Presentations report design and manufacture of plastic injection molding injection molds 2 plate was compiled with the following contents: Structure, operation principles and application. To master the content knowledge scratch paper invite you to consult the documentation.
REPORT DESIGN AND MANUFACTURING PLASTIC INJECTION MOLD 2 plate injection 2 plate injection mold A cavity Many cavity Having grafted core Having core inside the core graft transplantation Consists of 2 parts: mold prior (negative mold) and patterned (positive mold) Cấu tạo II. PRINCIPLE OF OPERATION Tables machine motion from left to right to bring action part mold Shaft guidance and navigation for the second silver mold half and static mold II. PRINCIPLE OF OPERATION When the second half against the same mold, the plastic molding machine will pump into the cavity, depending on the magnitude of the plastic products will be filled within 18 to 60 seconds The cooling system will operate II. PRINCIPLE OF OPERATION The process of pushing the plate compression springs push the mold, pushing shaft of the machine will push two plates push, pulls in the II. PRINCIPLE OF OPERATION This process is performed on an ongoing basis III. APPLICATION •These products have fewer vents Is the civil, personal items, household utensils Products with high accurately and high technical requirements Based on the public to identify the mold 2 sheets? Mold Based on only 2 plates, 1 move 1 stand still, just open one time was able to get products and plastic channels (Roll longer sticky resin on the product) The layout channel (channel 1 on the same plane) • The structure of the mold • Products after withdrawing mold characteristics to identify a second mold plate? ... Products with high accurately and high technical requirements Based on the public to identify the mold 2 sheets? Mold Based on only 2 plates, 1 move 1 stand still, just open one time was able to get products and plastic ... When the second half against the same mold, the plastic molding machine will pump into the cavity, depending on the magnitude of the plastic products will be filled within 18 to 60 seconds The cooling system will operate II. PRINCIPLE OF OPERATION.. .2 plate injection mold A cavity Many cavity Having grafted core Having core inside the core graft transplantation Consists of 2 parts: mold prior (negative mold) and patterned (positive