Thông tin tài liệu
Despicable Minion Minion army anyone? I just had to I've not seen the movie yet, but the little guys are just so charming This is only one of them of course, but at the end of the pattern, are some suggestions for making all different personalities of minions to create your very own Minion Army LOL As always, if you have any questions or find a problem with the pattern, just post here or email me, and I'll get back to you as soon as I can! Minion Materials: WW yarn in yellow, blue and small amounts of black, white and gray G Hook Fiberfill Small amounts of felt in black and medium/light blue Yarn Needle Sewing needle and matching sewing threads NOTES: Gauge isn't terribly important to this project as long as your hook, yarn and individual tension result in a stitch that's tight enough that the stuffing won't come through Numbers in ( ) at the end of each round or row indicate the total number of stitches in that round or row Read the 'Fun Stuff' at the end of the pattern for suggestions on making many minions of different shapes and personalities HEAD/BODY: Rnd 1: sc in magic ring (7) Rnd 2: sc in each sc around (14) Rnd 3: sc in next sc, sc in next sc around (21) Rnd 4: sc in next sc, sc in next sc around (28) Rnd 5: sc in next sc, sc in next sc around (35) Rnd 6-31: sc in each sc around (35) Begin stuffing at this point Stuff moderately firmly while shaping Continue to stuff as you progress Rnd 32: sc in next sc, dec over next sc around (28) Rnd 33: sc in next sc, dec over next sc around (21) Rnd 34: sc in next sc, dec over next sc around (14) Rnd 35: dec over next sc around (7) F/O Add any stuffing needed to finish out the shaping Weave tail through final round and tug gently to close up Secure ends, weave in OVERALLS: Using blue Rnd 1-5: same as for the Head/Body Rnd 6-10: sc in each sc around (35) Do not fasten off at end of round 10 (now working in rows) Row 1: Sc next 10 sc, ch and turn (10) Row 2-6: sc in each sc across, ch and turn (10) F/O Weave in ends With the newly made panel facing you, from the left side of this panel, count sc around (on row 10 of base of overalls) and attach yarn to the next sc Row 1: Sc in same sc as joining Sc in next 10 sc, ch and turn (11) Row 2-6: sc in each sc across, ch1 and turn (11) F/O Weave in ends For the straps of the overalls, Ch 9, sc in second chain from hook and each remaining ch across, (8) F/O Weave in ends Fit the overalls over the bottom of the body section Attach straps to the upper corners of each of the panels as shown (Don't sew the overalls to the body just yet) ARMS/HANDS: Beginning at the hand using black yarn: Rnd 1: sc in magic ring (4) Rnd 2: sc in next sc, sc in next sc, sc in next sc, sc in next sc (6) Rnd 3: sc in each of next sc, ch 3, sc in 2nd ch from hook and next ch, sc in each of remaining sc of round (6 sc and 'thumb') Rnd 4: sc in each sc around (hold thumb down to to the front as you sc behind it) (6) Rnd 5: working in front loops only, sc in each sc around (12) F/O and weave in ends Attach yellow to any free loop from round Rnd 1: sc in same free loop as joining Sc in each of next free loops around (6) Rnd 2-12: sc in each sc around (6) As you work, stuff the arm lightly to shape but don't overstuff Continue to stuff as you progress It's much easier to this as you go than to try to stuff it after it's done, since the arms are so thin Flatten the last row of the arm so that the thumb of the hand will be facing towards the body and pin to body as shown FEET (make 2): (using black) Rnd 1: sc in magic ring (6) Rnd 2: sc in next sc, sc in next sc around (9) Rnd 3-5: sc in each sc around (9) Rnd 6: sc in next sc, dec over next sc around (6) F/O Stuff foot lightly You just want to give the some some substance and shape, without overstuffing, as you'll want to very slightly flatten the foot to more resemble shoes PANT LEGS (make 2): (using blue) Chain 11, join to form a ring Rnd 1-3: sc in each sc around (11) F/O Sew the bottom of the pant leg to the top of the foot/shoe as shown Stuff the 'leg' moderately firm while shaping Pin the upper portion of the leg to the bottom of the overalls as shown EYES/GOGGLES: Eye