hướng dẫn sửa chữa xe honda đời mới full
HƯỚNG dẫn sửa CHỮA XE PEUGEOT 205
Ngày tải lên :
28/05/2014, 15:43
... cable so that the throttle
linkage closes fully with the accelerator pedal
released. Also check that full throttle can be
obtained with the accelerator pedal fully
depressed.
4 If there is any doubt ... reservoir cap and carefully
lift it out of position. Inspect the reservoir,
if the fluid is dirty the hydraulic system
should be drained and refilled (see Chapter 1).
3
Carefully add fluid, taking ... less effective.
29 Always use an ethylene-glycol based
antifreeze which is suitable for use in mixed-
metal cooling systems. The quantity of
antifreeze and levels of protection are
indicated in...
- 249
- 675
- 1
Toyota camry 2006 2011 body repair manual hướng dẫn sửa chữa thân xe toyota camry đời 2006 2011
Ngày tải lên :
24/05/2014, 13:18
... Conditioner
assy assembly
ECT Electronic Controlled Transmission
ECU Electronic Control Unit
e.g. Exempli Gratia (for Example)
Ex. Except
FWD Front Wheel Drive Vehicles
2WD Two Wheel Drive Vehicles
4WD ... Fender Gusset
BODY PANEL REPLACEMENT
BP-1
RADIATOR UPPER SUPPORT (ASSY): TMC made
B136589
for Fixed Seat Type:
REAR SEAT HEADREST ASSEMBLY
REAR CENTER SEAT
HEADREST ASSEMBLY
REAR SEAT BACK ASSEMBLY
REAR...
- 164
- 1.1K
- 1
Toyota land cruiser 1998 2007 body repair manual hướng dẫn sửa chữa thân xe land cruiser đời 1998 2007
Ngày tải lên :
24/05/2014, 15:25
... doors
and hood.
S Around the hinges of the doors
and hood.
S Inside of the welded parts with
boxed cross-section.
Tube Type
Cartridge Type
*The above SSM or equivalent
*The above SSM or equivalent
UNDERCOAT
Apply...
- 130
- 1K
- 0
Toyota RAV4 1994 2000 engine mechanical hướng dẫn sửa chữa động cơ xe toyota RAV4 đời 1998 2000
Ngày tải lên :
24/05/2014, 16:26
... vacuum hoses for EGR systems, etc. should be properly
connected.
(f) SFI system wiring connectors fully plugged
(g) Ignition timing check correctly
(h) Transmission in neutral position
(i) Tachometer ... induction system connected
(d) All vacuum lines properly connected
(e) SFI system wiring connectors fully plugged
(f) All operating accessories switched OFF
(g) Ignition timing check correctly
(h)...
- 105
- 721
- 0
