Cross cutting test according to DIN 53151 resp. ISO 2409

TIGER DRYLAC Quality Control Test instruction Cross cutting test according to DIN 53151 resp. ISO 2409 PA 01 1. Purpose / Target: The cross cutting test serves multilevel painting on its background one on the other for the evaluation of adhering in and as well as adhering the layers. 2. Description of the procedure: 2.1) Testing sets Cut devices : Cutting device and folding ruler according to DIN 53151 Multi-cut device B according to DIN 53151 2.2) Execution The coated sample boards are long stored at least 12 hours. For check the boards will provide with a cut tape going through up to the background with 6 cuts and in the right angle in addition with a further cut tape with 6 cuts. The cuts are to be drawn constantly and jerkily. 2.3) Analysis The characteristic value is determined by regarding the cross cuts and their comparing with the pictures and descriptions according to the analysis table (taken over from DIN 53151). If the given characteristic value is not fulfilled, then is 2. To execute and evaluate check of the same sheet metal. 3. Link documents: DIN 53151 ISO 2409 Analysis table Approved by: Ing. M. Mathe Issue date April 95 Update status 01 Folder – Nr. HQ 03 - 18 pagte 1/1 . Quality Control Test instruction Cross cutting test according to DIN 53151 resp. ISO 2409 PA 01 1. Purpose / Target: The cross cutting test serves multilevel. procedure: 2.1) Testing sets Cut devices : Cutting device and folding ruler according to DIN 53151 Multi-cut device B according to DIN 53151 2.2) Execution