;******************************************************************************* ; MSP430G2x31 Demo - ADC10, Sample A11, Lo_Batt, Set P1.0 if AVcc < 2.3V ; ; Description: A single sample is made on A11 (AVcc/2) with reference to ; internal 1.5V Vref Software sets ADC10SC to start sample and conversion ; - ADC10SC automatically cleared at EOC ADC10 internal oscillator times ; sample (16x) and conversion ADC10BUSY flag is polled for EOC If A11 ; (AVcc/2) < 0311h (0.65V) indicating AVcc is less 2.3V, P1.0 set indicating ; a lo_Batt condition, else reset ; ; MSP430G2x31 ; -; /|\| XIN|; | | | ; |RST XOUT|; | | ; |A11 (AVcc/2) P1.0 | > LED ; ; D Dang ; Texas Instruments Inc ; October 2010 ; Built with Code Composer Essentials Version: 4.2.0 ;******************************************************************************* cdecls C,LIST, "msp430g2231.h" ; -.text ; Progam Start ; -RESET mov.w #0280h,SP ; Initialize stackpointer StopWDT mov.w #WDTPW+WDTHOLD,&WDTCTL ; Stop WDT SetupADC10 mov.w #INCH_11,&ADC10CTL1 ; AVcc/2 mov.w #SREF_1+ADC10SHT_2+REFON+ADC10ON,&ADC10CTL0; mov.w #30,&TACCR0 ; Delay to allow Ref to settle bis.w #CCIE,&TACCTL0 ; Compare-mode interrupt mov.w #TACLR+MC_1+TASSEL_2,&TACTL; up mode, SMCLK bis.w #LPM0+GIE,SR ; Enter LPM0, enable interrupts bic.w #CCIE,&TACCTL0 ; Disable timer interrupt dint ; Disable Interrupts SetupP1 bis.b #001h,&P1DIR ; P1.0 output ; Mainloop bis.w #ENC+ADC10SC,&ADC10CTL0 ; Start sampling/conversion L1 bit.w #ADC10BUSY,&ADC10CTL1 ; ADC10BUSY? jnz L1 ; cmp.w #0311h,&ADC10MEM ; ADC10MEM = A11 (AVcc/2) > 0.65V? jlo lo_Batt ; bic.b #01h,&P1OUT ; P1.0 = jmp Mainloop ; Again lo_Batt bis.b #01h,&P1OUT ; P1.0 = jmp Mainloop ; Again ; ; TA0_ISR; ISR for TACCR0 ; clr.w &TACTL ; Clear Timer_A control registers bic.w #LPM0,0(SP) ; Exit LPM0 on reti reti ; ; -; Interrupt Vectors ; -.sect ".reset" ; MSP430 RESET Vector short RESET ; sect ".int09" ; Timer_A0 Vector short TA0_ISR ; .end