design analysis and testing

Ngày tải lên: 07/03/2014, 01:20

... punctured ZCZPS is introduced, and a method using optimized punctured sequence-pair and Hadamard matrix to construct such codes is given and proved In Section 4, the properties and ambiguity function ... [19] P Z Fan and M Darnell, Sequence Design for Communications Applications, Research Studies Press, John Wiley & Sons, London, UK, 1996 [20] P Z Fan and M Darnell, “On the construction and comparison ... sequences, Chu sequences, and modulatable sequences However, it should be noted that for both binary and non-binary cases, it is impossible for the sequences to have perfect ACF and CCF simultaneously...

Ngày tải lên: 21/06/2014, 17:20

... the bandwidth of m(t) is very small compared with H(t) We assume that the signal bandwidth of V (t) and H(t) (hence the bandwidth of V (t) and H(t)) is BS , and that the bandwidth of nV (t) and ... term) and a zero-mean band-limited Gaussian with the same power and frequency range is shown in Figure In the simulation, the bandwidth of bandpass filter is 40 MHz (BL = 20 MHz), the bandwidth ... results in (25), and the results are shown in Figures and In the simulation, both the SNRV and the SNRH terms are equal, and the bandwidth of the antenna is 10 MHz wider than the bandwidth of the...

Ngày tải lên: 21/06/2014, 23:20

... successful handshake In general, any handshaking-based protocol design should also consider the narrow bandwidth and low data rate characteristics; thus, a single-channel MAC design is desired, and the ... speed and low bit rate-distance product present new challenges to Medium Access Control (MAC) protocol design In this dissertation, we focus on the design, evaluation, and analysis of handshaking-based ... wireless networks and should be carefully considered in the networking protocol design First, underwater channel has a narrow and low bandwidth, that depends on both range and frequency; this...

Ngày tải lên: 09/09/2015, 18:49

... referred to the storage space and the bandwidth capacity in servers The bandwidth capacity is determined by the minimum of the I/O bandwidth and the network bandwidth The I/O bandwidth is generally determined ... the bandwidth and the space) only once for every interval and every stream, and therefore past interval-level caching algorithms clearly cannot handle the case of the variable retrieval bandwidth ... Secondly, we design strategies to handle the case of the variable retrieval bandwidth Thirdly, we design a bandwidth management strategy of caching CM data to improve the efficiency of utilizing bandwidth...

Ngày tải lên: 17/09/2015, 17:17

... present the problem formulation and the terminology, definitions and notations that are used throughout the chapter In Section 3.2, we will then present the design and analysis of our proposed strategy ... design of a load distribution strategy As done in the literature, we consider two possible cases of interest, namely identical release times and non-identical release times We design single and ... adopt in DLT and general definitions and notations used throughout this thesis In Chapter 3, we investigate the problem of scheduling multiple divisible loads in linear networks We design and conduct...

Ngày tải lên: 30/09/2015, 06:10

... processor in the near future and serve a variety of functions like processing customer requests and sending it to the server, receiving, storing and decoding video and other data, and displaying it consistently ... necessity of efficient usage of scarce resources like network bandwidth and server capacity (in terms of I/O bandwidth) demands novel and easy-to-use schemes for scheduling continuous video streams ... DESIGN, ANALYSIS, AND EXPERIMENT ON MULTIPLE SERVERS TECHNOLOGY FOR VIDEO-ON-DEMAND SERVICE IN DISTRIBUTED NETWORKS CHEN, LONG (M.Eng.&...

Ngày tải lên: 04/10/2015, 15:45

... 25 CHAPTER 3: DESIGN AND FEATURES OF T-SUNALYZER The T-Sunalyzer was designed with test and measurement building blocks which are assembled together and integrated with control and analysis software ... work during the design stage, the hardware and software design blocks and the main features of the T-Sunalyzer, debugging and troubleshooting work during the construction stage and experimental ... with the design and implementation of the T-Sunalyzer The Chapter starts with the introduction of the proposed I-V tester specifications It is followed by high level design and hardware design...

Ngày tải lên: 04/10/2015, 15:45

... longitudinal and vertical acceleration experienced by the race car at the center of gravity (CG) during skid pad event 292 2) Acceleration and Brake Test Graph 75-Longitudinal, associated lateral and ... acceleration and brake test 293 Graph 76-Longitudinal, associated lateral and vertical acceleration experienced by the front right unsprung mass of the race car during acceleration and brake test ... associated lateral and vertical acceleration experienced by the rear left unsprung mass of the race car during acceleration and brake test 295 Graph 78-Longitudinal, associated lateral and vertical...

Ngày tải lên: 12/10/2015, 17:36

... stiffness (STS) of chassis 10 with respect to variation of height of rear bulkhead 229 Appendices - Design & Analysis of Chassis – Orientation of Brace 1) Chassis 11 24.80 Weight of Chassis vs Brace Variation ... 248 Figure 173-Investigation of driver ergonomics requirement of chassis 23 249 Appendices - Design & Analysis of Chassis – Cross Section of Structural Element 1) Chassis 24 Weight of Chassis (kg)...

Ngày tải lên: 12/10/2015, 17:36

... 25 CHAPTER 3: DESIGN AND FEATURES OF T-SUNALYZER The T-Sunalyzer was designed with test and measurement building blocks which are assembled together and integrated with control and analysis software ... work during the design stage, the hardware and software design blocks and the main features of the T-Sunalyzer, debugging and troubleshooting work during the construction stage and experimental ... with the design and implementation of the T-Sunalyzer The Chapter starts with the introduction of the proposed I-V tester specifications It is followed by high level design and hardware design...

