figure5 performance testing topology overview

... redundant switch topology issues © 2002, Cisco Systems, Inc All rights reserved ICND v2.0—3-3 Redundant Topology • Redundant topology eliminates single points of failure • Redundant topology causes ... Redundant Topology Overview ©© 2002, Cisco Systems, Inc All rights reserved 2002, Cisco Systems, Inc All rights ... storm is when each switch on a redundant network floods broadcast frames endlessly • In a redundant topology, multiple copies of the same frame can arrive at the intended host, potentially causing...

Ngày tải lên: 08/07/2013, 01:27

... network delay between the server and clients 1.4 Pre-Requisites for Performance Testing We can identify five pre-requisites for a performance test Not all of these need be in place prior to planning ... design specification or a separate performance requirements document should : • • • Defines specific performance goals for each feature that is instrumented Bases performance goals on customer requirements ... useful for finding obscure errors in the code, but is, however, useless for a performance test 1.5 Performance Requirements Performance requirements normally comprise three components: • • • Response...

Ngày tải lên: 25/10/2013, 03:20

... Performance Testing of Permanent Links and Channels Testing of telecommunications Permanent Links and Channels to determine performance compliance to Class D ... 100m max Field Performance Testing V10 050111 Page of TO Passive Testing With Hand-Held Field Testers There are currently three levels of hand-held field tester: Level 2e – for testing up to Class ... test results This requirement only applies to PL testing Channel testing still uses the Vendor’s patch cords, which are to be left in situ after testing The configuration of the Permanent Link...

Ngày tải lên: 26/10/2013, 19:15

... Performance Testing of Permanent Links and Channels Testing of telecommunications Permanent Links and Channels to determine performance compliance to Class D ... 100m max Field Performance Testing V10 050111 Page of TO Passive Testing With Hand-Held Field Testers There are currently three levels of hand-held field tester: Level 2e – for testing up to Class ... test results This requirement only applies to PL testing Channel testing still uses the Vendor’s patch cords, which are to be left in situ after testing The configuration of the Permanent Link...

Ngày tải lên: 27/10/2013, 17:15

... reading, and not an average reading of both directions for LSPM testing) Some installers choose to use only OTDR testing and not LSPM testing If this is done, ADC KRONE will only accept the results ... during the early stages of testing to ensure you are getting the results you expect Take appropriate corrective action before further testing if the results are unexpected OF Testing ADC KRONE Requirements ... TIA/EIA 526-14-A 25 OTDR Testing, General Requirements Use a Launch Cord and a Tail Cord for OTDR testing [These Launch and tail Cords are different from those used in LSPM Testing. ] Both Launch...

Ngày tải lên: 10/12/2013, 02:15

... ISO 11801 performance standards Field Performance Testing V15 060508 Page of 11 If the default North American (TIA) Cat5E performance standards are selected, then not all the required testing and ... America) Field Performance Testing V15 060508 Page of 11 Passive Testing With Hand-Held Field Testers There are currently three levels of hand-held field tester: Level 2e – for testing up to Class ... Performance Testing of Permanent Links and Channels There are distinct areas of cable testing; Certification, Qualification and Verification Certification is the most rigorous of all cable testing...

Ngày tải lên: 12/12/2013, 12:15

Ngày tải lên: 20/12/2013, 22:15

... reading, and not an average reading of both directions for LSPM testing) Some installers choose to use only OTDR testing and not LSPM testing If this is done, ADC KRONE will only accept the results ... during the early stages of testing to ensure you are getting the results you expect Take appropriate corrective action before further testing if the results are unexpected OF Testing ADC KRONE Requirements ... TIA/EIA 526-14-A 25 OTDR Testing, General Requirements Use a Launch Cord and a Tail Cord for OTDR testing [These Launch and tail Cords are different from those used in LSPM Testing. ] Both Launch...

Ngày tải lên: 22/12/2013, 12:15

Ngày tải lên: 19/01/2014, 05:20

... Performance Testing of Permanent Links and Channels Testing of telecommunications Permanent Links and Channels to determine performance compliance to Class D ... 100m max Field Performance Testing V10 050111 Page of TO Passive Testing With Hand-Held Field Testers There are currently three levels of hand-held field tester: Level 2e – for testing up to Class ... test results This requirement only applies to PL testing Channel testing still uses the Vendor’s patch cords, which are to be left in situ after testing The configuration of the Permanent Link...

