Ô tô Camry 3.5Q - Phần 1 Phần 1 (Tài liệu bằng tiếng anh) gồm: - Kết cấu thân xe - Kết cấu phần điện - CHASSIS - Kích thước xe - Động cơ xe
BODY ELECTRICAL– MEMORY SYSTEMBE-252MEMORY SYSTEMJDESCRIPTIONDThe settings of the memory system vary depending on the destinations and grades. For details, see theequipment list in Model Outline (see page MO-42).D The memory system can store 2 positions for the driver seat, outside rear view mirror, and power tilt andpower telescopic steering column*1 respectively.D The seat ECU (driver) stores seat slide, front vertical, rear vertical and reclining positions in its memory.The seat ECU is built in to the power seat switch.D The mirror ECU stores the outside rear view mirror position in its memory.D The tilt & telescopic ECU*2 stores the tilt & telescopic position in its memory.D The seat ECU (driver) outputs a reproduction signal to each ECU.D The memory and recall conditions of this system are as follows.FunctionConditionMemoryStores the positions when all conditions below have been met and button 1 or 2 is pushedwhile the “SET” button is pushed.D Power source is “IG-ON”.D Shift position is “P”.When the memory setting is completed, the buzzer will sound for 0.5 seconds.RecallIf button 1 or 2 is pressed when all conditions have been met, the system operates to adjustthe positions.D Power source is “IG-ON”.D Shift position is “P”.If button 1 or 2 is pressed when all conditions have been met and within 30 seconds, thesystem operates to adjust the positions.D Power source is “IG-OFF”.D Driver door is opened.*1: Except G grade models with 2AZ-FE engines for Thailand*2: With power tilt and power telescopic steering column BEBODY ELECTRICAL – MEMORY SYSTEM02KBE65TEEngine SwitchMirror ControlSwitchDriver DoorCourtesy SwitchMain BodyECUCAN(CAN No.1 Bus)EngineECUNeutral StartSwitchPower SeatSwitchSeat MotorsSeat ECU(Driver)(Built-inPower SeatSwitch)CAN(MS Bus)Tilt &TelescopicECU*Power TiltMotors*TelescopicMotor*Tilt & TelescopicManual Switch*Mirror MotorPosition SensorMemorySwitchesSet SwitchesMirror ECUBE-253" System Diagram A*:With power tilt and power telescopic steering column . button 1 or 2 is pressed when all conditions have been met and within 30 seconds, thesystem operates to adjust the positions.D Power source is “IG-OFF”.D. conditions below have been met and button 1 or 2 is pushedwhile the “SET” button is pushed.D Power source is “IG-ON”.D Shift position is “P”.When the memory