b dynamic systems with random perturbations

... , ε μt M xt(i) i=1 =1 REFERENCES [1] J M´guez, M F Bugallo, and P M Djuri´ , “A new class of parı c ticle filters for random dynamic systems with unknown statistics,” EURASIP Journal on Applied ... in 1990 From 1981 to 1986 he was Research Associate with the Institute of Nuclear Sciences, Vinca, Belgrade Since 1990 he has been with Stony Brook University, where he is Professor a in the Department ... different disciplines including communications and biology Petar M Djuri´ received his B. S and M.S c degrees in electrical engineering from the University of Belgrade, in 1981 and 1986, respectively,...

Ngày tải lên: 22/06/2014, 23:20

... ∈ M as φ τ , τ ∈ a, b and φa ,b τ 0, τ ∈ 0, a ∪ b, ∞ ⊂ R0 ; for all a, b > a ∈ a, b ⊆ φa ,b τ φa ,b ∞ ≤ φ ∞ R0 , for all t ∈ R0 , for all φ ∈ M and note that φ a ,b : supτ∈ a ,b φ τ and φt ∈ M is ... theory have been investigated in 35, 36 Fixed point theory has also been employed successfully in stability problems of dynamic systems such as time-delay and continuous-time/digital hybrid systems ... stability properties for arbitrary admissible initial conditions or admissible bounded controls are lost in general if α ≥ However, it turns out that the boundedness of the solutions can be obtained...

Ngày tải lên: 21/06/2014, 05:20

... averaging the above conditional probability of error over the probability density function of γz Hence, for equally likely BPSK symbols, the average probability of bit error can be obtained as follows: ... error can be obtained by averaging the above conditional probability of error over the probability density function of γz If the transmitted symbols are equally likely, the probability of bit error ... where d is a binomial random variable with equal probability of success and failure Since each interferer’s component Iik = Ak bik ρk,1 is independent with zero mean, the random variable i Ui is...

Ngày tải lên: 22/06/2014, 19:20

... Introduction and probability theory Under the framework of probabilistic robust control, the notion of probabilistic robustness was proposed [34, 35, 36] By combining robust control with probabilistic information, ... the subsets of Ω P probability measure (Ω, F, P ) a probability space E[·] ensemble average or expectation with respect to a probability distribution B( α, β) Beta function with parameters α and ... Distribution 3.6 Special Case: Beta Distribution 3.6.1 Beta Distribution and Jacobi Polynomials 3.6.2 Asymptotic Stability of Systems with Beta Distribution...

Ngày tải lên: 10/09/2015, 09:25

... set-valued dynamic systems in metric spaces have been established by Edelstein 24 , Ding and Nadler Jr 29 , and Nadler Jr 30 Periodic point theorem for special single´ c valued dynamic systems ... topology T P having as a subbase the family B P {B x, εα : x ∈ X, εα > 0, α ∈ A} of all balls B x, εα {y ∈ X : pα x, y < εα }, x ∈ X, εα > 0, α ∈ A is called the topology induced by P on X iii Dugundji ... dissipative dynamic systems of the types 1.4 – 1.6 when entropy ω is not necessarily lower semicontinuous have been conducted by a number of authors in different settings; for example, see Aubin and...

Ngày tải lên: 21/06/2014, 11:20

... le if r" A /li < and u nstable in th e op p o site case 2) b^ d eterm in ed by B = Z T ( ~ m B l) - > °- (L22) In this case the v ib ration of the string is described by the eq u a tio n y ( i ... Jo Y*(x)dx DYNAMIC ABSORBERS FOR SYSTEMS WITH DISTRIBUTED PARAMETERS T h e triv ia l solu tion h\ > CLi 11 = of (2.18) is sta b le if h\ < or if th e friction A is sufficiently big W h e n t ... io n s : _ dx2 at = 0, X —t (3.2) at X = 0, X= t 13 DYNAMIC ABSORBERS FOR SYSTEMS WITH DISTRIBUTED PARAMETERS w e have for t h e w ea k absorber (c,Ao are small): I dy ( dy\3 1ã í _ d 2z dA z...