Ngày tải lên: 13/10/2015, 15:57

... used in the analysis The message in Figure 37 indicates that the analysis and design sections are different The goal is to repeat the analysis and design process until the analysis and design sections ... frame design G When the design is complete, click the Design menu > Steel Frame Design > Verify Analysis vs Design Section command A message similar to the one in Figure 40 appears Figure 40 Analysis ... Click the Design menu > Steel Frame Design > Start Design/ Check of Structure command or the Start Steel Design/ Check of Structure button, to start the steel frame design process The program designs...

Ngày tải lên: 06/09/2012, 15:56

... EFFORT AND EXPENSE HAVE GONE INTO THE DEVELOPMENT AND DOCUMENTATION OF SAP2000 THE PROGRAM HAS BEEN THOROUGHLY TESTED AND USED IN USING THE PROGRAM, HOWEVER, THE USER ACCEPTS AND UNDERSTANDS THAT ... time, but want to see the results of the pushover analysis, then you can read parts A and B, skip part C and the first five steps of part D, and then open the already created model (with the ... then run the linear static and dynamic analysis by clicking Run on the Analyze menu Next select Run Static Pushover from the Analysis menu to perform the pushover analysis The results are now...

Ngày tải lên: 06/09/2012, 15:56

... of a system is also known as System Analysis and Design process So let us now understand What exactly System Analysis and Design is.? Who is system analyst and what are his various responsibilities? ... System Analysis and Design? System development can generally be thought of having two major components: systems analysis and systems design. In System Analysis more emphasis is given to understanding ... the design of the system 2) System analysis and design: Here apart from the analysis work, Analyst is also responsible for the designing of the new system/application 3) Systems analysis, design, ...

Ngày tải lên: 27/10/2013, 23:15

... Oriented Analysis and Design Designing the Human Interface Systems Implementation and Operation myriam.lewkowicz@u Chapter Information Systems: The Big Picture Chapter Objectives Understand the ... Understand IS components: Technology, people, organizations Understand IS career opportunities Understand types of information systems Understand IS and organizational success or failure Understand ... Understand the IS in automation, organizational learning, and strategic support Understand IS for strategic organizational success Understand the need for making an IS business case Understand technological...

Ngày tải lên: 04/11/2013, 19:15

... Limited www.ariadnetraining.co.uk UML Applied - Object Oriented Analysis and Design using the UML THE CONSTRUCTION PHASE : DESIGN 64 Design - Introduction Collaboration of Objects in Real Life Collaboration ... clearly and unambiguously communicate their ideas using this, and a small collection ã2001 Ariadne Training Limited www.ariadnetraining.co.uk UML Applied - Object Oriented Analysis and Design ... to understand every aspect of the system, and if the lifecycle is short (a few ã2001 Ariadne Training Limited www.ariadnetraining.co.uk 12 UML Applied - Object Oriented Analysis and Design using...

Ngày tải lên: 10/12/2013, 14:16

... Object-Oriented Analysis and Design Understanding System Development with UML 2.0 Mike O’Docherty Object-Oriented Analysis and Design Object-Oriented Analysis and Design Understanding System Development ... Continuous Testing 13.1 Introduction 13.2 Testing Terminology 13.2.1 Black-Box Testing 13.2.2 White-Box Testing 13.3 Types of Test 13.3.1 Unit Testing 13.3.2 Integration Testing 13.3.3 Alpha Testing ... Testing 13.3.3 Alpha Testing 13.3.4 Beta Testing 13.3.5 Use Case Testing 13.3.6 Component Testing 13.3.7 Build Testing 13.3.8 Load Testing 13.3.9 Installation Testing 406 408 408 409 410 411 412 412...

Ngày tải lên: 18/12/2013, 09:10

... editions of Systems Analysis and Design have been so well received by instructors and students Systems Analysis and Design, Seventh Edition continues with the innovation, quality, and reliability ... and improve efficiency The Role of Systems Analysis and Design FIGURE 1-3 Internet World Stats is a firm that provides Internet usage figures and online population data Systems analysis and design ... design; systems implementation; and systems operation, support, and security Planning Analysis Design Testing Prototypes FIGURE 1-27 In this model, planning, analysis, and design tasks interact continuously...

Ngày tải lên: 19/12/2013, 21:50

... sensitivity-function is made arbitrarily small 1.8 CONTROL SYSTEM ANALYSIS AND DESIGN OBJECTIVES Control systems engineering consists of analysis and design of control systems configurations Control systems ... Arnold, 1990 D’Azzo, J.J., and Houpis, C.H., Linear Control System Analysis and Design: Conventional and Modern, 4th ed., McGraw Hill, New York, NY, 1995 Dorf, R.C., and Bishop, R.H., Modern Control ... constructs and loops in MATLAB, how to use subprograms and functions, how to use comments (%) for explaining the programs and tabs for easy readability, and how to print and plot graphics both two and...

Ngày tải lên: 01/01/2014, 18:43

... reverse-path as mandatory argument and a parameter list as optional argument This command tells the SMTP receiver that a new e-mail transaction is starting and that it has to reset its state tables and buffers, ... technological anti-spam measures and their advantages and disadvantages (1) Overview of technological anti-spam measures and their advantages and disadvantages (2) ... immediately for due processing and remittance of your prize money to a designated account of your choice: NOTE: For easy reference and identification, find below your Reference and Batch numbers Remember...

Ngày tải lên: 16/01/2014, 21:20