ball (make 2): Using white: Rnd 1: 15 sc in magic ring, pull your 'draw string' very tightly to close up the ring (15) Rnd 2: sc in next sc, dec over next sc around (10) F/O Tuck the loose yarn ends into the dome of the eyeball (add a tiny bit of stuffing if you want) Goggle Rims (make 2): Using gray: Rnd 1: sc in magic ring (8) Rnd 2: sc in each sc around (16) Rnd 3: working in back loops only, sc in each sc around (16) Rnd 4: sc in each sc around (16) F/O Tuck the eyeball into the 'goggle' as shown Once you're happy with the look, secure the eyball inside the goggle (I used a sewing needle and some gray sewing thread to this, so as not to add any bulk to the outside of the goggle rims) Sew the two 'eyes' to each other in a figure shape as shown (a few stitches with that gray sewing thread is good for that as well, as it won't add any unwanted bulk to the goggles) GOGGLE STRAP: Using black: Row 1: chain 28 (check this to make sure it's the right length to go around the head and attach to each side of the 'goggles', add or remove chains as needed) DC in each chain across (again, check this for size before F/O, and adjust as needed) F/O and weave in ends Sew the strap to either side of the goggle rims as shown ASSEMBLY: Fit the overalls over the body as shown and pin in place Pin arms as shown (this minion's arms reach about to the bottoms of the feet) Once you're pleased with the positioning of the arms (thumbs to inside of each hand), sew in place Sew overalls in place Attach legs to bottom of overalls, sew securely in place Place goggles over the top of the head and position as desired, once you're happy with the placement of the goggles/eyes, sew securely in place Cut two small circles of black felt and either sew or glue in place on the eyeballs For mouth: On this minion, I just used some of the yellow yarn, and whipstitched around one row of sc for a few scs to create the 'pouty' lower lip and then took a large stitch across the top and slightly below the 'lip' to create the shape Tug very gently on this large stitch to create the look of the mouth Hair: I cut several strands of black, and tied in the middle with another strand I folded the 'bundle' in half to create the 'shock' of hair and sewed this in place to the middle of the top of the head The insignia on the overalls is made by cutting a circle of black, and a square of the blue … the blue square is placed in the center of the black circle and glued in place then a smaller circle is glued to the center of the blue square and placed on the overalls in the center front as shown THE FUN STUFF: This is just a base design for one minion By removing rows of the body section (between rnd 6-31) you can create a shorter body Create different hair designs, make the eyes/goggles a little bigger, or just one very large eye/goggle Create different mouth shapes with felt Make many minions of different sizes, looks, and hair styles, you can have your own minion army! Make them so that no two are alike, or make them all the same it's your army! :D The Minions are copyright of the artists/makers of the Movie 'Despicable Me', but this crochet pattern is copyright of Linda Potts (July 2010) DO NOT reprint this pattern, or post it on any other website You may make a copy of this pattern for your own personal use, but not include it in any collections, website, or cds You are welcome to link to this pattern and if you post your own pictures of the minions you create, please credit accordingly and include a link to this original pattern ... Make many minions of different sizes, looks, and hair styles, you can have your own minion army! Make them so that no two are alike, or make them all the same it's your army! :D The Minions are... that round or row Read the 'Fun Stuff' at the end of the pattern for suggestions on making many minions of different shapes and personalities HEAD/BODY: Rnd 1: sc in magic ring (7) Rnd 2: sc in... shown ASSEMBLY: Fit the overalls over the body as shown and pin in place Pin arms as shown (this minion' s arms reach about to the bottoms of the feet) Once you're pleased with the positioning of
Ngày đăng: 09/02/2020, 21:24
Xem thêm:
