//****************************************************************************** // MSP430G2x32/G2x52 Demo - ADC10, DTC Sample A10 32x, 1.5V, Repeat Single, DCO // // Description: Use DTC to sample A10 32 times with reference to internal 1.5v // Vref Software writes to ADC10SC to trigger sample burst In Mainloop MSP430 // waits in LPM0 to save power until ADC10 conversion complete, ADC10_ISR(DTC) // will force exit from any LPMx in Mainloop on reti (ADC10OSC/4)/64 // determines sample time which needs to be greater than 30us for temperature // sensor DTC transfers conversion code to RAM 200h - 240h P1.0 set at start // of conversion burst, reset oncompletion Temperature sensor offset and slope // will vary from device to device per datasheet tolerance // // MSP430G2x32/G2x52 // // /|\| XIN|// | | | // |RST XOUT|// | | // |A10 P1.0| >LED // // D Dang // Texas Instruments Inc // December 2010 // Built with CCS Version 4.2.0 and IAR Embedded Workbench Version: 5.10 //****************************************************************************** #include "msp430g2452.h" void main(void) { WDTCTL = WDTPW + WDTHOLD; // Stop WDT ADC10CTL1 = INCH_10 + ADC10DIV_3 + CONSEQ_2; ADC10CTL0 = SREF_1 + ADC10SHT_3 + MSC + REFON + ADC10ON + ADC10IE; enable_interrupt(); // Enable interrupts TACCR0 = 30; // Delay to allow Ref to settle TACCTL0 |= CCIE; // Compare-mode interrupt TACTL = TASSEL_2 + MC_1; // TACLK = SMCLK, Up mode LPM0; // Wait for delay TACCTL0 &= ~CCIE; // Disable timer Interrupt disable_interrupt(); ADC10DTC1 = 0x20; // 32 conversions P1DIR |= 0x01; // Set P1.0 output for (;;) { ADC10CTL0 &= ~ENC; while (ADC10CTL1 & BUSY); ADC10SA = 0x200; P1OUT |= 0x01; ADC10CTL0 |= ENC + ADC10SC; bis_SR_register(CPUOFF + GIE); P1OUT &= ~0x01; } // // // // // // // Wait if ADC10 core is active Data buffer start P1.0 = Sampling and conversion start LPM0, ADC10_ISR will force exit P1.0 = } // ADC10 interrupt service routine #pragma vector=ADC10_VECTOR interrupt void ADC10_ISR(void) { bic_SR_register_on_exit(CPUOFF); } #pragma vector=TIMER0_A0_VECTOR interrupt void ta0_isr(void) { // Clear CPUOFF bit from 0(SR) TACTL = 0; LPM0_EXIT; } // Exit LPM0 on return