... Intermediate Routing v 3.0 - Lab 6.2.8 Copyright 2003, Cisco Systems, Inc.
Lab 6.2.8 Password Recovery Procedure on a Catalyst2900Series Switches
Objective
ã Create and verify a basic ...
diagnostics console is displayed.
The following logon screen will appear:
Cisco Systems Diagnostic Console
Copyright(c) Cisco Systems, Inc. 1999
All rights reserved.
Ethernet Address: 00-E0-1E-7E-B4-40 ... above port 1x goes off or when the
diagnostic console is displayed.
Cisco Systems Diagnostic Console
Copyright(c) Cisco Systems, Inc. 1999
All rights reserved.
Ethernet Address: 00-E0-1E-7E-B4-40...
... Copyright 2003, Cisco Systems, Inc.
4. Release the Mode button one or two seconds after the LED above port 1x goes off.
Cisco Systems Diagnostic Console
Copyright(c) Cisco Systems, Inc. 1999 ... Intermediate Routing v 3.0 - Lab 6.2.8 Copyright 2003, Cisco Systems, Inc.
Lab 6.2.8 Password Recovery Procedure on a Catalyst2900Series Switches
Objective
ã Create and verify a basic ... port 1x
goes off.
You will see the following logon screen:
CiscoSystems Diagnostic Console
Copyright(c) Cisco Systems, Inc. 1999
All rights reserved.
Ethernet Address: 00-E0-1E-7E-B4-40...
... 3.3.4.2: Catalyst2900 Password Recovery
ALSwitch
290 0XL
10.1.1.251/24
Console Cable
Workstation
10.1.1.10/24
Native
VLAN1
Objective:
Regain control of a CiscoCatalyst2900 Ethernet ... you are connected to the console port and power off your Catalyst2900 switch.
Hold down the “MODE” button on the front of the Catalyst2900 switch at the same time that
you power on the switch. ... 10.1.1.10/24
2. Attempt to telnet into the Catalyst switch. You will not be able to get in because you do not
know the passwords.
The Catalyst2900series of switches deals with password recovery...
... Lab 3.3.7.2: Catalyst2900 TFTP Configuration Files
ALSwitch
290 0XL
10.1.1.251/24
Console Cable
Workstation
10.1.1.10/24
TFTP Server
Native
VLAN1
... just taken a job at a company that uses Catalyst2900 Ethernet switches in their IDFs.
You want to save a copy of the configuration file from your Catalyst2900 switch to a TFTP server
for safekeeping. ... safekeeping.
Lab Tasks:
1. First, configure your 2900 switch to the diagram above. You can skip this step if you already
have the Lab 3.2.3 (2900 initial setup) configured.
Switch>enable...
... 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003, Cisco Systems, Inc.
Lab 7.2.6 Spanning Tree Recalculation
Objective
ã Create a basic switch ... 2 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003, Cisco Systems, Inc.
Step 4 Look at the show interface information
a. On both switches, type the ... 4 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7.2.6 Copyright 2003, Cisco Systems, Inc.
c. What changes have taken place in the command output?
On Switch_A?
____________________________________________________________
...
...
ALSwitch#show version
Cisco Internetwork Operating System Software
IOS (tm) C290 0XL Software (C290 0XL- C3H2S-M), Version 12.0(5)XU,
RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc. ... configuration on this switch.
IOS (tm) C290 0XL Software (C290 0XL- C3H2S-M), Version 12.0(5)XU,
RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Mon 03-Apr-00 16:37 ... program is C290 0XL boot loader
ALSwitch uptime is 16 minutes
System returned to ROM by power-on
System image file is "flash:c290 0XL- c3h2s-mz-120.5-XU.bin"
cisco WS-C2924 -XL (PowerPC403GA)...