Ngày tải lên: 08/04/2015, 15:28

... The results obtained are qualitatively the same as with discrete systems 11], but a system 10, with multi -dynamic absorbers is more effective than that having only one absorber, because the resulting ... A M I C A B S O R D E R S E F F E C T O N A B E A M The results obtained in the previous sections for the string can be used for a beam carrying N absorbers whose motion is described by the equations ... lf-e x c ite d v ib r a t io n s o f th e s t r in g w ill be in v e s tig a te d T w o ty p e s oi d y n a m ic a b s o rb e rs w ill be c o n s id e re d : S tro n g a b s o r b e rs w h e n...

Ngày tải lên: 08/04/2015, 15:29

... rationing problems with multiple products (with some substitutions) or multiple echelons, but without holding cost While here we focus on the inventory rationing problems at one place with one product ... at the beginning of period m before ordering (i.e., at the end of period m - ) and Bm = {b1 , , bK } denote the vector of backorders of each demand class at the beginning of period m before ordering, ... and backordering Chapter studies dynamic rationing for systems with general demand processes and backordering Chapter analyzes dynamic rationing for systems with Poisson demand and lost sales...

Ngày tải lên: 11/09/2015, 09:00

... parameter D n D However, it will be seen later that this set BIBO STABILITY OF THE BOUC–WEN MODEL 19 Table 2.1 Classification of the BIBO-stable Bouc–Wen models Case Upper bound on z t + >0 −

Ngày tải lên: 12/12/2013, 22:41

Ngày tải lên: 14/12/2013, 12:15

... wiring symbols Objectives: • Be able to understand and design basic input and output wiring • Be able to produce industrial wiring diagrams 3.1 INTRODUCTION Many PLC configurations are available, ... The input number on the card is shown below the contact as 01 and 03 Many beginners become confused about where connections are needed in the circuit above The key word to remember is circuit, ... large (up to 18” by 30” by 10”) and can hold multiple cards When necessary, multiple racks can be connected together These tend to be the highest cost, but also the most flexible and easy to maintain...

Ngày tải lên: 22/12/2013, 20:16

... through either branch of the circuit, through the contacts labelled A or B The input B will only be on when the output B is on If B is off, and A is energized, then B will turn on If B turns on then ... 5.12 4.3.8 Fluid Flow SUMMARY PRACTICE PROBLEMS PRACTICE PROBLEM SOLUTIONS ASSIGNMENT PROBLEMS INTRODUCTION BOOLEAN ALGEBRA LOGIC DESIGN 6.3.1 Boolean Algebra Techniques COMMON LOGIC FORMS 6.4.1 ... the input B will turn on, and keep output B on even if input A goes off After B is turned on the output B will not turn off plc wiring - 2.6 A B B Note: When A is pushed, the output B will turn...

Ngày tải lên: 22/12/2013, 20:16

... through either branch of the circuit, through the contacts labelled A or B The input B will only be on when the output B is on If B is off, and A is energized, then B will turn on If B turns on then ... 5.12 4.3.8 Fluid Flow SUMMARY PRACTICE PROBLEMS PRACTICE PROBLEM SOLUTIONS ASSIGNMENT PROBLEMS INTRODUCTION BOOLEAN ALGEBRA LOGIC DESIGN 6.3.1 Boolean Algebra Techniques COMMON LOGIC FORMS 6.4.1 ... the input B will turn on, and keep output B on even if input A goes off After B is turned on the output B will not turn off plc wiring - 2.6 A B B Note: When A is pushed, the output B will turn...

