage On the other hand, looking...
... renewal and transformation; and (3) and understanding ENVIRONMENTAL HAZARDS of change and uncertainty as inherent in social-ecological systems This statement strongly reflects the convergent aspects ... et al (2003) attribute coping capacity and adaptive capacity as separate dimensions of resilience, Smit and Wandel (2006) lump them together To Smit and Wandel (2006), adaptive capacity is equivalent ... CCA and DRR merged with insurance schemes could play an important role when discussing financial vulnerability and managing risks for governments and communities Understanding resilience and vulnerability...