... only in
combination with information from direct methods
of exploration, such as SPT, CPT, etc. to establish
stratification of the subsurface materials, the profile
of the top of bedrock and bedrock ... be unsuitable for field
verification of nominal axial resistance of soft silts or
clays where a large amount of setup is anticipated
and it is not feasible to obtain dynamic
measurement of pile ... determined to be too soft or weak
to support the design loads without excessive
movement or loss of stability. Alternatively, the
unsuitable material can be removed and replaced with
suitable and properly...
... lower
portion of the shaft.
The value of is often considered to vary as a
function of S
u
. Values of for drilled shafts are
recommended as shown in Equations 2 and 3,
based on the results of back-analyzed, ... distance
of 1.5B above the top of the weaker layer to the base
resistance of the weaker layer at the top of the weaker
layer.
C10.8.3.5.3
The distance of 1.5B represents the zone of
influence for general ... of
undisturbed samples obtained within a depth of 2.0
diameters below the tip of the shaft. If the soil within
2.0 diameters of the tip has S
u
<0.50 KSF, the value
of N
c
should be multiplied...
... shear strength of clays (KSF)
n
h
= rate of increase of soil modulus with depth
for sands as specified in Table 10.4.6.3-2
(KSI/FT)
10.7.4 Extreme Event Limit State
The provisions of Article 10.5.5.3 ... types of cement for various types of
sulfate exposure.
For prestressed concrete, ACI 318
recommends a maximum water-soluble chloride ion
of 0.06 percent by weight of cement.
Cathodic protection of ... RESISTANCE OF PILE GROUPS IN
COMPRESSION
For pile groups in clay, the nominal axial
resistance of the pile group shall be taken as the
lesser of:
The sum of the individual nominal resistances of
each...
... determined to be too soft or weak
to support the design loads without excessive
movement or loss of stability. Alternatively, the
unsuitable material can be removed and replaced with
suitable and properly ... the zone of overbreak or fracturing.
Evaluation of seepage forces and hydraulic
gradients should be performed as part of the design of
foundations that will extend below the groundwater
table. ... profile
consisting of a combination of cohesive soil,
cohesionless soil and/or rock shall be evaluated
using an appropriate settlement estimation
procedure for each layer within the zone of
influence of induced...
... (KSI)
n
h
= rate of increase of soil modulus with depth
as defined in Table C2 (KSI/FT)
z = depth in feet below the ground surface (FT)
Table C10.4.6.3-2 – Rate of increase of Soil
Modulus with Depth ... methods
of exploration, such as SPT, CPT, etc. to establish
stratification of the subsurface materials, the profile
of the top of bedrock and bedrock quality, depth to
groundwater, limits of types of ... test with signal
matching at beginning of redrive conditions only of at
least one production pile per pier, but no less than the
number of tests per site provided in Table 3. Quality
control of...
... [NWAN96]
__________
Tilburg University, Tilburg, The
Netherlands, the 9
th
of July 1996
1
Intelligent Software Agents on the Internet
Tableof Contents
... Intelligent Software Agents on the
Internet:
an inventory of currently offered
functionality in the information
society & a prediction of
(near-)future developments
by ... Hermans
__________
"[ ] Agents are here to
stay, not least because of
their diversity, their wide
range of applicability and
the broad spectrum of
companies investing in
them. As we move further
and further...
... understanding of the main idea or details in a spoken passage, a
telephone message, a public address announcement, a sequence of steps described in a set of oral
directions, a stated cause or effect of ... tone, mood, or point of view ofone or more speakers; determining
a relationship (e.g., cause-and-effect) implied but not stated in an oral communication; and
determining the social context of ... German
TM
TABLE OF CONTENTS
Field 17: German
PART 1: G
ENERAL
I
NFORMATION
A
BOUT THE
AEPA
AND
T
EST
P
REPARATION
A
N
O
VERVIEW OF THE
AEPA 1-1
Test Development Process
Characteristics of the...
... the rear side of the block exit up
toward the top of the frame) or “downward” (cables terminated to the rear side of the block exit down
toward the bottom of the frame). All blocks with adapters ... terminated to the rear side of the
block exit up toward the top of the frame) or “downward” (cables terminated to the rear side of the
block exit down toward the bottom of the frame).
Preterminated ... kit for FOT patch cords
included with fiber termination
blocks loaded with adapters only
Cable clamp kit for IFC/OSP cables
included with fiber termination
blocks with IFC
Catalog Number
RAC-MX0616
RAC-MX0615
Ordering...
... security
organization in the UK.
9
COMPLETE TABLEOFCONTENTS AND GLOSSARY
COMPLETE
TABLE OF CONTENTS
AND
GLOSSARY
social engineering – The act of obtaining or attempting to obtain otherwise ... Configuration Protocol.
8
COMPLETE TABLEOFCONTENTS AND GLOSSARY
Lesson 11: Passwords
11.0 Introduction
11.1 Types of Passwords
11.1.1 Strings of Characters
11.1.2 Strings of Characters plus a token
11.1.3 ... servers.
Most e-mail systems that send mail over the Internet use SMTP
12
COMPLETE TABLEOFCONTENTS AND GLOSSARY
Tableof Contents
Lesson 1: Being a Hacker
1.0 Introduction
1.1 Resources
1.1.1 Books
1.1.2...
... access to rear
of front plate and interior of panel
ã FL2000 6pak adapter plug-ins ordered separately
ã Constructed of high strength aluminum
ã Equipped with removable metal doors with
Plexiglas ... Select splice tray with chip
5. Select number of cable clamps (0-9)
6. Select number of compression fittings (0-9)
7. Select number of bonding grounding kits (0-9)
8. Select number of radius limiters ... plug-in
None/NA
7
E
4
2
R
C
P
L
J
F
K
B
3
0
N
6paks (with or without fiber)
not installed into panel
Rack Mount Front View
3A 3B
3C 3D
1
2
N
Adapters with pigtails (2.0 mm x 3.0 m)*
Adapters only
None/NA
Cable...
... are affiliated with a number of major professional societies such as IEEE, ASME, SME,
IIE, and their counterparts in Europe, Asia, and the rest of the world. The book is a source of new
information ... the applications of genetic algorithms for production planning and scheduling.
Part IV of the book is composed of five chapters and is concerned with monitoring and control of
manufacturing processes ... Editor of the
IEEE Transactions
on Neural Networks.
Andrew Kusiak
is a Professor of Industrial Engineering at the University of Iowa, Iowa City. His interests
include applications of...
... Accountability Office (I)
Office of Management and Budget (1)
Office of the Chief Financial Officer
Director, Planning and Accountability Division (1)
Japan Export Investigation Report
For Official ... shipping, or
exporting of any veal offal products. As such, none of these offal products were
eligible for EV certification.
ã Golden did not segregate or identify veal offal products for certification ... made aware of this ineligible shipment, the U.S.
Secretary of Agriculture ordered a thorough investigation. The Office of Program
Evaluation, Enforcement and Review, the office within the Food...