Ngày tải lên: 22/12/2013, 21:18

... Rf ×g = B( pe ) + B( pf ) × Rg + B( pg ) × Rf + Rf × Rg • B( p) indicates an interval bound on the function p • Reciprocal operation and intrinsic functions can also be defined • It is possible to ... not satisfying c(x) ≤ • For some i = 1, · · · , m bi b2 − i + Si ≤ B( Tc ) = B( pc ) + Rc = Xi − xi0 + 2ai 4ai bi b2 i and Vi = − Si =⇒ Ui ≤ Vi , with Ui = Xi − xi0 + 2ai 4ai  ∅ if > and Vi <  ... 13 10 Branch and Reduce Algorithm Summary Beginning with initial parameter interval Θ (0) ˆ • Establish φ, the upper bound on global minimum using p2 local minimizations • Iterate: for subinterval...

Ngày tải lên: 12/01/2014, 22:03

... Rf ×g = B( pe ) + B( pf ) × Rg + B( pg ) × Rf + Rf × Rg • B( p) indicates an interval bound on the function p • Reciprocal operation and intrinsic functions can also be defined • It is possible to ... not satisfying c(x) ≤ • For some i = 1, · · · , m bi b2 − i + Si ≤ B( Tc ) = B( pc ) + Rc = Xi − xi0 + 2ai 4ai bi b2 i and Vi = − Si =⇒ Ui ≤ Vi , with Ui = Xi − xi0 + 2ai 4ai  ∅ if > and Vi <  ... 13 10 Branch and Reduce Algorithm Summary Beginning with initial parameter interval Θ (0) ˆ • Establish φ, the upper bound on global minimum using p2 local minimizations • Iterate: for subinterval...

Ngày tải lên: 12/01/2014, 22:16

... mysql_select_db("learndb",$db); $result = mysql_query($sql,$db); echo ""; echo" Full Name< /B> Nick Name< /B> Options< /B> "; Create dynamic sites with PHP & ... database "learndb" located by the pointer variable $db But we want information from the database, so we query the database with the lines "$result = mysql_query("SELECT * FROM personnel",$db);" The ... additions should be obvious

Ngày tải lên: 17/01/2014, 08:20

... date You should follow this practice with the exercises on all chapters of this book Signals and Systems with MATLAB Applications, Second Edition Orchard Publications 1-21 Chapter Elementary Signals ... Elementary Signals NOTES 1-24 Signals and Systems with MATLAB Applications, Second Edition Orchard Publications Chapter The Laplace Transformation his chapter begins with an introduction to the Laplace ... represented by multiplication of the time variable t by a positive scaling factor a Thus, the function f ( t ) after scaling the time axis, becomes f ( at ) Scaling Property Let a be an arbitrary...

Ngày tải lên: 19/01/2014, 18:20

... Appendix B Review of Complex Numbers Definition of a Complex Number B- 1 Addition and Subtraction of Complex Numbers B- 2 Multiplication of Complex Numbers B- 3 Division ... $39.95 U.S.A Signals and Systems with MATLAB® Applications Second Edition Steven T Karris Orchard Publications www.orchardpublications.com Signals and Systems with MATLAB Applications, Second Edition ... Signals and Systems with MATLAB® Applications Second Edition Steven T Karris Students and working professionals will find Signals and Systems with MATLAB® Applications, Second Edition, to be a concise...

Ngày tải lên: 19/01/2014, 18:20

... wiring symbols Objectives: • Be able to understand and design basic input and output wiring • Be able to produce industrial wiring diagrams 3.1 INTRODUCTION Many PLC configurations are available, ... The input number on the card is shown below the contact as 01 and 03 Many beginners become confused about where connections are needed in the circuit above The key word to remember is circuit, ... large (up to 18” by 30” by 10”) and can hold multiple cards When necessary, multiple racks can be connected together These tend to be the highest cost, but also the most flexible and easy to maintain...

Ngày tải lên: 19/01/2014, 20:20

... mysql_select_db("learndb",$db); $result = mysql_query($sql,$db); echo ""; echo" Full Name< /B> Nick Name< /B> Options< /B> "; Create dynamic sites with PHP & ... database "learndb" located by the pointer variable $db But we want information from the database, so we query the database with the lines "$result = mysql_query("SELECT * FROM personnel",$db);" The ... additions should be obvious

Ngày tải lên: 20/01/2014, 06:20