Ngày tải lên: 24/01/2014, 03:20

... system to be fine-tuned for the twisted pair cable Such features provide adjustment for optimum performance over the entire operating range and allow for cable length to be estimated with a wide ... realised in lower labour and material costs, smaller conduits, fewer cable pulls, common media topology and easier retrofits using existing cabling deployed for voice and data Structured cabling ... changes is low; hence patch by exception makes sense Also as excellent, connectivity transmission performance is required for high picture quality, then KRONE’s HIGHBAND products are an ideal solution...

Ngày tải lên: 24/01/2014, 03:20

Ngày tải lên: 24/03/2014, 01:21

... redundant switch topology issues © 2002, Cisco Systems, Inc All rights reserved ICND v2.0—3-3 Redundant Topology • Redundant topology eliminates single points of failure • Redundant topology causes ... Redundant Topology Overview ©© 2002, Cisco Systems, Inc All rights reserved 2002, Cisco Systems, Inc All rights ... storm is when each switch on a redundant network floods broadcast frames endlessly • In a redundant topology, multiple copies of the same frame can arrive at the intended host, potentially causing...

Ngày tải lên: 29/03/2014, 14:20

... three areas regarding vCloud Director performance:  vCloud Director sizing guidelines and software requirements  Best practices in performance and tuning  Performance characterization for key ... VMware vCloud Director 1.5 Performance and Best Practices 20 18 16 14 12 10 Figure Latency overview for vCloud Director operations Next, we looked into vApp deployment performance vApp can be deployed ... TECHNICAL WHITE PAPER /18 VMware vCloud Director 1.5 Performance and Best Practices Performance tips:  To achieve better first linked clone performance across datastores in vCloud Director 1.5,...

Ngày tải lên: 31/03/2014, 16:20

... http://developer.android.com/reference/android/test/ActivityTestCase.html Thursday, April 14, 2011 Testing Thursday, April 14, 2011 Testing Johnson's Law If it is not tested it does not work The more time between coding and testing More effort is needed to ... http://junit.org/junit/javadoc/4.5/ JUnit FAQ, http://junit.sourceforge.net/doc/faq/faq.htm Testing for Programmers, Brian Marick, Available at: http://www.exampler.com /testing- com/writings.html Android Documentation, http://developer.android.com/reference/android/test/ActivityTestCase.html ... Testing References JUnit Cookbook http://junit.sourceforge.net/doc/cookbook/cookbook.htm JUnit Test Infected: Programmers Love Writing Tests http://junit.sourceforge.net/doc/testinfected /testing. htm...

Ngày tải lên: 28/04/2014, 16:39

... Usability testing Implementation Testing acceptance testing System testing Security testing Maintainance Performance testing Documentation testing Performance Testing in Modern Development Life ... for Performance Testing General Perception about Performance Testing 12 Performance Testing: “LESS” Approach 14 Difference between the Components of LESS 18 Performance Testing ... existence of performance testing Performance Testing practice s Reviewed or Simulated (performance during requirements analysis and design) Testing conducted at early stages of S DLC Testing conducted...

Ngày tải lên: 01/06/2014, 09:54

... Performance Testing Introduction to Performance Testing Difference between Performance, Load and Stress Testing Why Performance Testing? When is it required? What should be tested? Performance ... it required? What should be tested? Performance Testing Process Performance Testing Tools Introduction to Performance Testing Performance testing is the process of determining the speed or ... transactions can be differentiated from other transactions Performance Testing Process Performance Testing Process Planning • • Determine the performance testing objectives Describe the application to test...

Ngày tải lên: 28/07/2014, 12:41

... Identify the components of performance management systems – Distinguish between performance management (PM) and performance appraisal (PA), and between job criteria and performance standards – Explain ... performance • Provide information to employees about their performance • Clarify organizational performance expectations • Identify the development steps that are needed to enhance employee performance ... Difference Between Performance Management and Performance Appraisals  Performance Management  – Processes used to identify, encourage, measure, evaluate, improve, and reward employee performance ©...

Ngày tải lên: 28/11/2014, 15:17