//****************************************************************************** // MSP430G2x31 Demo - ADC10, DTC Sample A1 32x, AVcc, Repeat Single, DCO // // Description: Use DTC to sample A1 32 times with reference to AVcc Software // writes to ADC10SC to trigger sample burst In Mainloop MSP430 waits in LPM0 // to save power until ADC10 conversion burst complete, ADC10_ISR(DTC) will // force exit from any LPMx in Mainloop on reti ADC10 internal oscillator // times sample period (16x) and conversion (13x) DTC transfers conversion // code to RAM 200h - 240h P1.0 set at start of conversion burst, reset on // completion // // MSP430G2x31 // // /|\| XIN|// | | | // |RST XOUT|// | | // > -|P1.1/A1 P1.0| >LED // // D Dang // Texas Instruments Inc // October 2010 // Built with CCS Version 4.2.0 and IAR Embedded Workbench Version: 5.10 //****************************************************************************** #include "msp430g2231.h" void main(void) { WDTCTL = WDTPW + WDTHOLD; // Stop WDT ADC10CTL1 = CONSEQ_2 + INCH_1; // Repeat single channel, A1 ADC10CTL0 = ADC10SHT_2 + MSC + ADC10ON + ADC10IE; // ADC10ON, interrupt enabl ADC10DTC1 = 0x20; // 32 conversions ADC10AE0 |= 0x02; // P1.1 ADC option select P1DIR |= 0x01; // Set P1.0 to output direction } for (;;) { ADC10CTL0 &= ~ENC; while (ADC10CTL1 & BUSY); ADC10SA = 0x200; P1OUT |= 0x01; ADC10CTL0 |= ENC + ADC10SC; bis_SR_register(CPUOFF + GIE); P1OUT &= ~0x01; } // ADC10 interrupt service routine #pragma vector=ADC10_VECTOR interrupt void ADC10_ISR(void) { bic_SR_register_on_exit(CPUOFF); } // // // // // // Wait if ADC10 core is active Data buffer start Set P1.0 LED on Sampling and conversion start LPM0, ADC10_ISR will force exit Clear P1.0 LED off // Clear CPUOFF bit from 0(SR)